What is the fuel consumption of the Toyota Vios?

Where is the ETC device installed?

For small cars, the ETC device is generally installed in the upper middle part of the front windshield, while for large vehicles such as trucks and buses, the installation position is in the lower middle part. The appropriate installation position should be no lower than 1.2 meters and no higher than 2.5 meters, with an installation angle between 30 and 90 degrees. For vehicles with anti-explosion film or those that have had anti-explosion film applied later, it may affect the signal transmission of the microwave communication link, and the device should be installed in the microwave skylight zone. ETC stands for Electronic-Toll-Collection, which means electronic toll collection system. To apply for ETC, you need to provide the original and photocopies of the vehicle owner's valid ID card and vehicle registration certificate. If the application is not made by the owner, the agent must also bring their valid ID card. The photocopy of the vehicle registration certificate should include the page with the most recent annual inspection stamp. Additionally, a bank card for deducting highway tolls is required, and the vehicle must be registered under the name of an individual aged between 18 and 60. Below are some precautions for installing ETC: Do not obstruct the view; it is best to install it behind the rearview mirror: Many car models have a large inclination angle of the windshield, which can reduce the driver's field of vision. If this is not considered during ETC installation, it can increase the driver's blind spots. Installing it behind the rearview mirror on the right side can help avoid obstructing the view. Do not interfere with charging: The ETC electronic tag consumes power but generally does not require charging or battery replacement because it has a solar panel on the back that can charge itself. Therefore, during installation, avoid the black areas on the windshield and positions that may block the solar panel. Do not remove it arbitrarily once installed: The button in the middle of the adhesive is an anti-removal lever connected to a switch. After the electronic tag is installed, the windshield will press the anti-removal lever in. If the tag is removed arbitrarily, the lever will pop out and trigger the switch, locking the electronic tag and rendering it unusable. In such cases, you will need to visit an ETC service point to unlock it. This mechanism is designed to prevent multiple vehicles from sharing one device. When using ETC, note the following: The ETC transaction sensing range is 8 meters. To prevent the ETC device of the vehicle in front from malfunctioning, maintain a distance of more than 10 meters from the vehicle in front to avoid automatic payment for the front vehicle. The ETC lane recognition speed is 20 kilometers per hour. Driving too fast may result in failure to read the vehicle device information, leading to payment failure. When using a debit card linked to ETC, insufficient balance may also cause payment failure.

8

3

Share

What to Do When the Inspection Validity Period on the Duplicate of the Vehicle License Expires?

The owner of a motor vehicle with an expired inspection period on the vehicle license can apply for an inspection compliance mark at the vehicle management office of the registration location. The steps for application are as follows: 1. Before applying, the vehicle owner should resolve all road traffic safety violations and accidents related to the vehicle. 2. When applying, the vehicle owner should fill out the application form and submit the vehicle license, compulsory traffic accident liability insurance certificate, vehicle and vessel tax payment or exemption certificate, and motor vehicle safety technical inspection compliance certificate. 3. The vehicle management office should, within one day from the date of acceptance, confirm the motor vehicle, review the submitted certificates and vouchers, and issue the inspection compliance mark.

11

2

Share

Where is the tire pressure sensor located?

Tire pressure monitoring sensors can be divided into internal and external types based on their installation location. Internal sensors are installed inside the tire, which is relatively more stable and provides more accurate temperature monitoring data. External tire pressure monitoring sensors are installed on the tire, usually at the valve stem position. There are three common methods of tire pressure monitoring: Direct tire pressure monitoring: Direct tire pressure monitoring devices use pressure sensors installed in each tire to directly measure the tire pressure. The pressure information is transmitted from inside the tire to a central receiver module via a wireless transmitter, and then the tire pressure data is displayed. The system automatically alerts when the tire pressure is too low or there is a leak. Indirect tire pressure monitoring: When the pressure of a tire decreases, the vehicle's weight causes the rolling radius of that wheel to become smaller, resulting in a faster rotation speed compared to other wheels. By comparing the differences in rotation speeds between tires, the system monitors tire pressure. Indirect tire pressure alert systems essentially rely on calculating the rolling radius of the tires to monitor pressure. Introduction to Tire Pressure Monitoring System (TPMS): It combines the advantages of both systems mentioned above. Direct sensors are installed in two diagonally opposite tires, and a 4-wheel indirect system is also equipped. Compared to using only a direct system, this hybrid system can reduce costs and overcome the limitation of indirect systems, which cannot detect simultaneous low pressure in multiple tires. However, it still cannot provide real-time data on the actual pressure in all four tires as a direct system does.

20

3

Share

What does 'parallel' mean in parallel imported vehicles?

The meaning of 'parallel' in parallel imported vehicles should be: the same level, without any subordinate relationship. Parallel imported vehicles, the full name is parallel trade imported vehicles, referred to as parallel trade vehicles. More information about parallel imported vehicles is as follows: 1. Parallel imported vehicles refer to cars purchased by traders from overseas markets and introduced into the Chinese market for sale without the authorization of the brand manufacturer. Due to different import locations, they can be divided into 'American specification vehicles', 'Middle East version vehicles', 'Canadian version vehicles', 'European version vehicles', etc., to distinguish them from 'Chinese specification vehicles' sold through authorized channels. 2. The so-called 'parallel import' is relative to the concept of 'Chinese specification vehicles', referring to imports directly from the product's origin by other importers besides the general distributor, with the import channel being 'parallel' to the domestic authorized distribution channel.

13

3

Share

Why does the car start but won't move?

The reasons why a car starts but won't move are: Check if the handbrake is engaged. If it is, release it and shift gears again; Check if the car has stalled, which may indicate a transmission failure; Worn clutch plate: Needs replacement. Severe wear of the clutch plate causes loss of friction, making it unable to transmit the engine's power to the transmission, thus failing to establish effective power transmission; Low battery or expired battery life. A weak battery with insufficient power cannot drive the starter motor, resulting in insufficient motor speed. A dead battery is easy to check—just press the horn. It is recommended to replace the battery every 2 years. If you are unfamiliar with the operation when the car starts but won't move, it's best to seek rescue services for a jump-start, such as from a 4S shop, gas station, or insurance company. Free jump-start rescue services are often available during the car insurance coverage period. The reasons why a car won't start are: Dead battery; Spark plugs failing to ignite; Faulty starting circuit; Malfunction in the car's ignition system or fuel supply system; Starter motor not operating; Mechanical lock of the steering wheel stuck; Frozen exhaust pipe; Valves gummed up. Car ignition system: For a spark-ignition engine to operate normally, it must supply the spark plugs with sufficiently high-energy high-voltage electricity (approximately 15,000 to 30,000V) in the correct firing order for each cylinder, enabling the spark plugs to produce a strong enough spark to ignite the combustible mixture. Traditional ignition: The working process of a mechanical ignition system involves the crankshaft driving the distributor shaft to rotate. The cam on the distributor shaft turns, causing the primary contacts of the ignition coil to open and close, thereby generating high voltage.

19

0

Share

What is the Difference Between 6-Seater and 7-Seater Cars?

1. Number of Seats: The interior space of 6-seater and 7-seater cars is generally similar, with the main difference being the number of seats. A 6-seater car typically adopts a 2+2+2 seating layout, while a 7-seater car usually has a 2+3+2 layout. The 7-seater has one additional seat in the middle row compared to the 6-seater, but the rear seats are often more cramped. 2. Vehicle Inspection Frequency: According to the 'Regulations for the Implementation of the Road Traffic Safety Law', small passenger vehicles with 7 seats or more are required to undergo inspection every two years, while those with 6 seats or fewer are exempt from inspection for the first six years. 3. Insurance Premiums: Insurance companies classify small passenger vehicles based on the number of seats, such as those with up to 6 seats, 6-10 seats, and 11-20 seats. The premium varies depending on the number of seats, with higher seat counts generally leading to higher insurance costs.

15

2

Share

What is the fuel consumption of the Toyota Vios?

Where is the ETC device installed?

What to Do When the Inspection Validity Period on the Duplicate of the Vehicle License Expires?

Where is the tire pressure sensor located?

What does 'parallel' mean in parallel imported vehicles?

Why does the car start but won't move?

What is the Difference Between 6-Seater and 7-Seater Cars?

What are the reasons for a car displaying ESC malfunction and being unable to start?

What license plate is required for hybrid vehicles?

Where is the air conditioning intake of the Haima S5 located?

What colors are available for the Audi Q2L?