What is the fuel tank capacity of the Kia K3 in liters?

1 Answers
MacAxel
07/29/25 8:34pm
The fuel tank capacity of the Kia K3-2021 Modified 1.5L CVT Youth Edition is 53L. The vehicle is equipped with a 1.5L naturally aspirated engine and an 8-speed continuously variable transmission (CVT). The drivetrain configuration is front-engine, front-wheel drive. The front suspension type is MacPherson strut independent suspension, while the rear suspension employs a torsion beam non-independent suspension. Among comparable models in its class, the Hyundai Elantra-2021 1.5L CVT GLS Leading Edition has a fuel tank capacity of 47L, and the MG 6-2021 1.5T Automatic Tide Leading Edition features a 50L fuel tank. During actual refueling, the amount of fuel filled may exceed the calibrated capacity. This occurs because automakers specify tank capacity from the tank bottom to the safe fill level, leaving additional space between this level and the tank opening. This safety margin accommodates fuel expansion due to temperature increases, preventing overflow. If fuel is filled up to the tank opening during refueling, the actual fuel quantity will surpass the nominal tank capacity. To check remaining fuel levels, drivers can observe the fuel gauge on the right side of the instrument cluster, marked with E (Empty) and F (Full). When the needle approaches E, it indicates low fuel, while proximity to F signifies sufficient fuel levels.
Was this review help?
10
1
Share
More Forum Discussions

What is the transmission model of the Touareg?

The Touareg is equipped with an 8-speed automatic transmission with manual shift mode. Essentially, this type of transmission is a traditional AT or CVT gearbox enhanced with manual shifting capability. The purpose of this design is to provide more driving pleasure for automatic transmission vehicles. The Touareg utilizes a transmission manufactured by ZF. ZF is a German transmission supplier, renowned alongside Aisin and Getrag as one of the world's top three transmission manufacturers. Headquartered in Germany, ZF's primary products include mechanical transmissions, hydraulic automatic transmissions, various gearboxes, as well as steering systems, drive axles, pumps, suspension systems, and electromagnetic clutchers. When using the Touareg's transmission in daily driving, pay attention to the following points: Do not delay transmission fluid changes for extended periods. Prolonged use of old transmission fluid can damage internal components such as bearings and the housing. Avoid prolonged coasting in neutral. While some experienced drivers coast in neutral with manual transmissions, doing so with an automatic transmission can cause overheating. Additionally, shifting back into D (Drive) mode from neutral may create sudden jolts. Never shift into D or R (Reverse) before the vehicle comes to a complete stop. Some drivers attempt smooth gear changes by shifting into reverse while still moving forward, but this practice severely damages transmission gears and may eventually lead to gear grinding. Avoid frequent steep hill climbs in D mode. Automatic transmissions may overheat under heavy load or upshift prematurely during steep ascents, resulting in insufficient power. In such situations, use manual mode to maintain lower gears or switch to sport mode to protect the transmission. Do not tow the vehicle over long distances. If the automatic transmission vehicle breaks down, transport it using a flatbed tow truck with the transmission in N (Neutral). Never tow the vehicle directly with a rope or similar method.
9
4
Share

What Causes the Engine Warning Light to Illuminate in the 2019 Honda Lingpai?

The main reasons for the engine warning light to illuminate include sensor issues, engine misfire, car maintenance problems, fuel or oil quality issues, poor combustion of the air-fuel mixture, engine intake problems, turbocharging problems, exhaust system issues, and problems with the anti-theft system. Additionally, when starting the car, the vehicle performs a self-check on the engine system. Normally, the engine warning light should turn off after the self-check is completed. If it remains on for an extended period, it is advisable to visit a repair station promptly to seek professional assistance and eliminate potential safety hazards. Below is a detailed explanation of each type of fault: Sensor Issues: Sensors include coolant temperature, crankshaft position, air flow, intake temperature, oxygen sensors, etc. When these sensors are damaged, have poor connections, or experience signal interruptions, the car's ECU cannot accurately obtain engine data, which triggers the engine warning light. Solution: If such issues occur, promptly visit a repair center for professional inspection and eliminate safety hazards. Maintenance Issues: Poor engine maintenance is one of the most common causes of the engine warning light illuminating. Vehicles have specific maintenance cycles. If maintenance is not performed on schedule, coupled with poor driving habits, the engine's operational burden increases, eventually causing the engine warning light to illuminate as a reminder of a fault. Solution: Follow the maintenance schedule in the vehicle's manual, either by time or mileage, and perform comprehensive maintenance to eliminate non-maintenance-related issues. Fuel or Oil Quality Issues: This refers to the quality of both fuel and engine oil. The fuel used in cars usually has a specific octane rating, and engine oil can be semi-synthetic or fully synthetic. Manufacturers typically recommend the type of fuel and oil to use. If the owner fails to follow these recommendations, prolonged use can cause engine wear, leading to the warning light illuminating. Solution: Use the appropriate fuel octane rating and engine oil grade as specified for the vehicle. Poor Combustion of Air-Fuel Mixture: Faulty spark plugs, fuel pump issues, or clogged fuel lines can cause poor combustion of the air-fuel mixture in the engine. This leads to engine carbon buildup or knocking, which is detected by the oxygen sensor and reported to the ECU, triggering the warning light. Intake Issues: During engine combustion, proper air intake is essential, and the air filter plays a critical role. If the air filter is dirty or not cleaned regularly, it can affect the engine's air intake, potentially leading to blockages. Severe cases can cause the engine warning light to illuminate. Solution: Regularly clean or replace the air filter to ensure the intake system functions properly. Turbocharging Issues: Problems with the intake boost system or turbocharger can also trigger the engine warning light. The most common issue is turbocharger failure, accompanied by symptoms such as oil leaks, excessive oil consumption, reduced power, metallic noises, or blue/black smoke from the exhaust. Solution: Visit a 4S shop to inspect and replace the turbocharger. In most cases, repair is not cost-effective, and replacing the component is the better option. Exhaust System Issues: These include the rear oxygen sensor, catalytic converter, exhaust camshaft, and bearings. The most common issue is catalytic converter failure, which can be caused by physical damage or fuel system malfunctions. Solution: Use lead- or silicon-based lubricants to maintain and clean the catalytic converter. Anti-Theft System Issues: If the car's electronic anti-theft system malfunctions or the anti-theft controller is incompatible with the engine ECU, the engine may not operate correctly, and the warning light will illuminate. Solution: Visit a professional repair shop for a systematic inspection, as this issue cannot be resolved individually. Engine Misfire: This occurs when one or more cylinders fail to operate or operate poorly, leading to symptoms such as reduced power, difficulty starting, or unstable idling. Solution: First, identify which cylinder's components are faulty and replace them. If internal mechanical damage is detected, a major repair at a professional shop is necessary.
1
2
Share

How to Charge a Leapmotor Vehicle?

When purchasing the vehicle, the manufacturer provides a free 220V slow charging cable or wall-mounted charging station for charging the car. The fast charging port of this vehicle is located on the right front fender. With the vehicle unlocked, pressing the left side of the charging port cover will open it.
4
1
Share

How to fold the rearview mirror of Lynk & Co 01?

Set the ignition switch to position I or above, then simultaneously press the L or R button and release it. Press the L or R button simultaneously again, and the rearview mirror will automatically stop at the fully extended position.
9
3
Share

How to start a Suzuki GSX250 with a dead battery?

First, shift into first gear, depress the clutch, turn the key to the ACC position, and have friends push the bike from behind. When the bike gains enough speed, release the clutch, and the motorcycle will start successfully due to inertia.
18
3
Share

How to Turn on the Dash Cam in Leapmotor T03?

Insert the vehicle key and power on the car body, then you can turn on the dash cam by long-pressing its power button. Insert the vehicle key and power on the car body, the dash cam will automatically turn on. When the car is turned off and the key is removed, the dash cam will also automatically shut down.
2
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.