What is the fuel tank capacity of the Golf 7 in liters?

What are the 2021 point deduction standards for reverse parking?

Reverse parking test requirements: Candidates should follow the ground markings and operate the vehicle in the prescribed sequence to correctly reverse into and exit the garage from both sides of the test area. After both front wheel contact points exceed the control line at one end of the road, the vehicle must be reversed into the rear garage and parked correctly for the first time; then proceed forward out of the garage towards the control line at the other end of the road. When both front wheel contact points exceed the control line, stop, and reverse into the rear garage again to park correctly for the second time; finally, exit the garage and drive the vehicle back to the starting point, leaving the test area. Except for parking in the garage, stopping midway is not allowed, and the vehicle body must not cross the line. The total completion time must not exceed 210 seconds. New assessment standards: Failing to follow the prescribed sequence of routes results in disqualification; vehicle body crossing the line results in disqualification; failing to properly reverse into the garage results in disqualification; before reversing, if both front wheel contact points do not exceed the control line, it results in disqualification; exceeding the 210-second completion time results in disqualification; stopping midway for more than 2 seconds deducts 5 points per occurrence.

20

3

Share

How Far Should the Car Be from the Side Line When Reversing into a Parking Space?

Generally, the distance between the car body and the side line when reversing into a parking space should be 1.5 meters. If it is too close, the car may easily hit the left corner of the parking space, and the steering wheel should be turned fully to the right earlier. If it is too far, the car may easily hit the right corner of the parking space, and the steering wheel should be turned fully to the right later. By observing a little more than the outer quarter of the lower edge of the left rearview mirror, just seeing the side line indicates a distance of 1.5 meters. However, this should be adjusted based on the individual's seat height during practice. Tips for reversing into a parking space: When ensuring the wheels won't touch the right side line and maintaining a 20 cm distance from it, immediately turn the steering wheel fully to the right. As the car moves backward, the body gradually becomes parallel to the side line. At this point, observe both left and right rearview mirrors simultaneously to adjust the distance between the car body and the side lines. Pay attention to keeping the car body parallel to the parking space side lines with roughly equal distances. Also, focus on the lower edge of the left rearview mirror and the parking space entrance line. When the parking space entrance line aligns with the left rearview mirror, press the clutch and brake to stop, completing the right-side reversing. During regular practice, it's essential to learn how to use the rearview mirrors. You can start by checking the mirrors while the car is stationary, mainly focusing on the car's position and its distance from the parking space side lines. Once thoroughly familiar, you can smoothly observe while reversing.

14

4

Share

Where Are the Reference Points for Reverse Parking?

Whether it's right-side or left-side reverse parking, there are two most important reference points: The first point is when to fully turn the steering wheel left/right during reverse parking, characterized by the lower edge of the left rearview mirror aligning with the starting line (dashed line). The second point is when the vehicle is completely inside the parking space, the body is straight and centered in the space, indicating that the right-side parking is about to be completed, and it's time to stop—this stopping point is what we call the second reference point. Left-side reverse parking (left exit): Observe the left car door; when the exit line aligns with the middle of the two car doors, turn the steering wheel left by one and a quarter turns (one full turn plus one vertical turn) and hold it steady until the window switch presses against the exit line, then stop. Left-side entry: Shift into reverse gear, ensuring not to move the steering wheel (keep it at one full turn plus one vertical turn). When the left rear wheel is about to touch the extended line of the left corner (note: just before touching—touching the extended line would be too late; this may seem abstract, as the extended line is an imagined extension of the left line inside the parking space), fully turn the steering wheel left. When the left rear wheel is about to enter the space, check if adjustments are needed. Ensure the left rear wheel enters the space, then check the right rearview mirror—when the right corner becomes visible, straighten the steering wheel. The stopping point is the same as above. Right-side reverse parking (right entry): First point: When the lower edge of the left rearview mirror aligns with the parking line parallel to the left rearview mirror, fully turn the steering wheel right. Second point: When the most protruding part of the vehicle and the right corner appear two fingers' width apart in the right rearview mirror, turn the steering wheel left by one full turn (no more, no less). Third point: In the right rearview mirror, when the right corner points to the middle of the front door handle, fully turn the steering wheel right again. Fourth point: As soon as the left rear corner becomes visible in the left rearview mirror, immediately straighten the steering wheel. Fifth point: The stopping point inside the parking space—again, when the lower edge of the left rearview mirror is about to align with the parking line parallel to the left rearview mirror. Right exit: As soon as the left rear wheel crosses the exit line, fully turn the steering wheel right. When the window line aligns parallel to the parking boundary line, straighten the steering wheel. At this point, the front should appear wider and the rear narrower, as the vehicle body naturally has a curvature—what looks slanted is actually correctly parked.

15

1

Share

What are the standard dimensions for a reverse parking garage?

The standard dimensions for a reverse parking garage are as follows: For small cars, the garage length is 5.25 meters and the width is 2.3 meters. For large vehicles, the dimensions are 15.9 meters in length and 6.83 meters in width. The evaluation criteria for reverse parking include: failure to follow the designated route or sequence results in disqualification; the vehicle body crossing the line results in disqualification; failure to fully enter the garage results in disqualification; stopping midway results in disqualification; exceeding 4 minutes results in disqualification. Reverse parking rhyme: Reversing in and out isn't hard, fasten seatbelt, shift gear, left signal flash. Press clutch, release handbrake, slowly lift clutch to start gently. Watch the right line to adjust the car body, left mirror seam follows the right line. Stop when the front line aligns with the shoulder, shift to reverse gear, release clutch. When the left mirror covers the corner of the horizontal line, turn the steering wheel fully to the right. Watch the left mirror for the garage line, turn back one circle at a 30-degree angle, when the car aligns with the line, straighten the wheel with two full turns. When the left mirror covers the front corner of the garage, press clutch and brake. Shift to first gear to exit, turn the wheel fully left when the car touches the line. Stop when the car hood covers the line, keep the wheel position to reverse. Watch the right mirror for the garage line, turn back one circle at a 30-degree angle, when the car aligns with the line, straighten the wheel with two full turns. When the left mirror covers the front corner of the garage, press clutch and brake. Shift to first gear to exit, turn the wheel fully right when the car touches the line. Stop when the car hood covers the line, adjust the car body skillfully. The new garage has no poles to reference, only ground markings, and the garage length is much shorter than before, just enough for a car to fully park inside. The process involves reversing in from the right, then driving out to the left, reversing back in, and finally driving out to return to the starting point. This process is much simpler, eliminating the step of moving the car within the garage as in the current test.

5

3

Share

What are the detailed deduction items for reverse parking?

Subject 2 deduction standards general requirements: Failure to use the seat belt as required, deduct 100 points; Engine stalling once due to improper operation, deduct 10 points. For reverse parking, failure to follow the prescribed route or sequence, deduct 100 points; Vehicle body crossing the line, deduct 100 points; Failure to fully enter the parking space, deduct 100 points; Stopping midway, deduct 100 points. Key points for reverse parking in Subject 2 from the return point to entering the garage: Engage the reverse gear, keep the steering wheel at the left-turn limit position unchanged, and reverse the vehicle. The driver should observe the left rearview mirror and adjust the direction to guide the rear of the vehicle into the garage. After the vehicle enters the garage, the driver should observe the right rearview mirror. When the entire right line of the garage becomes visible, immediately straighten the steering wheel. Then, the driver should shift focus to the left rearview mirror and stop immediately when the left door handle is level with the garage's bottom line.

7

0

Share

How Many Days Does It Take to Learn Reverse Parking?

Generally, learning reverse parking requires four class hours per day, and it takes about a week to master. The evaluation criteria for reverse parking are as follows: failing to follow the prescribed route or sequence results in disqualification. If the vehicle body crosses the line or fails to enter the parking space, it is disqualified. Exceeding 210 seconds to complete reverse parking results in disqualification. Stopping midway deducts 5 points each time. Tips for reverse parking operation: control the driving speed by using first gear or reverse gear at idle speed throughout the process; maintain the same speed as when starting. Control the steering timing—observe carefully during the reverse process, grasp the key points of steering, and turn at the right moment. Control the driving route—during the test, the vehicle's path mainly depends on the speed of steering wheel rotation and driving speed. When reversing, aim for the side lines, correct the direction promptly, and keep the vehicle straight while entering the parking space.

9

0

Share

What is the fuel tank capacity of the Golf 7 in liters?

What are the 2021 point deduction standards for reverse parking?

How Far Should the Car Be from the Side Line When Reversing into a Parking Space?

Where Are the Reference Points for Reverse Parking?

What are the standard dimensions for a reverse parking garage?

What are the detailed deduction items for reverse parking?

How Many Days Does It Take to Learn Reverse Parking?

Should I Press the Brake When Shifting Gears During Reverse Parking?

How many minutes should it take to complete reverse parking?

What are the rules for reverse parking?

What is the appropriate position for adjusting rearview mirrors when reversing into a parking space?