What is the fuel tank capacity of the 2016 Geely King Kong?

1 Answers
ValerieRose
07/30/25 4:13am
The 2016 Geely King Kong has a total of 50 models, all with a fuel tank capacity of 45 liters. The vehicle is equipped with either a 1.5L or 1.8L naturally aspirated engine, paired with either a 5-speed manual transmission or a 4-speed automatic transmission. During the actual refueling process, the amount of fuel may exceed the calibrated volume. This is because the fuel tank capacity specified by the car manufacturer is measured from the bottom of the tank to the safe fill level. There is additional space from the safe fill level to the tank opening, which is designed to allow for fuel expansion due to temperature increases without causing overflow. If fuel is filled up to the tank opening during refueling, the actual amount of fuel added may exceed the calibrated tank capacity. To check the remaining fuel level, drivers can observe the fuel gauge on the right side of the instrument panel, which is marked with 'E' and 'F'. When the needle is near 'E', it indicates low fuel, and when it is close to 'F', it means the fuel level is sufficient.
Was this review help?
8
5
Share
More Forum Discussions

Where is the fuse box located in the Wuling Hongguang S?

The fuse box of the Wuling Hongguang S is located under the hood, on the left side of the battery in the engine compartment. The fuse box is used to house the car's fuses. Taking the Wuling Zhiguang 2020 model as an example, its body dimensions are: length 3797mm, width 1510mm, height 1820mm, with a wheelbase of 2500mm and a fuel tank capacity of 38 liters. The Wuling Zhiguang 2020 is equipped with a 1.2L naturally aspirated engine, delivering a maximum power of 56kW and a maximum torque of 108Nm, paired with a 5-speed manual transmission. It features a MacPherson strut front suspension and a longitudinal leaf spring rear suspension.
14
5
Share

What are the reasons for a manual transmission car not moving when in gear?

Manual transmission cars may not move when in gear due to: 1. Transmission solenoid valve malfunction; 2. Brake clutch pressure leakage; 3. Mechanical failure; 4. Sensor or ECU issues. The correct starting method for manual transmission cars is: 1. Fully depress the clutch pedal with your left foot; 2. Shift the gear lever into first gear; 3. Turn on the left turn signal and honk to alert vehicles and pedestrians ahead and behind; 4. Release the handbrake and gently lift the clutch with your left foot; 5. Lightly press the accelerator with the ball of your right foot. The correct starting method for automatic transmission cars is: 1. Start the engine, depress the foot brake and shift into D gear; 2. Release the handbrake and foot brake, then press the accelerator to start.
4
2
Share

What are the effects of excessive engine oil on the engine?

Excessive engine oil can have the following effects on the engine: 1. Increased oil consumption; 2. Reduced engine power; 3. Accelerated carbon deposit formation, damaging certain engine components; 4. Potential oil leakage from the crankshaft oil seal and shortened oil service life. Methods to address overfilled engine oil include: 1. Draining excess oil by removing the oil drain plug; 2. Using an oil pump to extract the excess. The primary functions of engine oil are: 1. To separate and lubricate moving parts, reducing component wear; 2. To carry heat back to the oil pan for dissipation into the air, assisting the radiator in cooling the engine; 3. To circulate and remove carbon deposits, sludge, and metal particles from engine components back to the oil pan, keeping the working surfaces clean.
3
3
Share

What does the pin definition of the car OBD diagnostic interface mean?

The pin definition of the car OBD diagnostic interface refers to the On-Board Diagnostics system, which monitors the vehicle's exhaust emissions in real-time during engine operation. If the emissions exceed the standard, the system will immediately issue a warning. The functions of the car OBD are: 1. It can automatically monitor the operating status of the engine; 2. It can diagnose the working conditions of other components in the car. When a fault occurs in any system of the car, the fault light will trigger an alarm. The detection devices of the car OBD mainly include: the engine, catalytic converter, particulate filter, oxygen sensor, emission control system, and fuel system.
19
1
Share

Where is the brake in an automatic transmission car?

In an automatic transmission car, the brake is located below the driver's side console. The left pedal is the brake. The principle of car braking is: using the friction between the brake pads and the brake disc, as well as between the tires and the ground, to generate tremendous friction, converting the vehicle's kinetic energy into heat energy through friction, and stopping the rotating parts by friction. An automatic transmission car refers to a vehicle where the driver does not need to manually shift gears; the car automatically selects the appropriate gear based on the driving speed and traffic conditions. The gears in an automatic transmission are: 1. P (Park) for parking; 2. R (Reverse) for reversing; 3. N (Neutral) for neutral; 4. D (Drive) for driving forward; 5. S (Sport) for sport mode; 6. L (Low) for low gear.
20
4
Share

Can a Car Engine Be Washed with Water?

Can a car engine be washed with water? The precautions are: 1. The engine must be cleaned while it is running; 2. Avoid prolonged washing of any single engine component; 3. Immediately after cleaning, use a high-pressure air gun to dry it thoroughly to prevent water from entering the engine wiring harness connectors, which could cause vehicle malfunctions. An engine is a machine that converts other forms of energy into mechanical energy, suitable for power generation devices. The maintenance methods include: 1. Regularly change the engine oil and oil filter; 2. Keep the crankcase well-ventilated; 3. Periodically clean the fuel system; 4. Regularly clean the radiator; 5. Periodically clean the crankcase.
16
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.