What is the fuel tank capacity of the BAIC E130?

2 Answers
VanBenjamin
07/23/25 7:59pm
The fuel tank capacity of the BAIC E130 is 56 liters. In terms of power, it is equipped with a 4A90M 1.3L inline four-cylinder gasoline engine, delivering a maximum horsepower of 99hp at 6000rpm and a peak torque of 12.8kgm at 4000rpm. Maintenance for the fuel tank is as follows: Drain accumulated water and sediment from the tank, and check for any oil leaks at the fuel pipe joints and switches. For fuel tank caps equipped with air valves and vapor valves, also ensure the vent holes are clear. The filter screen at the fuel filler neck should remain intact to prevent impurities from entering the tank during refueling and clogging the fuel lines. The sealing gasket on the fuel filler cap should also be in good condition to prevent fuel spillage while driving. To check the remaining fuel level, observe the fuel gauge on the right side of the instrument panel, marked with 'E' and 'F'. When the needle is near 'E', it indicates low fuel, while near 'F' means sufficient fuel. Methods to open the fuel tank: Mechanical key opening: Commonly found in rugged off-road vehicles, this method is rarely used in modern family cars. In-car switch method: The location of the in-car fuel tank switch varies by model. Remember to turn off the engine before refueling. Press-to-open method: The press-to-open fuel tank door is currently the most convenient method.
Was this review help?
1
4
Share
MaverickFitz
08/10/25 5:57pm
I remember when I drove the BAIC E130, it had a fuel tank capacity of 45 liters, which was quite thoughtfully designed. When driving around the city, a full tank could last over 500 kilometers, with an average fuel consumption of about 6L/100km, which was quite fuel-efficient. I usually prefer not to fill the tank completely, leaving about half a liter of space to avoid expansion in high temperatures. The fuel tank cap seal also needs regular checks to prevent dust from entering and affecting the fuel system. On long trips, I calculate the mileage and usually start looking for a gas station when the tank is about a quarter full. This car is sufficient for daily family use, and during maintenance, it's recommended to clean the fuel lines to prevent impurities from clogging the fuel injectors.
Was this review help?
1
2
Share
Expand All
More Forum Discussions

What car brand has the 'n' logo?

n logo is Beijing Hyundai. Below is more information about what car brand has the 'n' logo: 1. The car logo starting with 'n' is Hyundai Motor. Hyundai's logo is an oval with a slanted letter 'H' inside, where the oval represents the Earth, symbolizing Hyundai Motor's global business management on the world stage. 2. The letter 'H' is the first letter of Hyundai Motor Company's English name (HYUNDAI), and at the same time, 'H' represents the artistic image of two people shaking hands, symbolizing the trust and support between Hyundai Motor Company and its customers. 3. Additionally, Hyundai Motor's brand philosophy is based on its business philosophy, core values, and corporate vision.
2
5
Share

How to Use Windshield Washer Fluid in the Buick Excelle?

The method to use windshield washer fluid in the Buick Excelle is: pull the wiper control lever towards the driver to spray the washer fluid. The Buick Excelle is a 4-door, 5-seater compact sedan with exterior dimensions of 4609mm in length, 1798mm in width, and 1486mm in height, with a wheelbase of 2640mm. The Buick Excelle is equipped with a 1.3T turbocharged engine and a 6-speed automatic transmission, delivering a maximum power of 120 kW at 5500 rpm and a maximum torque of 230 Nm at 4400 rpm. It features front-wheel drive, with a MacPherson strut front suspension and a multi-link independent rear suspension.
4
4
Share

How to adjust the time on the classic GL8?

The method to adjust the time on the classic GL8 is: 1. Turn on the ignition to power the vehicle, there is a button at the lower left and lower right corners of the dashboard; 2. The left button is the selection key, press it once to adjust the hour, the right button is the adjustment key, press it once to increase a value; 3. Press the left button twice continuously to adjust the minutes, operate quickly when adjusting the time. The Buick GL8 is an MPV under the Buick brand, with body dimensions of: length 5256mm, width 1878mm, height 1776mm, wheelbase 3088mm, and minimum ground clearance of 144mm.
5
3
Share

Does the Toyota Camry have a one-button start?

The Toyota Camry features a one-button start system. Simply press the brake pedal and lightly press the one-button start button to ignite the engine. The Toyota Camry is a sedan under GAC Toyota, with body dimensions of 4885mm in length, 1840mm in width, and 1455mm in height, a wheelbase of 2825mm, a minimum ground clearance of 155mm, and a trunk capacity of 300 liters. It is equipped with a 2.0L naturally aspirated engine, delivering a maximum horsepower of 178PS, a maximum power of 131kW, and a maximum torque of 210Nm. The front suspension adopts a MacPherson strut structure, a mainstream suspension layout, with the lower control arm made of steel.
14
0
Share

What Causes the Malfunction of Mercedes-Benz 9-Speed Transmission?

Mercedes-Benz 9-speed transmission malfunctions can be attributed to the following reasons: Excessive Transmission Temperature: After high-intensity driving, the transmission temperature may rise abnormally, triggering the malfunction indicator light. In such cases, simply park the vehicle and allow the temperature to naturally decrease. Insufficient Transmission Fluid: When the transmission fluid is low, the malfunction indicator light will illuminate to alert the driver to replenish it promptly. Generally, transmission fluid should be replaced and topped up when the vehicle has traveled approximately 50,000-80,000 kilometers. Transmission Gear Slippage: If the malfunction light comes on due to transmission gear slippage, it is necessary to visit a repair shop or an authorized 4S dealership for professional inspection.
7
0
Share

What is the relationship between the transmission and the engine?

The relationship between the transmission and the engine is: the engine outputs power to the transmission, which controls the power and then transmits it to the car wheels. The functions of the transmission: 1. Change the transmission ratio to expand the variation range of driving wheel torque and speed, adapting to frequently changing driving conditions while keeping the engine working under favorable conditions; 2. Enable the car to reverse while keeping the engine rotation direction unchanged; 3. Use neutral gear to interrupt power transmission, allowing the engine to start, idle, and facilitating gear shifting or power output. The function of the engine is: to convert the thermal energy of gasoline into mechanical energy by expanding gas after combustion in a sealed cylinder, pushing the piston to do work.
2
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.