What is the fuel consumption of the Toyota Prado?

1 Answers
LeEmmanuel
07/29/25 7:34pm
The fuel consumption of the Toyota Prado is approximately 11.0-12.8L. Different driving styles may result in different fuel consumption. Here is some related information about the Toyota Prado: 1. The Toyota Prado is an off-road vehicle launched by Toyota, and it is one of the models in the Toyota Land Cruiser series. 2. In terms of power, this vehicle is equipped with a 3.5L naturally aspirated engine, with a maximum power of 206kw and a maximum torque of 365 Nm. The transmission is matched with a 6-speed automatic manual transmission. This engine is the latest six-cylinder EFI 1GR-FEV6 engine developed by Toyota. 3. The Prado is an improved version of the Land Cruiser 70 and 90 series. This vehicle evolved from the 70 series passenger-cargo vehicle to the 90 series Prado. 4. The engine in the Prado adopts technologies such as 24 valves and the VVT-i intelligent variable valve timing system, etc. The overall power level has improved compared to the previous generation engine, and the low and consistent working noise is also quite satisfactory.
Was this review help?
1
0
Share
More Forum Discussions

What Causes the Noise When Pressing the Clutch Pedal?

The reasons for noise when pressing the clutch pedal are: 1. The clutch pedal return spring is too soft, detached, or broken; 2. The release bearing is damaged; 3. The release bearing return spring is loose or broken; 4. The driven plate damping spring is loose or broken; 5. Excessive clearance between the driven plate spline hole and the shaft; 6. The driven plate steel sheet is broken, shattered, or the rivet heads are exposed. The solutions for noise when pressing the clutch pedal are: 1. Remove the pedal, inspect, and apply grease; 2. Remove the slave cylinder push rod and manually push/pull the release fork to check flexibility; 3. Check if the pedal is deformed; 4. Inspect the pipeline between the slave cylinder and the air tank for blockages or leaks; 5. Replace the return spring and release bearing; 6. Check if the driven plate damping spring is loose or broken.
13
5
Share

How many points will be deducted for occasionally driving at 160 km/h on the highway?

If you drive at 160 km/h in a 120 km/h speed limit zone, which is 33% over the speed limit, according to the new traffic regulations, the penalty is a deduction of 6 points. Here is some extended information: Laws and regulations: Highways should clearly mark the speed limits for each lane. The maximum speed should not exceed 120 km/h, and the minimum speed should not be lower than 60 km/h. On highways, the maximum speed for small passenger vehicles should not exceed 120 km/h, while other motor vehicles should not exceed 100 km/h. Lane speed limits: For roads with two lanes in the same direction, the minimum speed for the left lane is 100 km/h. For roads with three or more lanes in the same direction, the minimum speed for the leftmost lane is 110 km/h, and the minimum speed for the middle lane is 90 km/h.
13
1
Share

Which country produces Mitsuoka Motors?

Mitsuoka Motors is produced by Japan. Here is more information about Mitsuoka Motors: 1. The Mitsuoka Galue 4.5 resembles a classic car, with its thick and classical front end highlighting the noble temperament of a duke. However, when viewed from the side, its overall curves exhibit more of the smooth lines of a modern sedan. The rear design echoes the front, featuring narrow strip-shaped taillights and a massive chrome bumper. 2. The Mitsuoka Galue 4.5 is equipped with a 4.5L V8 engine, delivering a maximum power of 253Kw, ensuring the dynamic performance of this luxury sedan with a net weight of 1.8 tons. 3. It comes with modern configurations such as a five-speed manual/automatic transmission, tire pressure monitor, DSC traction control system, airbags + side curtains, and a BOSE 7-channel audio system.
2
5
Share

How many amps is a 12V battery?

12V cannot be directly converted to milliamperes (mA). Volt (V) is a unit of voltage, while milliampere (mA) or ampere (A) is a unit of current. These units are not interchangeable. A battery is typically described by two parameters: voltage and capacity. Precautions for battery usage: Wait 15 seconds before reignition: If the vehicle fails to start on the first attempt, wait at least 15 seconds before trying again to prevent excessive battery discharge, which could affect performance and lifespan. When the vehicle is unused for over half a month: Remove the negative terminal clamp of the battery to prevent the vehicle's electrical system from draining the battery with residual current, which may result in failure to start upon reuse. Regular maintenance: Batteries that remain unused for extended periods may self-discharge, leading to power depletion. Therefore, batteries not in use should be regularly maintained and recharged to avoid performance degradation and lifespan reduction due to excessive discharge.
2
2
Share

What causes a car to sway left and right?

Car swaying left and right may be caused by abnormal tire pressure. The tire pressure values of the four tires should not differ too much, generally within 0.1 bar is normal. If the tire pressure values differ significantly, the uneven pressure will cause inconsistent energy absorption and shock absorption capabilities of the tires, leading to body shaking at high speeds. Below are the functions of car tires: Supporting the entire weight of the vehicle: Car tires support the full weight of the vehicle, bear the load of the car, and transmit forces and moments in other directions. Improving vehicle performance: Car tires transmit traction and braking torque to ensure good adhesion between the wheels and the road surface, enhancing the car's power, braking, and off-road capabilities; together with the car's suspension, they mitigate impacts during driving and dampen resulting vibrations. Preventing early damage to car components: Car tires protect car components from severe vibrations and early damage, adapt to the vehicle's high-speed performance, reduce driving noise, and ensure driving safety, handling stability, comfort, and fuel efficiency.
10
4
Share

How to Transfer an Out-of-Town Driver's License to Local?

The procedure for transferring a driver's license back to your local area requires that the license must have been held for at least one year before it can be transferred, and you will need to retake the third subject test. After preparing the necessary materials: original and photocopy of ID card, original and photocopy of driver's license, recent one-inch bareheaded photo, motor vehicle driver's license application form, and physical examination form (to be filled out and tested at the vehicle management office), follow the steps below at the processing window of the vehicle management office to get a number and queue: 1. First, check if there are any traffic violations on the driver's license. 2. Go to the corresponding window to request the application form. 3. Submit the application form, physical examination report, and related materials to the staff. 4. After the staff verifies and reviews, go to the cashier to pay the fees.
11
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.