What is the fuel tank capacity of the 2014 Geely Emgrand?

1 Answers
DamianAnn
07/29/25 1:46pm
Geely Emgrand 2014 has a total of 10 models, all with a fuel tank capacity of 50 liters. The vehicle is equipped with a 1.5L naturally aspirated engine, paired with either a 5-speed manual transmission or a CVT transmission. During actual refueling, the amount of fuel may exceed the calibrated volume. This is because the fuel tank capacity marked by the car manufacturer is measured from the bottom of the tank to the safe fill level, and there is still some space from the safe fill level to the tank opening. This space is reserved to allow for fuel expansion when the temperature rises, preventing overflow from the tank. If fuel is filled up to the tank opening during refueling, the actual amount of fuel added may exceed the calibrated tank capacity. To check the remaining fuel level, the driver can observe the fuel gauge on the right side of the instrument panel, which is marked with 'E' and 'F'. When the needle is close to 'E', it indicates that the fuel is almost empty, while when it is near 'F', it means the fuel level is sufficient.
Was this review help?
12
4
Share
More Forum Discussions

What Causes Loud Noise from Car Radiator Fan?

It may be related to the fan belt or the balance of the fan blades, or possibly due to a dirty radiator causing poor heat dissipation, which affects the air intake volume. This leads to the electric fan increasing its rotation speed, resulting in increased wind noise. This issue does not affect daily use. It is recommended to clean the radiator and fan blades, and check if the fan's mounting screws are loose. Below is an introduction to the electric fan: 1. Composition: The electric fan is designed to prevent the engine coolant temperature from becoming too high. It consists of a sensor, electric fan, chip, etc. 2. Function: When the coolant temperature generally exceeds 90 degrees, the sensor activates, and the electric fan turns on to lower the coolant temperature. In winter, when temperatures are lower and the coolant temperature is also lower, the electric fan usually does not operate, protecting the engine from working in excessively cold or hot conditions.
9
4
Share

What is the working principle of the power steering system?

The power steering system of a car can be roughly divided into two categories: hydraulic and electric. The working principle of the Electro-Hydraulic Power Steering (EHPS) system is the same as that of the traditional mechanical hydraulic power steering system, using the power generated by the electric motor to assist the driver in steering. The following is a related introduction to the power steering system: 1. Principle: The Electro-Hydraulic Power Steering (EHPS) system adds the function of an electric steering pump, and the start and stop of the electric pump are controlled by the ECU. When no steering action is performed, the electric steering pump is turned off, unlike the mechanical hydraulic power steering pump, which is always connected to the engine through a belt. 2. Composition: The Electric Power Steering (EPS) system consists of a torque sensor, a control unit (ECU), a power motor, and a mechanical steering gear.
1
5
Share

What to Do When a Car Won't Start?

Each attempt to start the car should not exceed 5 seconds. If the car doesn't start within 5 seconds, release the key and try again. Avoid holding the key in the start position continuously if the car fails to start. If the car doesn't start after three consecutive attempts, it's advisable to wait for half a minute before trying again. This is because the starting current is very high and can potentially damage the starter and wiring, as well as cause excessive instantaneous discharge from the battery, shortening its lifespan. Waiting for half a minute allows the battery to recover some charge. Here are additional details: Solutions: Check the starting system. The starting system's circuit generally includes the following basic components: the battery, the starter motor, and the cables connecting these parts. Additionally, the ignition switch, starter relay, solenoid coil, and the vehicle's anti-theft system are also crucial parts of the starting system.
17
1
Share

Who is the inventor of the internal combustion engine?

The inventor of the internal combustion engine is Karl Benz. Below is a detailed introduction to automotive internal combustion engines: 1. Overview: An internal combustion engine is a type of power machinery that converts the heat energy released by burning fuel directly into mechanical energy. Broadly speaking, internal combustion engines include not only reciprocating piston engines, rotary piston engines, and free-piston engines but also rotary turbine jet engines. However, the term 'internal combustion engine' typically refers to piston-type internal combustion engines. 2. Principle: A piston-type internal combustion engine mixes fuel and air, which is then burned inside the cylinder, releasing heat energy that generates high-temperature, high-pressure gas. The expansion of this gas drives the piston to perform work, and the mechanical energy is then output through a crankshaft linkage or other mechanisms to drive machinery. Common types include diesel and gasoline engines, which convert internal energy into mechanical energy by performing work to alter internal energy.
7
0
Share

What is the operating method for starting an automatic transmission car?

Automatic transmission car starting operation method is: 1. Insert the key after getting in the car, turn the key to the second gear power position for ignition, and wait for the system self-check to complete; 2. Shift the gear lever from P gear to N gear; 3. Release the brake and start the car's engine; 4. Step on the brake with your foot, shift the gear lever from N gear to D gear, release the brake and step on the accelerator to start. The driving method for automatic transmission cars is: 1. Start slowly by stepping on the accelerator, engage P gear or N gear when starting, and avoid coasting in neutral; 2. Shift back to N gear when waiting at traffic lights or during brief stops, and engage P gear when parking; 3. Do not shift into P gear while driving; 4. Ensure the vehicle is completely stopped before shifting into R gear for reversing.
15
4
Share

How to Avoid Crossing the Line in Subject Two Curve Driving?

When navigating an S-curve, there's a handy trick to remember: "Left point aligns with right line, right point aligns with left line." The left and right points refer to the front corners of the car's hood. This means when turning in a particular direction, you should use that corner of the hood to follow the opposite side's road edge line. Here's some information about Subject Two: 1. Definition: Subject Two, also known as the small road test, is part of the motor vehicle driver's license assessment and refers to the field driving skill examination. 2. Objectives: Master the basic essentials of driving operations and acquire fundamental vehicle control skills; proficiently grasp basic methods for field and road driving, develop the ability to reasonably use vehicle controls and correctly manage the vehicle's spatial position, and accurately control the vehicle's position, speed, and path.
17
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.