What is the fuel tank capacity of the Great Wall Pao Commercial Edition diesel model in liters?

Is Higher Oil Viscosity Always Better?

Higher oil viscosity is not always better. Here are the impacts of oil viscosity: 1. Difficulty in cold engine starts. If the oil viscosity is too high, oil circulation during cold starts will be slow. Although oil pressure may be high, the actual oil flow is limited due to poor pumpability caused by excessive viscosity. This can lead to temporary dry or semi-fluid friction. 2. Poor cooling performance. Higher viscosity oil has poorer fluidity and slower circulation speed, resulting in reduced heat dissipation from friction surfaces and potentially causing engine overheating. 3. Reduced cleaning effectiveness. Thicker oil circulates more slowly, passing through filters less frequently. This makes it harder to remove metal particles, carbon deposits, and other contaminants from friction surfaces. 4. Conversely, if oil viscosity is too low, it may not form a sufficiently thick oil film on high-temperature friction surfaces. The weaker load-bearing capacity of such thin oil films makes them prone to breakdown under pressure, leading to inadequate lubrication and increased wear.

6

2

Share

What Causes Car Lights to Flash?

Car lights are primarily used for illumination during daily driving, nighttime, and poor visibility conditions, as well as to alert other vehicles, ensuring driving safety. The reasons for car lights flashing are as follows: 1. The hazard warning light switch is turned on. 2. Partial circuit faults connected to the vehicle's computer, bulb or ignition coil faults, or stabilizer faults. 3. Poor line contact causing a short circuit. 4. The vehicle's computer activates the recognition system for the anti-theft chip. 5. Insufficient battery power, prompting the car to alert the owner by flashing the lights. 6. Faults in the braking system causing the tail lights to flash continuously. 7. The steering wheel is locked when parking, activating the car's anti-theft function.

9

5

Share

What brand is Jetta?

In the past, Jetta was a compact car under the Volkswagen brand. Now, Jetta itself has become an independent automotive brand. Here is the relevant information: 1. The current status of Jetta is similar to Audi, both being independent brands under Volkswagen. The last Jetta model under FAW-Volkswagen was the 2019 version. On June 21, 2019, the last mass-produced vehicle rolled off the production line. Over 28 years in China, Jetta produced a total of 4,418,287 units. 2. As of November 29, 2019, the Jetta brand has two models on sale: the Jetta VS5, positioned as a compact SUV, with five variants available, all meeting the China VI emission standards. The Jetta VA3, positioned as a compact car, with four variants available, all meeting the China VI emission standards. A new compact SUV, the Jetta VS7, is also set to be launched in the future.

12

4

Share

Where to Add Coolant in a BMW?

Open the hood, and you will find a black reservoir on the left side of the engine. Open the cap of the reservoir to add coolant. Here is some relevant information: 1. The full name of coolant is antifreeze coolant, which has antifreeze functionality. Coolant is not only used in winter but also throughout the year. Whether it's cold or hot, a car cannot function without coolant. Proper use of coolant not only protects the engine's cooling system and improves heat dissipation but also enhances engine efficiency and extends its lifespan. 2. Be careful not to mix different types of antifreeze. Different types of antifreeze have varying freezing points due to their different compositions, so it's important to choose based on the temperature conditions of the vehicle's operating environment. Generally, the freezing point of the selected antifreeze should be 10-15°C lower than the local minimum temperature to prevent the antifreeze from losing its antifreeze function.

12

4

Share

How to Replace the Battery in a Lavida Car Key?

The method for replacing the battery in the new Lavida key is as follows: 1. There are two screws on the back cover of the car key. Use a screwdriver to remove each screw, then open the back cover to see the battery panel. Remove the old battery, install the new battery, then reattach the back cover and tighten the screws. 2. The Lavida is a sedan produced by Shanghai Volkswagen, with body dimensions of 4670 mm in length, 1806 mm in width, and 1474 mm in height, and a wheelbase of 2688 mm. The new Lavida features front-wheel drive, with a front suspension type of MacPherson independent suspension and a rear suspension type of torsion beam non-independent suspension, and a body structure of unibody construction.

2

1

Share

How to Check the Tire Pressure Monitoring on Trumpchi GM8?

The tire pressure monitoring switch for the Trumpchi GM8 is located on the steering wheel. Press the page-turning button to display the tire pressure information. The tire pressure monitoring function can monitor the tire pressure and temperature of each tire in real-time and will alert the driver promptly when any abnormalities are detected, allowing timely action to prevent accidents. Tire Pressure Reset Method: First, turn on the ignition switch, then press and hold the tire pressure monitoring reset button until you hear a "beep" sound before releasing it. The tire pressure monitoring system will store the current normal tire pressure data, automatically clear the previous data, and finally, the warning light on the dashboard will turn off, indicating the tire pressure reset is complete. There are three commonly used tire pressure monitoring methods: Direct Tire Pressure Monitoring: Direct tire pressure monitoring devices use pressure sensors installed in each tire to directly measure the tire pressure. The pressure information is transmitted wirelessly from inside the tire to a central receiver module, which then displays the tire pressure data for each tire. The system automatically alerts when the tire pressure is too low or if there is a leak. Indirect Tire Pressure Monitoring: When the pressure in a tire decreases, the vehicle's weight causes the rolling radius of that wheel to become smaller, resulting in a faster rotation speed compared to the other wheels. By comparing the differences in rotation speeds between the tires, the system monitors the tire pressure. Indirect tire pressure monitoring systems essentially rely on calculating the rolling radius of the tires to monitor pressure. Introduction to Tire Pressure Monitoring System (TPMS): This system combines the advantages of both the direct and indirect systems. It is equipped with direct sensors in two diagonally opposite tires and an indirect system for all four wheels. Compared to a fully direct system, this hybrid system can reduce costs and overcome the limitation of indirect systems, which cannot detect simultaneous low pressure in multiple tires. However, it still cannot provide real-time pressure data for all four tires as accurately as a direct system.

1

4

Share

What is the fuel tank capacity of the Great Wall Pao Commercial Edition diesel model in liters?

Is Higher Oil Viscosity Always Better?

What Causes Car Lights to Flash?

What brand is Jetta?

Where to Add Coolant in a BMW?

How to Replace the Battery in a Lavida Car Key?

How to Check the Tire Pressure Monitoring on Trumpchi GM8?

Which region does the license plate starting with 'Su' belong to?

What Causes Oil Spray from the Exhaust Pipe of a Diesel Engine?

How to Check for Carbon Buildup in a Car?

What Causes the Anti-Skid Light to Appear on the Car?