What is the fuel tank capacity of the Oshan X5?

2 Answers
MacCarson
07/23/25 8:32pm
Changan Oshan X5 has a fuel tank capacity of 53 liters, which is the officially announced data. Owners who have purchased the Changan Oshan X5 can also check this information on the vehicle's configuration sheet. The fuel grade for the Changan Oshan X5 is 92, with a fuel consumption of 6.0 to 6.3L per 100 kilometers. A full tank of fuel can cover a distance of 841 to 883 kilometers. During daily driving, it is necessary to always pay attention to the remaining fuel level in the tank. This is usually observed through the fuel gauge inside the vehicle. If there are no other issues, the fuel level will be accurately reflected on the gauge. The fuel gauge on the dashboard typically has 5 to 6 segments. It is generally recommended to refuel when there are only 2 segments left to avoid running out of fuel midway. During actual refueling, the amount of fuel may exceed the marked capacity. This is because the fuel tank capacity marked by the car manufacturer is the volume from the bottom of the tank to the safety limit. There is still some space from the safety limit to the tank opening, which is reserved to allow for fuel expansion due to temperature increases without causing overflow. If fuel is filled up to the tank opening during refueling, the actual refueling amount may exceed the marked fuel tank capacity.
Was this review help?
2
0
Share
DeEva
08/10/25 6:31pm
51 liters is the standard fuel tank capacity, but many owners have measured that a full tank can reach around 53 liters. When I drove this car on long trips, I calculated that it can generally run about 500 kilometers in the city and around 650 kilometers on the highway. A reminder to everyone: don't wait until the last fuel bar to refuel, as the fuel pump can easily overheat. The fuel filler is located on the right rear side of the body, and you can unscrew the No. 9 fuel cap to fill up with 92-octane gasoline. The fuel tank is made of resin material, which is much more corrosion-resistant than iron.
Was this review help?
9
2
Share
Expand All
More Forum Discussions

What transmission does the Lexus UX use?

Lexus UX is equipped with an electronic continuously variable transmission (E-CVT). Below is some introduction about the transmission: 1. The transmission is a very important component in a vehicle. It can change the transmission ratio and expand the torque and speed of the driving wheels. 2. With the development of modern technology, transmissions have also been upgraded. From the initial manual transmission to the current continuously variable transmission, and from no synchronizer to having a synchronizer, operation has become increasingly convenient. 3. The performance of the transmission is key to measuring the power, economy, and drivability of engineering machinery. Current transmission systems mainly include: mechanical transmission and hydrostatic transmission.
4
2
Share

Why doesn't the steering wheel automatically return after turning?

The external steering gear is damaged. When a car turns, the steering wheel is designed to automatically return to the center position. This is intentionally designed to enhance the car's handling and driving stability. The key factors are the caster angle and the kingpin inclination, with the caster angle having the greatest influence. The front wheels of the car are independent suspensions, so there is no physical kingpin, just a virtual line. The wheels rotate around an axis, which is referred to as the kingpin. Below is an introduction to the steering wheel: 1. Steering Wheel Overview: The steering wheel is a wheel-shaped device used to control the direction of cars, ships, airplanes, etc. 2. Steering Wheel Function: The function of the steering wheel is to convert the force applied by the driver to the edge of the steering wheel into torque and transmit it to the steering shaft.
20
5
Share

Is it 'Backing Up, Please Be Aware' or 'Please Be Aware, Backing Up'?

Most commonly, it's 'Please Be Aware, Backing Up.' Here are some relevant introductions about backing up: 1. Precautions: Whether you're a novice or an experienced driver, this is a must-know point. Not only should you avoid pressing the accelerator while backing up, but you should also avoid half-pressing the brake. Especially for novices, the speed should be slower than idle speed. This allows more time to observe the surroundings. 2. Basic essentials: When parking in a parking lot, first, visually estimate the width of the parking space, check for any obstacles behind, whether there are cars parked on both sides, and if the length is suitable for your vehicle. If visibility is poor at night, step out to observe the exact position before backing up.
4
4
Share

Ignition System Troubleshooting Methods?

Here are the troubleshooting methods for the ignition system: 1. For ignition system faults, first start the engine and check if the warning light is illuminated. If it is, use a fault code reader to retrieve the fault codes. 2. Diagnose faults in the low-voltage circuit based on the fault code content. If the warning light is normal, then check the high-voltage circuit of the ignition system. Common causes of ignition system faults include: 1. Difficulty starting: Mainly manifests as trouble during initial startup, normal idling, normal acceleration in neutral, occasional jerking when starting, and stalling easily when starting on an incline. 2. Engine misfire: The engine misfire mainly manifests as no faults during idling and low speeds, but starts to shake after continuous high-speed driving for a period of time.
18
0
Share

What are the differences between the ES200 and ES260?

The differences between the ES200 and ES260 lie in the powertrain. Below are the specific details: 1. The ES200 model is equipped with a 2.0L inline 4-cylinder naturally aspirated engine, paired with a 6-speed automatic transmission. It delivers a maximum power of 127kW (173PS) and a peak torque of 208Nm. 2. The ES260 is powered by a Dynamic-Force series 2.5L naturally aspirated engine, producing a maximum power of 152kW (207PS) and a peak torque of 243Nm, matched with an 8-speed automatic transmission.
7
5
Share

What Causes Engine Idle Vibration in Motor Vehicles?

Motor vehicle engine idle vibration can be caused by the following reasons: 1. Dirty air filter: The air filter is designed to protect the engine and reduce wear. Simply replacing the air filter can resolve this issue. 2. High-voltage line breakage: A high-voltage line breakage refers to the interruption of the conductor core in the high-voltage line, which can affect ignition and cause engine vibration. 3. Low idle speed: The engine idle speed value is preset in the computer. When the RPM drops below a certain range, the vehicle's computer will automatically adjust it. 4. Abnormal water temperature: High water temperature can lead to advanced ignition timing, changes in the air-fuel mixture ratio, thinning of engine oil viscosity, and reduced lubrication performance. 5. Clogged fuel injector: Impurities in gasoline can clog the injector nozzles, causing inconsistent fuel injection from each injector. This results in uneven cylinder operation and engine vibration.
18
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.