What is the fuel tank capacity of the BMW 5 Series?

How to Install a Car ETC?

ETC device installation process is as follows: Upon receiving the device, first check if the ETC card and electronic tag (OBU) are damaged. Press the anti-tamper button on the back of the OBU. The red light will briefly illuminate, and the OLED screen will display "Tag Invalid" or "Please Insert Card," indicating the device is functioning normally. Clean the front windshield, ensuring the glass surface is smooth, clean, and dry. Then peel off the protective film from the OBU adhesive and attach it to the installation location. Press firmly for 2-3 minutes to remove air bubbles. Insert the ETC card with the front facing the driver and the back facing the windshield, ensuring the chip is inserted into the OBU device. Where can ETC be installed: For small vehicles like cars and minivans, the OBU device should be installed on the upper middle part of the front windshield. For large vehicles like trucks and buses, the installation position is on the lower middle part. ETC installation requirements: The height should be no less than 1.2 meters and no more than 2.5 meters; the installation angle N should be between 30º and 90º (the angle between the electronic tag surface and the horizontal plane).

5

0

Share

How to Turn on the Heater in Volkswagen Lamando?

To turn on the heater in Volkswagen Lamando, rotate the air conditioning knob, which has blue and red indicators. Turn it to the left to the red mark and press it. There are three key points to note when using the heater: 1. Avoid turning on the heater immediately after starting the car: The hot air from the car's air conditioning relies on the heat generated by the engine. Wait for 3-5 minutes until the water temperature reaches normal levels before activating the heater. 2. Avoid turning on the A/C when using the heater: The A/C button controls the vehicle's compressor, which is primarily used in summer. In winter, the heater only requires the engine's coolant temperature to function effectively. 3. Avoid switching to external circulation immediately after turning on the heater: After activating the heater, switch the circulation mode to internal circulation to quickly raise the interior temperature. Once the desired temperature is reached, you can switch to external circulation as needed.

4

Share

Should the X-Trail's Vehicle Stability System Be Kept On Normally?

The X-Trail's vehicle stability system is enabled by default. The system monitors the vehicle's driving conditions through sensors. When the vehicle shows a tendency to skid during driving, the stability system applies braking to the corresponding wheels to prevent skidding. In situations where the vehicle needs to suddenly avoid an obstacle during an emergency turn, if the wheels lose traction and start to slip, the stability system intervenes by applying braking force to the skidding wheels, reducing the risk of rollover. Below is relevant information: 1. The vehicle stability system usually has a physical switch. It is recommended to keep the system enabled during normal driving, as it can help reduce the probability of traffic accidents to some extent. 2. When the vehicle is stuck in mud or sand, the ESP should be turned off. In such cases, the vehicle typically requires a sudden, strong application of throttle to provide sufficient power to escape. However, if the ESP is enabled, it will apply braking to the wheels, limiting the engine's RPM and making it more difficult for the vehicle to escape the predicament.

17

5

Share

How to Open the Car Fuel Tank Cap?

The following is an introduction to the methods of opening the car fuel tank cap: 1. Press-to-open type, which is the simplest method to open the fuel tank cap. When the vehicle is unlocked, the fuel tank cap can be opened by directly pressing it with your hand. When the vehicle is locked, the fuel tank cap cannot be opened. 2. Switch button type, where the fuel tank cap is controlled by a switch button inside the car. The location of this switch varies across different models. In some vehicles, the switch is located on the floor to the left of the driver's seat, while in others, it is designed as an electronic button placed on the door panel of the left front door or on the center console. The symbol for this is typically in the style of a fuel pump, and it can be found with a little attention. 3. Mechanical key type, which involves using a key to directly unlock the fuel tank cap. Alternatively, some cars have a press-type or directly openable outer cap, after which an inner cap needs to be opened with a key.

11

5

Share

What are the impacts of a damaged catalytic converter?

Here are the impacts caused by a damaged catalytic converter: 1. Excessive exhaust emissions: When the catalytic converter is clogged or fails, harmful gases such as CO, HC, and NOx are directly emitted, resulting in non-compliant exhaust emissions. 2. Increased fuel consumption: A clogged catalytic converter affects the normal operation of the oxygen sensor, which in turn affects the accuracy of the oxygen sensor signals received by the engine. This leads to inaccurate control of fuel injection, air intake, and ignition, naturally increasing fuel consumption. 3. Poor exhaust flow and reduced power: This is more noticeable in turbocharged models. When the catalytic converter is clogged, high-pressure exhaust flow is hindered, affecting air intake and causing a decrease in engine power. This results in reduced acceleration and a feeling of sluggishness while driving.

7

5

Share

Where is the Haval H6 radiator located?

Haval H6 radiator is located in the engine compartment, behind the intake grille, and connected to the coolant. The car radiator, also known as the heat exchanger, is the main component of the car cooling system; its function is to dissipate heat. The coolant absorbs heat in the water jacket, flows to the radiator to dissipate the heat, and then returns to the water jacket for circulation, achieving temperature regulation. It is an integral part of the car engine. Precautions for using the car radiator: 1. Wait until the engine has stopped working for a while before unscrewing the cap, otherwise there is a risk of being scalded by the coolant. 2. The added coolant must have the same specifications and parameters as the original coolant. 3. The amount added should neither exceed the MAX mark (upper limit) nor be lower than the MIN mark (lower limit).

20

0

Share

What is the fuel tank capacity of the BMW 5 Series?

How to Install a Car ETC?

How to Turn on the Heater in Volkswagen Lamando?

Should the X-Trail's Vehicle Stability System Be Kept On Normally?

How to Open the Car Fuel Tank Cap?

What are the impacts of a damaged catalytic converter?

Where is the Haval H6 radiator located?

Where are Lincoln cars manufactured?

Should I Service My New Car When the Time Comes but the Mileage Hasn't Been Reached?

Where is the Nissan X-Trail's cabin air filter located?

Can a New Car Without License Plates Drive on the Highway?