What is the fuel tank capacity of the JMC Transit in liters?

1 Answers
TaylorDella
07/30/25 4:11am
The 2021 JMC Transit comes in 12 models, all of which have a fuel tank capacity of 68 liters. All models are equipped with a 2.8-liter turbocharged engine, paired with a 5-speed manual transmission (MT), and feature a front-engine, rear-wheel-drive layout. Among vehicles in the same class, the 2021 Dragon W5 has a fuel tank capacity of 70 liters, while the 2020 Ruitu has an 80-liter fuel tank. If owners wish to check the remaining fuel level, they can observe the fuel gauge on the right side of the instrument panel, which is marked with E and F. When the needle is close to E, it indicates that the fuel is running low, and when it is near F, it means the fuel level is sufficient. Fuel tank maintenance includes the following: Drain any accumulated water and sediment from the fuel tank, and check for oil leaks at the fuel pipe joints and switches. For fuel tank caps equipped with air valves and vapor valves, also check if the vent holes are clear. The filter screen at the fuel filler inlet should remain intact to prevent impurities from entering the tank during refueling and clogging the fuel lines. The sealing gasket on the fuel filler cap should also be in good condition to prevent fuel from spilling out while driving.
Was this review help?
1
2
Share
More Forum Discussions

What are the steps for removing and installing the steering wheel of the Baojun 730?

Baojun 730 steering wheel removal and installation steps: After turning off the engine, switch off all electrical devices, turn the steering wheel 90 degrees, locate the hole on the back of the steering wheel, poke it with an appropriate tool, then return the steering wheel to the straight position, turn it 90 degrees in the opposite direction, poke the other hole, and the airbag assembly will come off. Remove the screws to take out the airbag, then remove the screws of the steering wheel, and the steering wheel can be taken off. The dimensions of the Baojun 730 are 4780 mm in length, 1780 mm in width, and 1740 mm in height, with a wheelbase of 2750 mm. It features front and rear disc brakes, front-wheel drive, and a fuel tank capacity of 52 liters.
16
5
Share

Symptoms of a Faulty Exhaust Valve?

Exhaust valve damage can cause engine shaking or even stalling during idle. If the exhaust valve is faulty, some exhaust gases will enter the engine's intake manifold during idle, leading these gases to participate in combustion within the combustion chamber. This results in an overly lean air-fuel mixture, causing unstable idle or stalling. The exhaust valve, also known as the Exhaust Gas Recirculation (EGR) valve, connects the intake manifold and the exhaust manifold. It controls the degree of valve opening via a vacuum tube, thereby regulating the amount of exhaust gas entering the intake manifold. The exhaust valve contains coolant, which helps lower the temperature of the exhaust gases. When the vehicle's exhaust valve malfunctions, the engine's fault indicator light will illuminate, prompting the owner to visit a repair shop or 4S dealership for inspection.
20
4
Share

How to Test the Condition of a Car Battery?

Methods to test the condition of a car battery: 1. Connect the positive and negative clips of the battery tester properly, with the red clip attached to the positive terminal and the black clip to the negative terminal of the battery; 2. Once connected, the battery will display the current static voltage; 3. Press the Enter key to select external testing; 4. Press the Enter key again to choose a standard lead-acid battery; 5. Select the measurement standard type based on the battery label; 6. Use the up and down buttons on the battery tester to adjust the test rating to 550A; 7. After adjusting the corresponding rating, press the Enter key to confirm and start the test; 8. Judge the actual condition based on the test results.
10
3
Share

Is the Lynk & Co 03 Plus engine from Volvo?

Lynk & Co 03 Plus engine is not from Volvo. The engine of Lynk & Co 03 utilizes Volvo's technology, but it does not directly use Volvo's engine. The Lynk & Co 03 is a compact sedan under the Lynk & Co brand, with dimensions of 4639mm in length, 1840mm in width, and 1472mm in height, and a wheelbase of 2730mm. The Lynk & Co 03 is equipped with three engines in total: a low-power version 1.5-liter turbocharged engine, a high-power version 1.5-liter turbocharged engine, and a 2.0-liter turbocharged engine. The front suspension of the Lynk & Co 03 uses a MacPherson independent suspension, while the rear suspension employs a multi-link independent suspension.
14
5
Share

What are the common methods for removing old paint?

Common methods for removing old paint: 1. Manual paint removal; 2. Mechanical paint removal; 3. Sandblasting paint removal; 4. Electric sanding; 5. Chemical paint removal. Manual paint removal is a commonly used method in painting work and is the only method for partially removing old paint films. It mainly relies on tools such as scrapers, putty knives, wire brushes, and sandpaper to remove old paint from the surface of vehicle components. Mechanical paint removal uses electric or pneumatic tools, such as wire wheels, wire sanders, and dry/wet sandpaper sanders, to replace manual scraping and sanding. Sandblasting paint removal involves using compressed air, high-pressure water flow, or mechanical centrifugal force to project abrasives, sand, or metal shot onto the old paint surface, removing the old paint through impact and friction.
17
0
Share

How often should the throttle body and fuel injectors of a car engine be cleaned?

It is recommended to clean the throttle body and fuel injectors of a car engine every 20,000 to 40,000 kilometers. However, cleaning the throttle body too frequently is not beneficial. Over-cleaning can gradually remove the special coating inside the throttle body cavity. Without this coating, the cavity is more prone to oil buildup, which can accelerate the aging of the throttle body or increase its load. On the other hand, if the throttle body is not cleaned for a long time, the accumulated carbon deposits and impurities can affect the accuracy of the throttle opening. This may also allow air containing impurities to enter the combustion chamber, disrupting the normal operation of the engine. The most noticeable symptoms include unstable idling, a sudden feeling of fuel cutback during normal driving, significantly reduced power, increased fuel consumption, and in some cases, even difficulty starting the engine.
16
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.