What is the fuel tank capacity of the Roewe 550?

What causes the noise when shifting to P gear before the car comes to a complete stop?

Shifting to P gear before the car comes to a complete stop causes noise because the locking mechanism interferes with the gears. When the car is not fully stopped, do not shift into P gear, as it may damage the locking mechanism of the P gear. Automatic transmission cars are equipped with a P gear, which is the parking gear used when stopping and turning off the engine. After shifting into P gear, the car can remain stationary. It is essential to maintain proper usage habits in daily driving to prolong the car's lifespan. Additionally, regular maintenance of your vehicle is crucial, and it is recommended to use genuine fluids and parts during maintenance.

15

0

Share

What to Do When the Car Battery Is Dead and Won't Start?

Solutions for a dead car battery that won't start the engine: Manual transmission vehicles can be push-started or towed by another vehicle. However, it's important to note that these methods are not suitable for automatic transmission vehicles, as they may cause damage to the engine and transmission. For automatic transmission vehicles, you can try jump-starting the car using jumper cables or charging the battery with a charger. Steps for jump-starting a car: 1. You'll need a rescue vehicle. Once you have one, position the two cars facing each other and prepare two jumper cables. 2. Open the hoods of both cars and connect the positive and negative terminals of the two batteries using the jumper cables—positive to positive and negative to negative. 3. Start the rescue vehicle and let the engine idle. Then, attempt to start the dead car. If the issue is just a dead battery, the car should start quickly, and the alternator will begin charging the battery.

4

Share

Which direction to turn when loosening car tire bolts?

Car tire bolts should be turned counterclockwise to loosen. Place your left hand facing the center of the tire, grip the wrench with your right hand and lift upwards to loosen the bolt - this method applies to passenger cars. For large trucks, the tire bolt directions differ between left and right sides: left-side bolts have reverse threads (turn opposite to normal), while right-side bolts have standard threads (turn in the rolling direction of the vehicle to tighten, opposite direction to loosen). After loosening, it's essential to visit the nearest auto repair shop for professional inspection of the tires to avoid potential safety hazards caused by oversight. It's recommended that owners check the tread condition and air pressure of spare tires during every vehicle maintenance session.

9

2

Share

What car has an eagle-like logo?

An eagle-like logo belongs to Saab automobiles. Its models include the Saab 95 and Saab 93. The Saab 93 is equipped with a 2.0TS all-aluminum inline four-cylinder strong turbocharged engine, paired with a 5-speed automatic transmission. It delivers a maximum power of 155 kW and a maximum torque of 300 Nm. The vehicle dimensions are 4654mm in length, 1762mm in width, and 1492mm in height, with a wheelbase of 2675mm. In terms of safety, the Saab 93 features a MacPherson strut front suspension and a multi-link independent rear suspension. It is also equipped with the Saab car anti-theft alarm system, cruise control, hands-free telephone preparation system, electric anti-fog exterior mirrors, and functions such as memory and reverse assist.

9

1

Share

How Long Until a Vehicle is Considered Scrapped?

An automobile that has not undergone inspection for three years is considered scrapped. According to relevant regulations, a registered motor vehicle shall be mandatorily scrapped under any of the following circumstances: 1. It still fails to meet the national standards for the safety technical requirements of in-use vehicles after repair and adjustment; 2. After repair and adjustment or the adoption of control technology, the pollutants or noise emitted into the atmosphere still fail to meet the national standards for in-use vehicles; 3. It has not obtained the motor vehicle inspection compliance mark for three consecutive inspection cycles after the expiration of the inspection validity period. The owner of the scrapped vehicle shall sell the motor vehicle to a recycling and dismantling enterprise for scrapped motor vehicles, which will carry out registration, dismantling, destruction, and other processes in accordance with regulations, and submit the scrapped motor vehicle registration certificate, license plate, and driving license to the traffic management department of the public security authority for cancellation.

15

5

Share

What are the four conditions for upgrading from C1 to B2 license?

The four conditions for upgrading from C1 to B2 license are age restrictions, holding the license for at least 2 years, not having accumulated 12 penalty points, and not having been involved in major traffic accidents. Upgrading from C1 to B2 requires passing all driving tests, including Theory Test (Subject 1), Practical Driving Test (Subject 2), Road Test (Subject 3), and Safety & Civilization Driving Test (Subject 4). Age Restrictions Currently, the C1 driver's license has no upper age limit, requiring only that applicants be at least 18 years old and pass a medical examination to take the driving test. However, the B2 license differs significantly, imposing strict age requirements. The B2 license is restricted to individuals aged 21 to 50. Therefore, when upgrading from a C1 to a B2 license, applicants must not exceed 50 years of age or be under 21. Holding the License for at Least 2 Years After obtaining a C1 license, there is a one-year probationary period during which an upgrade application cannot be submitted. Therefore, applicants must wait until the C1 license has passed the probationary period and has been held for at least 2 years before applying to upgrade to a B2 license. Not Having Accumulated 12 Penalty Points As is well known, a driver's license has a maximum of 12 penalty points per cycle. Violations while driving result in point deductions and fines. To upgrade from C1 to B2, applicants must not have accumulated 12 penalty points within two cycles. If 12 points were deducted in any two cycles, the applicant cannot apply for an upgrade and must wait for another two cycles without accumulating 12 points before reapplying. Not Having Been Involved in Major Traffic Accidents Obtaining a B2 license allows drivers to operate large trucks, such as 9.6-meter-high barrier trucks, which demand high driving skills. If a driver lacks sufficient experience, accidents are more likely to occur. However, accidents involving large trucks differ from those involving private cars due to their size, weight, and cargo. The consequences of such accidents can be severe. Therefore, the B2 license imposes strict requirements on driving skills. The following outlines the main components of the upgrade test: Subjects 1, 3, and 4 remain unchanged, covering theory, road tests, and safety & civilization driving tests. Subject 2 includes tests such as pole parking, hill starts, parallel parking, single-plank bridge crossing, curve driving, right-angle turns, narrow gate passage, continuous obstacle navigation, bumpy road driving, narrow road U-turns, and simulations for highways, mountain roads with sharp turns, tunnels, rain/fog conditions, slippery roads, and emergency handling. During the probationary period after upgrading, driving vehicles under the original license class is unrestricted. A driver's license, officially known as a motor vehicle driving license or simply "license," is a legal document required for operating motor vehicles. It certifies that the holder has learned and mastered traffic regulations and driving skills, passed relevant tests, and is legally permitted to drive specific types of vehicles. Applicants cannot upgrade from C1 to B2 under the following circumstances: causing a fatal accident with equal or greater liability, drunk driving, or having their license revoked or suspended within the past 10 years. Since the B2 license, like the C1, can be applied for during the initial driving test registration, applicants need only enroll in a driving school. However, many regions lack driving schools or test centers for B2 licenses. In such cases, applicants can apply for a B2 license in another location where such facilities are available. According to Article 19 of the "Road Traffic Safety Law": Driving a motor vehicle requires a valid driver's license. Applicants must meet the driving permit conditions set by the public security department under the State Council. Upon passing the test, the traffic management department issues the corresponding license. Drivers must operate vehicles within their licensed class and carry their license while driving. Therefore, it is clear that driving without a license or operating a vehicle beyond the licensed class is illegal. Per the State Council Legislative Affairs Office's reply on the interpretation of the "Road Traffic Safety Law" and its implementation regulations: Driving a vehicle beyond the licensed class is considered unlicensed driving. Penalties should be proportionate, with lighter punishments possible compared to unlicensed driving. Both offenses fall under Article 99 of the "Road Traffic Safety Law," which stipulates fines and potential detention of up to 15 days for driving without a license, with a revoked or suspended license.

6

4

Share

What is the fuel tank capacity of the Roewe 550?

What causes the noise when shifting to P gear before the car comes to a complete stop?

What to Do When the Car Battery Is Dead and Won't Start?

Which direction to turn when loosening car tire bolts?

What car has an eagle-like logo?

How Long Until a Vehicle is Considered Scrapped?

What are the four conditions for upgrading from C1 to B2 license?

Is Driving a Yellow License Plate Vehicle with a C License Considered Unlicensed Driving?

What are the Ten Don'ts for Safe Driving?

Can a Car Recover from a Dead Battery on Its Own?

What is OnStar Vehicle Geo-Fence?