···
Log in / Register

What is the fuel consumption per kilometer for the BYD F3?

6Answers
GiannaLee
08/31/2025, 10:57:13 PM

BYD F3 mainly has 5 models, with the lowest fuel consumption ranging between 6.25L/100km6.7L/100km, and the highest fuel consumption ranging between 7.83L/100km8.61L/100km. Additional information is as follows: BYD F3: Biggest advantages: High cost-performance ratio; spacious interior; stylish and fashionable exterior; high-end models are richly equipped. Biggest disadvantages: Many minor issues such as abnormal noises, oil leaks, water ingress in headlights, inaccurate fuel gauge, abnormal water temperature, etc.; poor overall assembly quality with thin paint and large gaps. The exterior is stylish and elegant, the interior design is simple and generous with a fresh light color scheme, and the configuration is comprehensive and abundant. High-end models' leather seats and rear parking radar are well-received by users. The air conditioning performs well, but the craftsmanship and materials are average, with noticeable gaps in some areas.

Was this review help?
116
Share
LeBrianna
09/13/2025, 01:52:32 AM

As a long-time owner of the BYD F3, I find its fuel consumption per kilometer quite reassuring. On average, it consumes about 6 to 8 liters per 100 kilometers, which translates to approximately 0.06 to 0.08 liters per kilometer, though this varies by driver. In city driving, especially during morning rush hour traffic, fuel consumption tends to be higher, while it drops significantly on highways. Driving habits play a crucial role—gentle acceleration and less braking can help reduce fuel usage. Regular maintenance is also essential; a dirty air filter or underinflated tires can increase consumption. Colder weather slightly raises fuel use as the engine warms up slower. Overall, the BYD F3 is economical, but paying attention to these small details can save you money on fuel and extend your car's lifespan.

Was this review help?
7
Share
Expand All
MaverickFitz
10/27/2025, 02:37:57 AM

As a car tech enthusiast, analyzing the BYD F3's fuel consumption starts with its engine. It's equipped with a 1.5L naturally aspirated engine designed for balanced fuel combustion efficiency, maintaining an average fuel consumption of around 7L per 100km, equivalent to approximately 0.07L per kilometer. The electronic control unit optimizes fuel injection timing, though frequent starts in city driving can slightly increase consumption. Aerodynamics affect wind resistance, while regular oil changes and spark plug checks help maintain low consumption. Significant tire tread wear can increase resistance, leading to a 5% rise in fuel usage. From my tests, gentle driving can reduce consumption to 6.5L. These technical details make the F3 a cost-effective compact car, and with some mechanical knowledge, you can perform maintenance yourself to save money.

Was this review help?
2
Share
Expand All
OLydia
12/10/2025, 01:53:42 AM

Having driven a BYD F3 for several years, my primary concern is fuel efficiency to save costs. It consumes about 7 liters per 100 kilometers, roughly 0.07 liters per kilometer. At current fuel prices, that's approximately a bit over 0.5 yuan per kilometer. Driving habits significantly affect expenses; for instance, frequent short trips and sudden braking can increase consumption to 8 liters per 100 km. I plan routes to avoid traffic jams and use cruise control on highways. Older cars tend to consume more fuel, and after three years, some parts may need replacement. A money-saving tip is to travel light and avoid overloading the trunk, as heavier loads increase fuel consumption. Monthly checks of oil levels help detect leaks early, preventing unnecessary expenses.

Was this review help?
6
Share
Expand All
DelTucker
01/30/2026, 03:04:50 AM

From an environmental perspective, the BYD F3 consumes approximately 0.07 liters of fuel per kilometer, which has a relatively smaller impact on the environment. As an owner, I strive to minimize emissions—every 0.1-liter reduction in fuel consumption means less carbon emitted. The car is designed for efficiency, though fuel consumption rises to 8 liters per 100 kilometers when using air conditioning in summer or carrying more passengers. I make it a habit to avoid rapid acceleration, opting for smooth driving to save fuel and reduce environmental impact. External factors like high-altitude areas slightly increase fuel consumption due to reduced engine efficiency. While choosing electric or hybrid vehicles is a long-term solution, the F3's low fuel consumption serves as a practical compromise. Green driving not only saves on personal fuel costs but also helps reduce pollution, benefiting the community.

Was this review help?
13
Share
Expand All
LeMadison
04/25/2026, 02:06:37 PM

I'm quite familiar with the BYD F3, which is renowned for its affordability and practicality, averaging around 7 liters of fuel per 100 kilometers, equivalent to 0.07 liters per kilometer. According to feedback from car owners, urban driving consumes slightly more fuel, approximately 8 liters, while highway driving reduces it to 6 liters. The lightweight engine design contributes significantly, but fluctuating road conditions like mountain roads increase fuel consumption. Seasonal variations affect it too; insufficient warm-up in winter can raise fuel consumption by 5%. During the break-in period of a new car, gentle driving within the first 2,000 kilometers can optimize long-term fuel efficiency. Overall, the F3's fuel consumption is considered budget-friendly, suitable for cost-conscious users, but a test drive is recommended to assess real costs based on personal driving habits.

Was this review help?
13
Share
Expand All
More Q&A

What Causes the Engine Warning Light to Illuminate in a Jaguar XEL?

The engine warning light may illuminate due to the following 7 main reasons: Sensor malfunction: This includes sensors such as coolant temperature, crankshaft position, air flow, intake temperature, and oxygen sensors. When these sensors are damaged, have poor contact, or signal interruption occurs, the vehicle's ECU cannot accurately obtain engine data, triggering the engine warning light. Fuel/oil quality issues: Failure to use the fuel and engine oil as specified by the manufacturer may cause engine wear, leading to the warning light activation. Poor fuel mixture combustion: Incomplete combustion can cause engine carbon buildup or knocking. When detected by the oxygen sensor and reported to the ECU, the warning light will illuminate as an alert. Spark plug failure, ignition coil malfunction, fuel pump issues, or fuel line blockages can all result in poor combustion. Turbocharging problems: Issues with the intake boost piping or turbocharger can also trigger the engine light. The most common is turbocharger damage, often accompanied by oil leaks, excessive oil consumption, reduced power, metallic noises, or blue/black smoke from the exhaust. Intake problems: Air intake issues may lead to engine pipe blockages, potentially causing the warning light to activate. A dirty or uncleaned air filter can restrict proper airflow. Exhaust system faults: Exhaust problems can trigger the engine light. Common causes include rear oxygen sensor failure, catalytic converter issues, or exhaust camshaft and bearing failures. Using leaded gasoline, improper lubricant additives, physical damage to the catalytic converter, or fuel system malfunctions may damage this component. Anti-theft system malfunction: If the vehicle's electronic anti-theft system fails or doesn't properly communicate with the engine control unit, it may prevent normal engine operation while illuminating the warning light. When the engine warning light appears, follow these steps: First check if the engine operates normally - observe for vibrations, black smoke, etc. If present, avoid restarting the engine. Note: Never restart if the light is red. If the engine starts normally, turn off the vehicle for 5-10 minutes. Without pressing the brake pedal, press the start button once or turn the key halfway to the ON position (without engaging the clutch). The system will perform a self-check - observe if the warning light turns off after 5-10 seconds. If the light remains on, visit a service center immediately. Technicians can use diagnostic tools to retrieve trouble codes and perform targeted repairs.
116
Share

Is There Any Impact from Switching from 95 Octane to 92 Octane Fuel Long-Term?

Switching from 95 octane to 92 octane fuel long-term does have an impact. Occasionally using the wrong gasoline grade only requires switching back to the correct grade after consumption, but long-term use of the wrong gasoline grade can lead to the following effects: For vehicles designed for lower octane fuel, using higher octane fuel will not cause damage, but the increase in octane rating alters the fuel's ignition point, leading to delayed combustion in the engine. This results in reduced engine power and thermal efficiency, with the practical experience being poorer performance. For vehicles designed for higher octane fuel, using lower octane fuel can cause engine knocking. Because the octane rating is significantly lower, the reduced ignition point causes premature ignition during the compression stroke. If combustion occurs before the spark plug fires, resistance is created during the upward stroke. This resistance makes the engine run very unevenly. If the knocking is imperceptible, it only increases noise without significant engine damage. However, noticeable knocking indicates severe engine conditions, affecting not only driving stability but also causing abnormal wear on pistons and cylinders, and in severe cases, cylinder scoring. In addition to checking the appropriate gasoline grade in the vehicle's manual, you can also find it on the fuel tank cap. Generally, the gasoline grade can also be determined based on the engine's compression ratio. Vehicles with a compression ratio between 8.6-9.9 should use 92 octane fuel, while those with a compression ratio between 10.0-11.5 should use 95 octane fuel. However, with the use of new technologies, the compression ratio alone cannot determine the required gasoline grade. High compression ratio engines can be tuned to use lower octane fuel because other factors, such as ignition timing, turbocharging technology, and Atkinson cycle technology, also play a role. Generally, the higher the gasoline grade, the higher the octane rating and the better the anti-knock performance. 92 octane gasoline contains 92% isooctane and 8% n-heptane, while 95 octane gasoline contains 95% isooctane and 5% n-heptane.
108
Share

What are the hidden functions of the 2011 Teana key?

The hidden functions of the 2011 Teana key include closing the windows after turning off the engine, finding the car in a parking lot, automatically opening the trunk, and remotely opening the windows. Relevant information about the Teana is as follows: 1. Exterior Design: The 2021 Teana newly introduced red-black and white-black dual-color exteriors. Except for the entry-level 2.0L model, all models are equipped with 17-inch or larger wheels, LED headlights, and LED daytime running lights. Additionally, the model also launched the Phantom Edition package, which includes blackened rear emblems, chrome front grille trim, wheels, rear spoiler, Midnight personalized rear emblem, and other unique exterior accessories. 2. Interior Design: The 2021 Teana upgrade features piano-black door trim panels, wood-grain center console and gear lever box, and exquisite soft material wrapping to enhance the cabin's luxury feel. Moreover, the Phantom Edition package also includes luxury LED welcome pedals and exclusive floor mats. 3. Powertrain: The 2021 Teana offers a 2.0L naturally aspirated engine and a 2.0T turbocharged engine, paired with the new intelligent XTRONIC-CVT continuously variable transmission equivalent to an 8AT gear range. The 2.0T model is equipped with the VC-TURBO variable compression ratio turbocharged engine, which allows the engine compression ratio to intelligently and continuously switch between 8:1 (high performance) and 14:1 (high efficiency). The 2021 Teana can accelerate from 0 to 100 km/h in just 6.42 seconds, with a minimum fuel consumption of 6.6L per 100 km.
119
Share

Should the car be started when charging a phone inside?

Starting the car is necessary when charging a phone inside. Here are the precautions for starting a car: 1. Check the surroundings of the vehicle: Walk around the car to inspect its exterior and the environment, ensuring there are no obstacles in front or behind the car. Check the ground where the car is parked for any suspicious oil stains or water stains, verify if the front and rear light assemblies are damaged, and ensure the tire pressure is adequate. 2. Inspect the internal condition of the car: Check if the engine oil and coolant levels are sufficient, and if the front and rear lights, signal lights, and dashboard are functioning properly. The main focus is to examine the technical condition inside the car. Lift the engine hood, pull out the dipstick to check if the oil level is normal, and unscrew the radiator cap to verify if the water level is normal.
112
Share

What is the method to reset the maintenance light on Changan Suzuki?

Turn on the ignition switch, briefly press the right-side information display selection handle until the information display screen goes black and then stops. Press and hold the left-side mileage button for more than 5 seconds until the oil lock display appears on the screen, then release the button. The display area will show the oil lock. Release the button and press it five times consecutively within 2 seconds, completing the action within 3 seconds. The oil lock will turn off, indicating the operation is complete.
115
Share

Why does the car key not respond when locking the car?

If the car key does not respond when locking the car, it may be due to a malfunction of the remote lock or aging of the remote transmitter antenna in the vehicle, which prevents the remote key from working properly. Another possible cause is strong magnetic signal interference around the car. Here are some precautions for car keys: 1. Do not place it near electronic devices: Since smart keys use low-intensity radio waves, they may not function properly under magnetic interference. Frequently placing the smart car key together with a mobile phone can lead to malfunction, as the chip inside the smart key may sometimes be affected by the phone's frequency, temporarily disabling the remote function. Additionally, if the smart key receives high-intensity radio waves, it may excessively drain the battery. Therefore, avoid placing the smart key near electronic devices such as TVs or personal computers. 2. Avoid rough handling: Smart keys are most vulnerable to being dropped from a height. While the outer shell of most smart keys is sturdy, the internal circuitry is less resistant to impact and can easily be damaged by severe collisions. Furthermore, if water enters the smart car key, it can burn out the internal circuitry, also causing remote failure. If the smart car key gets wet, do not shake it vigorously, as this can cause water to spread to other critical circuits. Also, avoid using the remote to unlock the car immediately, as this may damage the circuit board. 3. Use the correct battery: The battery life of a smart car key is approximately one year. Battery consumption varies depending on the frequency and distance of key usage. Replacing the battery of a smart car key requires caution, as any mistake can damage the circuit board inside the key. Before replacement, the owner should carefully review the battery replacement diagram. When disassembling the key, pay attention to the original positions of all components and try to use an original battery. During installation, ensure the correct orientation of the battery's positive and negative terminals to avoid incorrect placement. Additionally, be careful with the sealing ring at the bottom of the key to prevent damage during replacement, which could otherwise burn out the circuit board.
120
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.