What is the fuel tank capacity of the 2015 CR-V in liters?

What are the detailed differences between the 6-seater and 7-seater versions of the Touareg?

The differences between the 6-seater and 7-seater versions of the Touareg are as follows: 1. Insurance premium: The general vehicle classification for passenger cars by insurance companies is: passenger vehicles with 6 seats or fewer, and passenger vehicles with 6-10 seats. Different vehicle categories are subject to different rate standards. Therefore, in terms of insurance, 5-seater and 6-seater/7-seater vehicles fall into two different categories, using different base rates. The difference between 6-seater and 7-seater lies in the purchase of seat insurance. 2. Annual inspection differences: According to annual inspection regulations, 6-seater vehicles (inclusive) enjoy exemption from inspection for the first 6 years, while 7-seater vehicles with more than 6 seats do not have this exemption privilege and need to undergo regular annual inspections, with inspections every two years within the first 6 years. After 6 years, all vehicle models are subject to annual inspections.

5

3

Share

Why is the keyless entry not working on the Buick Regal?

Buick Regal keyless entry not working reasons are as follows: 1. Fault diagnosis: After GDS detection, there is a fault code B3119 in the keyless entry control module, indicating that keyless entry antenna 1 has high voltage or is open circuit. The reasons for this fault code include corresponding circuit breakage or open circuit, antenna damage, keyless entry module failure, etc. Press the switch on the left front door handle and observe this data with GOS as inactive (it should normally show active). Press the switch on the left rear door handle, and this data shows as active and normal. 2. Working principle: When the door handle button or trunk touchpad is pressed, the low-frequency antenna sends a verification command to the keyless entry transmitter. Due to the low frequency, the communication range is limited. The antenna will send the verification command within a 1m range, and the transmitter must be within this range to receive the verification command. The transmitter receives this verification command and sends a radio frequency response message, which will be received by the remote door lock receiver. If the response is correct, entry to the vehicle is allowed.

1

3

Share

What is the fuel consumption of the Jianghuai Refine M5?

Refine M5's MIIT comprehensive fuel consumption is 8.2-12.3L/100km. The vehicle is equipped with a new 2.0T engine and a 6-speed dual-clutch transmission system. Since fuel consumption is related to driving habits, vehicle load, and road conditions, an actual fuel consumption fluctuation of around 10% is normal. Changes after the Refine M5 facelift: 1. Exterior: The facelifted Refine M5 only underwent minor adjustments to its exterior, adopting a new front face design. The front grille is now wrapped in large chrome decorations, with reduced line definition, making the entire front face smoother and more refined. 2. Styling: The lower part of the front bumper and the fog light assembly have also been adjusted accordingly. At the rear, the 2019 Refine M5's tail lights have been changed from the original red-and-white style to an all-red design, giving it a more fashionable look. The rear of the vehicle also features the latest JAC brand logo.

12

2

Share

What is the purpose of a novice looking at the rearview mirror?

For novice drivers, the purpose of looking at the rearview mirror is to judge the distance of the vehicle behind by observing changes in positional relationships and distances. Below are specific introductions to the functions of car rearview mirrors: Observing road conditions: While driving, the driver can observe the road conditions on both sides through the rearview mirrors to perform operations such as lane changes and overtaking. Reference points: During operations like parallel parking or reversing into a parking space, reference points can be identified using the rearview mirrors. Judging the distance to the vehicle behind: Pay special attention to the central rearview mirror. The distance to the vehicle behind can be judged through the central rearview mirror. When the front wheels of the vehicle behind are just visible in the central rearview mirror, the distance is approximately 13 meters. When the grille is visible, the distance is about 6 meters. When the grille is just no longer visible, the distance is approximately 4 meters.

18

1

Share

What Causes the Lag in Camry's Rearview Camera?

The reason is the failure of the vehicle's infotainment module, where internal interference causes lag, which is a system malfunction. Below is relevant information about the rearview camera: 1. Definition: The rearview camera, also known as the parking assist system, or reverse visual system, vehicle monitoring system, etc., is widely used in various large, medium, and small vehicles for reversing or driving safety assistance. 2. Technologies Used: Professional vehicle-mounted probes have further improved anti-magnetic, anti-shock, waterproof, and dustproof performance. The vehicle-mounted display uses TFT true color, with anti-magnetic treatment to eliminate signal interference and flicker. It can simultaneously receive two video signals, play VCDs and DVDs without a decoder, and features automatic horizontal switching and automatic on/off functions for the rearview camera.

9

3

Share

Is the 'bang' sound when pulling the handbrake a sign of breakage?

This sound occurs when the brake pads are stuck to the brake discs. Lightly tapping the brakes a few times after starting the car will resolve it. Sometimes, this situation also arises when driving the next day after washing the car and leaving it parked without use. Below are specific details about the handbrake: 1. Handbrake: The handbrake operates on the lever principle, using a steel cable to activate the rear wheel braking mechanism. The key components are the locking tooth and gear, which automatically engage with each other. 2. Pulling the handbrake (braking the rear wheels): When the handle is pulled up, the tooth automatically springs up to catch the next gear, while the connected steel cable gradually tightens, thereby applying the rear wheel brake pads. 3. Releasing the handbrake (releasing the rear wheels): When the handle button is pressed, the tooth and gear separate. Pressing down the handle at this point releases the tensioned steel cable, thus disengaging the rear wheel brakes.

4

5

Share

What is the fuel tank capacity of the 2015 CR-V in liters?

What are the detailed differences between the 6-seater and 7-seater versions of the Touareg?

Why is the keyless entry not working on the Buick Regal?

What is the fuel consumption of the Jianghuai Refine M5?

What is the purpose of a novice looking at the rearview mirror?

What Causes the Lag in Camry's Rearview Camera?

Is the 'bang' sound when pulling the handbrake a sign of breakage?

Where is the emergency trunk release switch for the Sportage?

What are the lucky numbers for car license plates?

Where is the manufacturer's label of BAIC Huansu located?

What Causes the Nissan Teana to Lack Power When Climbing Hills?