What is the fuel tank capacity of the Chery E3 in liters?

2 Answers
EmmettDella
09/08/25 7:37am
The fuel tank capacity of the Chery E3 2015 1.5L Manual Fun Edition is 42L. It is equipped with a 1.5L naturally aspirated engine and a 5-speed manual transmission (MT). The drivetrain is front-engine, front-wheel drive. The front suspension type is MacPherson independent suspension, and the rear suspension type is torsion beam non-independent suspension. In the same vehicle class, the Baojun 310 2020 1.2L Manual Value Edition has a fuel tank capacity of 30L, while the Kia Pegas 2020 1.4L Automatic Comfort Sunroof Edition has a fuel tank capacity of 43L. During actual refueling, the amount of fuel may exceed the calibrated capacity. This is because the fuel tank capacity marked by the manufacturer is measured from the bottom of the tank to the safe fill level, and there is additional space from the safe fill level to the tank opening. This space ensures that the fuel can expand when temperatures rise without overflowing. If fuel is filled up to the tank opening during refueling, the actual amount of fuel added may exceed the calibrated tank capacity. To check the remaining fuel level, drivers can observe the fuel gauge on the right side of the instrument panel, which is marked with E and F. When the needle is close to E, it indicates low fuel, and when it is near F, it indicates a sufficient fuel level.
Was this review help?
10
0
Share
DelZoe
09/20/25 6:05am
I've been driving the Chery E3 for over three years, and the official fuel tank capacity is 42 liters. For daily commuting, a full tank shows over 500 kilometers on the dashboard, but in actual city driving conditions, I need to refuel after about 400 kilometers. I have a habit of refueling when the fuel warning light comes on to save time and effort, but I don't delay too long to avoid damaging the fuel pump. The fuel filler is on the left rear side and is operated with a mechanical key, which isn't as convenient as an electronic button but is less prone to failure. Once on a long trip, I refueled when I had half a tank left at a service area, and found that the pump stopped at 38 liters, indicating a reasonable fuel reserve design. Overall, the 42-liter capacity is quite economical and fully sufficient for regular household use.
Was this review help?
15
5
Share
Expand All
More Forum Discussions

What to Do If You Have a Driver's License but Are Afraid to Drive on the Road?

If you have a driver's license but are afraid to drive on the road, here are some solutions: 1. In the initial stage of driving on the road, you can choose to have an experienced driver accompany you, which will act as a reassurance and make you feel more at ease. 2. Choose places with fewer cars. If you are really afraid of driving on the road, try to choose areas with less traffic, providing a good practice environment for new drivers. Once you become more familiar with driving, you can then move to areas with heavier traffic. 3. Familiar roads and cars. Start by driving on roads you are familiar with, as you will have better control over the surrounding traffic conditions. You can also prepare in advance for when to slow down or when traffic might get congested. Using a car you are familiar with will further enhance your sense of security. 4. Maintain a good mindset. Every experienced driver was once a beginner. If you never drive, you will always remain a novice. If you feel particularly nervous, you can slow down a bit—safety is the most important thing.
4
5
Share

What is the size of Accord wiper blades?

For the 14-16 Honda Accord models, the wiper blades on the passenger side and driver side are 19 and 26 inches respectively. If the rubber strip of the wiper blade ages, it may leave streaks on the windshield, and the metal wiper arm could potentially scratch the windshield glass, at which point the wiper blade needs to be replaced. The replacement steps are as follows: 1. First lift the driver side wiper arm, then lift the passenger side wiper arm. Avoid letting the wiper arms fall onto the windshield; this could damage the wiper arms and/or the windshield. 2. Press the tab and slide the bracket out from the wiper arm. 3. Pull the end of the tab and slide the wiper blade out of the bracket. 4. Remove the retainer from the detached wiper blade and install it onto the new wiper blade. Ensure the wiper blade protrusion and retainer groove are correctly aligned. 5. Slide the new wiper blade onto the bracket from the bottom end. The tab on the X bracket should snap into the recess of the wiper blade. 6. Slide the wiper blade onto the wiper arm, then press down the locking tab. 7. Lower the passenger side wiper arm first, then lower the driver side wiper arm.
17
3
Share

What does 2.0 naturally aspirated mean?

2.0 naturally aspirated refers to the vehicle's intake system where air enters the cylinders through the vacuum negative pressure generated by the downward movement of the engine pistons. Below is a related introduction to naturally aspirated cars: 1. Introduction: Naturally aspirated in cars refers to a method of engine intake, which is a form where atmospheric pressure forces air into the combustion chamber without the use of forced induction. 2. Expansion: Engines that use this intake method are called naturally aspirated engines. Naturally aspirated engines offer better smoothness in power output and responsiveness compared to forced induction engines.
4
1
Share

Does the front and rear position of the seat affect the driving experience?

Yes. Here is the relevant introduction about seat position: 1. Correct seat position: The correct seat height should be adjusted so that the driver's view is not blocked by the steering wheel, and all important instruments and street signs can be clearly seen. After adjusting the seat height, the front and rear position of the seat should also be adjusted. 2. Only by properly adjusting the seat can you clearly see the road conditions ahead: After adjusting the front and rear distance, adjust the seat height so that you can see the horizontal midline position of the front windshield. If the position is too high, when encountering sudden braking or uneven road surfaces causing the car to jolt, the driver's head can easily collide with the roof.
17
0
Share

What does 200 mph mean?

It means 300 kilometers per hour. The following are expressions of speed: 1. mph: stands for miles per hour. 1 mph = 1.609344 km/h. 2. km/h: In daily life, "kilometers" are often referred to as "kilometers". It can be expressed as kilometers per hour, km/h, km·h, kph or kmph. So kilometers per hour is "kilometers per hour". 3. m/s: read as meters per second, is a unit of speed that can be used to express vehicle speed. 4. Mach: Mach is a measure word for speed, also called Mach number. One Mach is equal to the speed of sound: a Mach number less than 1 is subsonic, and a Mach number greater than about 5 is hypersonic; the Mach number is the ratio of the flight speed to the speed of sound at that time, greater than 1 means faster than the speed of sound, similarly, less than 1 means slower than the speed of sound.
9
3
Share

Should the foot brake be pressed when starting in P gear of an automatic transmission?

Yes. Below are the precautions for using the foot brake: 1. Correct usage of the foot brake: The foot brake is generally used for deceleration and for emergency braking in dangerous situations. When driving on an ordinary road, when decelerating or stopping in complex situations, the accelerator pedal should be released in advance, utilizing the engine's pulling force, and then the brake should be applied gradually to slow down or stop. 2. When driving on mud, ice, or snow: Safe combined braking should be noted. Due to the low coefficient of adhesion, reduced braking efficiency, and high probability of skidding, the vehicle should use the foot brake alone to lock the wheels. When a car descends a steep slope, continuous use of the brake causes it to heat up, leading to reduced braking force until the brake fails. Therefore, during a long descent, the car should be pre-positioned in a low gear, making full use of the engine's drag operation to control speed. 3. When a vehicle is submerged in water, the brake is prone to failure: When soaked, a layer of water film adheres to the friction surface, reducing the friction coefficient by 20-30%, significantly lowering braking efficiency. Therefore, after wading through water, the vehicle must reduce speed and use the brake continuously multiple times to allow the heat generated by friction to evaporate quickly, restoring normal braking performance.
6
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.