What is the fuel consumption of Volkswagen Bora?

1 Answers
SanDaniel
07/29/25 7:06pm
The official fuel consumption given by Volkswagen Bora is 5.5L/100km. According to data provided by car owners, the average fuel consumption of the Bora 1.4T model is around 7L/100km, with a range of 6~8L/100km. The average fuel consumption of the 1.5L model is around 7.5L/100km, with a range of 6~8L/100km. Here are some issues to pay attention to when fuel consumption is high: 1. Check whether the tire pressure is sufficient, the degree of tire wear, and whether new tires need to be replaced to enhance friction and reduce fuel consumption. 2. Check the braking system and whether the clutch is slipping. 3. Check whether the spark plugs need to be replaced. Damaged spark plugs will reduce ignition energy and slow down the car's acceleration. 4. Check whether the engine has too much carbon deposits and pay attention to cleaning the carbon deposits.
Was this review help?
7
0
Share
More Forum Discussions

Where is the trunk switch of Cadillac XT4?

Cadillac XT4's trunk switch is located below the driver's door, press the button to open the trunk. The luggage compartment volume is 447-1334 liters (depending on the tilt degree of rear seats). Other ways to open Cadillac XT4's trunk: Use the car key to open the trunk. Press and hold the trunk unlock button on the key, the trunk will automatically open after a few seconds; Press the unlock button to unlock the doors, then pull the trunk opening button below the license plate frame to open the trunk. Ensure the trunk is properly closed before driving, as the trunk may suddenly open if not engaged properly even when door locks are activated, which poses a safety hazard during driving. Moreover, when the trunk lid is open, it may cause exhaust fumes to enter the vehicle, affecting the health of passengers.
4
4
Share

How to Tell if the Gear is Properly Engaged in a Manual Transmission?

Methods to determine if the gear is properly engaged in a manual transmission: The car's dashboard will display the current gear position, and it may provide warnings if there is a gear mismatch. Additionally, you can check the car's tachometer to confirm, as the gear position and speed are directly proportional. If the car is in a high gear at low speed or a low gear at high speed, the tachometer will show abnormal readings. Generally, during normal operation, a car's engine speed should be between 2000 and 3000 RPM, though this range may vary for different vehicles. A manual transmission, also known as a manual gearbox, requires the driver to manually shift gears by moving the gear lever to change the gear engagement inside the transmission, thereby altering the gear ratio to achieve speed variation. Its working principle involves using the shift fork to change the transmission ratio (gear ratio) of the meshing gears, thereby adjusting the driving torque to suit different operating conditions.
2
5
Share

Do manual transmission cars have cruise control?

Manual transmission cars do have cruise control. Cruise control refers to automatically maintaining the vehicle speed without pressing the accelerator pedal, allowing the car to travel at a fixed speed. The usage method of cruise control is: 1. When the speed is above 40 km/h, press the CCS button on the left side of the steering wheel to activate it; 2. Use the RES and SET buttons to fine-tune the speed for acceleration or deceleration; 3. Step on the brake or press the CCS button on the left side of the steering wheel to deactivate it. The principle of cruise control is: The cruise control component reads the pulse signal from the speed sensor and compares it with the set speed, then issues commands to the servo mechanism to adjust the throttle opening degree (increase or decrease) so that the vehicle always maintains the set speed.
18
2
Share

What does maintreqd mean as a fault?

maintreqd indicates the maintenance warning light. maintreqd is the abbreviation for Maintenance Required, which serves as a reminder for the driver to perform vehicle maintenance and is not a fault. Solution: Disconnect the negative terminal of the battery for 20 seconds. (When disconnecting the battery, all electrical devices must be turned off; otherwise, it may cause the radio to lock.) Use an automotive computer diagnostic tool to reset the maintenance light. More details are as follows: 1. Vehicle maintenance refers to the periodic inspection, cleaning, replenishment, lubrication, adjustment, or replacement of certain parts as preventive work, also known as vehicle servicing. 2. Modern vehicle maintenance mainly includes the maintenance of the engine system, transmission system, air conditioning system, cooling system, fuel system, power steering system, etc. 3. The purpose of vehicle maintenance is to keep the vehicle clean, ensure normal technical conditions, eliminate potential hazards, prevent faults, slow down the deterioration process, and extend the service life.
4
4
Share

What engine does the SWM G05 use?

SWM G05 uses a 2.0L naturally aspirated engine and a 1.5T turbocharged engine. The 2.0L engine has a maximum power of 105kW and a maximum torque of 190Nm; the 1.5T engine has a maximum power of 115kW and a maximum torque of 230Nm. The SWM G05 is the second SUV product born under SWM Motors' G platform. In terms of appearance, the new car draws design elements from the SWM G01. In terms of details, the designers used many sharp lines on its body, especially the large front grille, combined with the headlight assembly shaped by geometric broken lines, creating a very imposing visual effect. The body dimensions of the SWM G05 are 4750mm in length, 1860mm in width, and 1780mm in height, with a wheelbase of 2750mm.
14
4
Share

Where is the Mondeo's radiator located?

The Mondeo's radiator is positioned at the front of the engine compartment. The car radiator generally refers to the heat exchanger. As part of the vehicle's cooling system, the radiator in an engine water-cooling system consists of three main components: the inlet chamber, outlet chamber, main plate, and radiator core. Below are the radiator maintenance procedures: 1. Park the vehicle securely and turn off the engine. After the coolant temperature drops, open the expansion tank and add radiator cleaner; 2. Start the engine and let it idle for 5-10 minutes after the cooling fan activates; 3. Turn off the engine and remove the front bumper. During disassembly, ensure all fastening screws are loosened, then carefully detach from both ends toward the center to avoid breaking mounting clips; 4. After confirming the coolant has completely cooled, drain the radiator cleaner along with the coolant, then refill with fresh engine coolant.
3
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.