What is the fuel tank capacity of the 2020 Emgrand?

2 Answers
Lawson
09/08/25 3:13am
The fuel tank capacity of the 2020 Emgrand is 50 liters, and it requires 92-octane or higher unleaded gasoline. The Emgrand is a compact car under Geely Auto, and the fuel tank capacity for the entire Emgrand series is 51 liters, equipped with a manual transmission (MT). If the owner wants to know the remaining fuel level, they can observe the fuel gauge on the right side of the dashboard, which is marked with E and F. When the pointer is close to E, it indicates that the fuel is almost empty, and when it is near F, it means the fuel level is sufficient. Maintenance of the fuel tank is as follows: Drain accumulated water and sediment from the fuel tank, and check for any oil leakage at the fuel pipe joints and switches. For fuel tank caps equipped with air valves and steam valves, also check if the ventilation holes are clear. The filter screen at the fuel filler inlet should be kept intact to prevent impurities from entering the fuel tank during refueling, which could clog the fuel lines. The sealing gasket of the fuel filler cap should also be intact to prevent fuel from spilling out while driving.
Was this review help?
3
5
Share
LaChloe
09/20/25 2:04am
I've driven the 2020 Emgrand, which has a fuel tank capacity of 48 liters. This size is quite suitable for daily commuting, allowing a full tank to last around 500-600 kilometers. On highways, it's even more fuel-efficient, with a range of about 700 kilometers. The average fuel consumption is around 7 liters per 100 kilometers. The lightweight design doesn't add much weight, so it doesn't affect performance. When refueling, it's recommended to choose reputable gas stations for better fuel quality to protect the engine. Don't wait until the fuel light comes on to refuel, as this can damage the fuel pump. Before long trips, filling up the tank and carrying a small fuel can for emergencies is a good idea, but ensure it's stored safely. Regularly check the fuel tank cap's seal to prevent evaporation and waste. The Emgrand's fuel tank capacity is standard for compact sedans, balancing practicality and economy, and it's easy to maintain.
Was this review help?
14
1
Share
Expand All
More Forum Discussions

Is an Insurance Policy Required for Annual Vehicle Inspection?

An insurance policy is required for annual vehicle inspection. In regions where electronic insurance policies are implemented, there is no need to carry a paper policy as the inspection agency can verify the electronic insurance policy of the vehicle. Requirements for vehicle annual inspection: Before the inspection, ensure the vehicle's braking performance is in good condition, and replace the brake pads if necessary. The braking performance is one of the most critical indicators of vehicle safety and is a mandatory check during the inspection. Prior to the inspection, the braking system should be thoroughly checked. Brake fluid and brake pads are two key areas to focus on. Dirty brake fluid or high moisture content can result in soft braking, while excessively worn brake pads can lead to reduced braking force and unusual noises. After inspection, perform necessary maintenance on relevant parts to ensure the vehicle passes the inspection smoothly. Regulations related to vehicle annual inspection: Before applying, the vehicle owner must resolve all traffic violations and accidents involving the vehicle. When applying, the owner must fill out an application form and submit the vehicle registration certificate, compulsory traffic accident liability insurance certificate, vehicle and vessel tax payment or exemption proof, and the vehicle safety technical inspection certificate.
14
4
Share

Where is the rearview mirror heating switch for the Roewe RX5 Plus?

The rearview mirror heating switch for the Roewe RX5 Plus is located in the button area below the central control screen. Control key for the rearview mirror heating function: The control key is a rotatable button with three positions corresponding to L, O, and R. There is a pattern of rising heat at the bottom. Rotate the button to this position to activate the rearview mirror heating function. This function helps keep the rearview mirrors clear when they fog up after rain, allowing the driver to indirectly see the rear and surrounding conditions clearly. It acts as a second pair of eyes, expanding the driver's field of vision and improving driving safety. Some cars have a knob on the driver's side door that adjusts the angles of the left and right rearview mirrors. Turning the knob to the left adjusts the left mirror, and turning it to the right adjusts the right mirror. When the knob is in the middle position, it activates the rearview mirror heating function automatically. Therefore, it is important to turn the knob to the left or right to prevent the heating function from staying on continuously, which could affect the lifespan of the heater. Notes: Not all cars are equipped with a rearview mirror heating function, so check whether your vehicle has this feature. Before using the rearview mirror heating, ensure the vehicle is in the ignition-on state or turn the key to the ON position to power the function. Importantly, do not use this function when the car battery is low on charge or malfunctioning. When the exterior rearview mirror heating is on, avoid touching the mirror surface.
2
3
Share

What Causes Transmission Fluid to Turn Yellow?

Transmission fluid, also known as gear oil, may turn yellow after some time of use due to the presence of worn metal particles and high temperatures. This is a normal phenomenon. The functions of transmission fluid are as follows: Reduce friction and wear, control clutch friction and synchronizer performance. Bear loads (low speed with high torque, vibration loads), dissipate heat, reduce vibration and noise, and remove contaminants from gear meshing areas (cleaning function). Prevent corrosion, pitting, and surface metal tearing, isolate metal surfaces to prevent direct contact between metal parts. The methods for changing transmission fluid are as follows: Drain the fluid by loosening the drain plug at the bottom of the transmission and then refill it. Remove the transmission oil pan directly to drain and refill the fluid: This method is more thorough than the previous one, as it removes impurities from the bottom of the oil pan. Use a circulation machine to change automatic transmission fluid: Dynamic fluid exchange with an intelligent circulation machine can filter and clean sludge and impurities inside the automatic transmission.
1
1
Share

Why does the fuel gauge of a new car fluctuate up and down?

The main reason for the inaccurate fuel gauge is an issue with the fuel level sensor. Composition of the fuel gauge: Pointer-type fuel gauges are divided into combined and separate types. Combined gauges are more common in sit-in motorcycles, consisting of a fuel gauge combined with a tachometer, odometer, water temperature gauge, charging ammeter, etc., forming a large instrument cluster. Separate fuel gauges, on the other hand, consist of a single fuel gauge and are more common in retro-style and cruiser motorcycles. Working principle of the fuel gauge: When the current from the battery XG flows through coils L1, L2, and L3, the magnetic fields generated by these three coils exert force on the disc-shaped permanent magnet of the pointer-type gauge head. The magnetic field directions generated by coils L1 and L3 are perpendicular to the magnetic field direction generated by coil L2.
11
1
Share

Do modified headlights need to be registered with the DMV?

Modified headlights need to be registered with the DMV. Consequences of not registering modified headlights: If not approved by the traffic management department in advance, vehicles with modified headlights cannot be driven on the road or pass the annual inspection normally. According to the relevant provisions of the current "Motor Vehicle Registration Regulations," any changes to the body color, model, performance, purpose, or structure of a licensed motor vehicle, as well as replacing the frame, body, or engine, must be reported to the DMV for modification registration. Installing spoilers, extensive body kits, or modifying exhaust pipes are generally not allowed. Precautions for modifying headlights: The low beam must not be less than 1050 lumens, and the high beam must not be less than 1450 lumens. The light intensity of the vehicle in motion must not be less than 15,000 CD and not more than 120,000 CD. The color temperature must not exceed 6000K; otherwise, the annual inspection equipment cannot detect the light. Currently, owners who have correctly modified their headlights still cannot pass vehicle inspections in most cities nationwide.
13
2
Share

Why does the Tianjian have unstable idle speed?

Severe engine carbon deposits, excessive dirt accumulation in the throttle body and intake passages, spark plug failure, fuel pressure issues, and various component failures can all contribute to this problem. Stalling caused by excessive carbon deposits: Carbon deposits typically accumulate in the throttle body, spark plugs, cylinders, fuel lines, and intake passages. These are coke-like substances formed when fuel is exposed to high temperatures. They are difficult to remove through ordinary physical methods and require specialized cleaning agents for removal. Poor fuel quality and clogged fuel injectors: Using low-quality fuel not only increases carbon deposits but may also clog fuel injectors, resulting in poor atomization. Additionally, inferior fuel directly affects combustion efficiency, increasing fuel consumption. Incomplete combustion produces carbon monoxide, which can accumulate inside the vehicle and potentially lead to fatal poisoning.
8
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.