What is the fuel tank capacity of the 2017 Nissan Qashqai in liters?

1 Answers
VonHazel
07/29/25 2:19pm
This model has a fuel tank capacity of 65L. Below is more information about fuel tank capacity: Introduction: Fuel tank capacity refers to the size measurement of a vehicle's ability to hold fuel. The fuel tank capacity determines the driving range. For two cars with identical engines, the one with a larger fuel tank can travel farther. Notes: Car owners often judge the fuel tank capacity based on when the fuel warning light comes on, but this method is not entirely accurate. Generally, due to various factors such as road conditions and driving conditions, the remaining fuel capacity when the warning light flashes may not be the same each time. For example, when the fuel level is close to the warning point, actions like high-speed driving, turning, going uphill or downhill, emergency braking, and strong vibrations can trigger the warning light. Additionally, road conditions affect mileage and fuel consumption. In congested traffic with slow speeds and frequent braking and acceleration, fuel consumption tends to be higher. The warning light can only provide a rough estimate of the fuel tank capacity and should not be considered the sole standard.
Was this review help?
7
0
Share
More Forum Discussions

Where to check tire pressure for Mercedes-Benz E300?

For the Mercedes-Benz E300, tire pressure information can be viewed in the tire pressure check module located in the center of the dashboard. According to the international GBT2978-2008 standard, the recommended tire pressure for standard tires is 2.4-2.5bar. In winter, the tire pressure should be slightly increased by about 0.2bar based on the standard tire pressure. In summer, the tire pressure can generally be about 0.1bar lower than the standard to prevent tire blowouts due to high temperatures. There are generally three reasons for abnormal tire pressure: Tire pressure abnormality: The system will alert if the pressure is generally below 1.8bar or above 3.0bar. In this case, tire inspection and pressure adjustment are required. Tire pressure monitoring not reset: After inflating the tires, if the tire pressure monitoring system is not reset in time, it will still record the previous data, causing the tire pressure monitoring indicator to light up. Simply performing a tire pressure reset will resolve this issue. Damaged tire pressure sensor: The tire pressure sensor, which is directly installed inside the tire and connected to the tire inflation valve, monitors tire pressure. If the sensor is damaged due to impact while driving, it will also trigger the tire pressure warning light. For sensor damage, the only solution is to replace it with a new one.
2
4
Share

What documents are required for reissuing a vehicle license?

The documents required for reissuing a vehicle license are: 1. Business process record form for motor vehicle registration; 2. Application form for replacement and reissuance of vehicle license plates and certificates; 3. Motor vehicle registration certificate; 4. Copy of the vehicle owner's identity proof; 5. Three vehicle photos; 6. Power of attorney and the identity proof of the authorized person. To apply for the replacement or reissuance of a driver's license, all traffic violations associated with the license must be resolved before the application can proceed. After submitting the relevant information successfully, the vehicle management office staff will process the application within one working day. For those who have already applied for replacement or reissuance, the specific progress can be checked by clicking on the progress inquiry. The motor vehicle license is the legal document that permits a motor vehicle to drive on roads within China.
6
4
Share

What does the triangle exclamation mark in a car mean?

Car triangle exclamation mark light indicates: 1. Transmission clutch overheating; 2. Fuel cut-off system intervention or malfunction; 3. Parking sensor failure; 4. Faulty exterior light bulb; 5. Engine oil pressure sensor malfunction; 6. Traction control system failure. Other indicator lights in a car include: tire pressure indicator, lighting fault indicator, steering system fault indicator, brake system warning light, transmission fault indicator, and windshield wiper fault indicator. When a dashboard warning light with an exclamation mark illuminates, it indicates an abnormality or malfunction in the corresponding part of the vehicle. This should not be taken lightly, and the source of the fault should be identified and addressed as soon as possible.
20
3
Share

How to Open the Hood?

Opening the hood involves the following steps: 1. Pull the hood release lever located at the lower left corner of the driver's compartment; 2. Lift the hood and then release the latch. The functions of the hood include: 1. Airflow guidance; 2. Protection for the engine and surrounding pipeline fittings; 3. Assisting driving vision by effectively adjusting the direction of reflected light; 4. Preventing accidents; 5. Isolating heat generated during engine operation. If the hood is stuck and cannot be opened, try these methods: 1. Lubricate the hood latch spring; 2. Use a tool to hook open the hood, or insert a wire from under the vehicle's engine into the hood lock hole to pull it open.
12
1
Share

What is the replacement cycle for a car battery?

The replacement cycle for a car battery is approximately 2 to 3 years. Symptoms of a damaged battery include: 1. Insufficient power; 2. Difficulty starting the car; 3. Remote key sometimes malfunctions; 4. Dashboard warning lights turn on; 5. Central control failure; 6. Engine not charging; 7. Car horn not working; 8. Headlights dimming. The functions of a car battery are: 1. Providing power to the starting system, ignition system, and electronic fuel injection system; 2. Acting as a voltage stabilizer for the entire vehicle's electrical system; 3. Assisting in power supply to electrical devices when the generator's output is insufficient. A car battery, also known as a storage battery, can be categorized into: 1. Conventional battery; 2. Dry-charged lead-acid battery; 3. Maintenance-free battery.
20
5
Share

How to Use Rearview Mirrors When Driving in an S-Curve?

The method for using rearview mirrors when driving in an S-curve is: 1. When the left front edge of the car aligns with the right line of the S-curve, turn the steering wheel one full turn to the left; 2. From the left rearview mirror, ensure the distance between the car body and the left line is maintained at approximately 30cm; 3. At the curve junction, straighten the steering wheel and then check the right rearview mirror, keeping the car body about 30cm from the right line. Car rearview mirrors are divided into: 1. Left-side rearview mirror; 2. Right-side rearview mirror; 3. Central rearview mirror. Car rearview mirrors are important safety components, and their function is to allow the driver to indirectly see the conditions behind, beside, and below the car, thereby expanding the driver's field of vision.
12
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.