What is the fuel consumption of the third-generation Haval H6 2.0T?

1 Answers
DelKai
07/29/25 8:10pm
The fuel consumption of the third-generation Haval H6 2.0T is 10.38 liters per 100 kilometers. Below are detailed introductions about it: 1. Body dimensions: The length, width, and height are 4653/1886/1730mm respectively, with a wheelbase of 2738mm, providing a more spacious interior. 2. Powertrain: Equipped with an upgraded 2.0GDITEVO engine, the engine has a maximum power of 124kw (169ps), a maximum torque of 285Nm, and an improved maximum torque range of 1400-3600rpm. High torque arrives earlier and lasts longer, with a thermal efficiency of up to 38%.
Was this review help?
19
3
Share
More Forum Discussions

What are the precautions for beginners driving on the highway?

Precautions for beginners driving on the highway: 1. Pay attention to traffic rules and display a novice driver sign; 2. First-time highway drivers should have an experienced driver accompany them; 3. Inspect the vehicle before entering the highway; 4. Be aware of speed limits, especially the minimum speed requirement; 5. Choose lanes wisely; 6. Overtake decisively on the highway; 7. Avoid following large vehicles and prevent them from following you; 8. Pay attention to road signs, markings, and warning signs; 9. Ensure safety during emergency stops or accidents; 10. When exiting the highway, merge into the outermost lane in advance. Many accidents occur due to last-minute lane changes caused by missing the exit.
2
4
Share

What should be paid attention to when driving on the highway for the first time?

First-time highway driving precautions: 1. Maintain distance - Safe following distance is the primary factor for driving safety. If you follow too closely and the preceding vehicle suddenly encounters an emergency, you won't have enough time to brake. 2. Speed limits - Highway speeds must not be lower than 60 km/h nor exceed 120 km/h. According to traffic regulations, driving below 60 km/h on highways will result in a 3-point penalty. 3. Avoid sharp steering - Always keep a firm grip on the steering wheel at high speeds. When changing lanes or overtaking, avoid large turning angles to prevent vehicle drift at high speeds. For braking, apply the brakes several times gradually rather than slamming them to prevent skidding. 4. If you miss an exit - If you fail to notice the exit warning signs and miss your highway exit, remain calm. Don't attempt to brake sharply or make a U-turn. Continue driving at speed and take the next exit to return to your original route.
5
5
Share

Can I replace just one tire after driving 30,000 kilometers?

Tires that have been driven for 30,000 kilometers may not necessarily be severely worn. If the wear is not significant, replacing just one tire is sufficient. Tires are circular elastic rubber products assembled on various vehicles or machinery for ground rolling. They are typically mounted on metal rims to support the vehicle body, absorb external shocks, maintain contact with the road surface, and ensure driving performance. Tires often operate under complex and demanding conditions, enduring various deformations, loads, forces, and temperature extremes during use. Therefore, they must possess high load-bearing capacity, traction performance, and cushioning ability.
1
1
Share

Is It Necessary to Repair Paint on a Bumper?

It is necessary to repair paint on a bumper. The steps for car paint repair are as follows: 1. Thoroughly clean the surface to be repaired before starting; 2. Use alcohol to remove wax, moisture, oil stains, and rust from the area to be repaired to enhance the adhesion of the paint film; 3. Shake the touch-up paint pen thoroughly before use; 4. Open the cap of the touch-up paint pen while keeping it upright; 5. Apply the touch-up paint directly to the damaged area. Once the paint film has dried, use 2000-grit sandpaper with water to sand the surface smooth until the paint level is even. The car's paint surface consists of four layers, from the inside out: the electrocoat layer, the primer layer, the base coat layer, and the clear coat layer. The clear coat is the most susceptible to damage, and most minor scratches typically remain on this layer. Scratches on the clear coat can be removed through polishing.
6
2
Share

What is the license plate prefix for Ziyang?

Ziyang's license plate prefix is Chuan M. The license plate prefixes for various regions in Sichuan are as follows: Chuan A and Chuan G for Chengdu, Chuan B for Mianyang, Chuan C for Zigong, Chuan D for Panzhihua, Chuan E for Luzhou, Chuan F for Deyang, Chuan H for Guangyuan, Chuan J for Suining, Chuan K for Neijiang, Chuan L for Leshan, Chuan Q for Yibin, Chuan R for Nanchong, Chuan S for Daxian, Chuan T for Ya'an, Chuan U for Aba, Chuan V for Ganzi, Chuan W for Liangshan, Chuan Y for Bazhong, and Chuan Z for Meishan. The first Chinese character on a car's license plate indicates the province or municipality where the vehicle is registered, while the second letter is an English letter representing the prefecture-level administrative region to which the vehicle belongs. The letter 'A' denotes the provincial capital or the central urban area of a municipality, while other letters are assigned based on the importance of the prefecture-level city within the province.
6
1
Share

Should the Arrizo 5 use 5w30 or 5w40 engine oil?

Both 5w30 and 5w40 engine oils are suitable for the Arrizo 5. Engine oil, also known as motor oil or engine lubricant, is a substance enhanced with additives in base oil, primarily containing anti-wear additives, detergents, dispersants, and multi-grade viscosity index improvers. The main functions of engine oil are to reduce friction and wear on moving parts, and to remove sludge (one of the functions of dispersants) and varnish (the function of detergents) from the engine. Taking the 2021 Arrizo 5 1.6L CNG Luxury model as an example: the manufacturer of this car is Chery Automobile, its class is compact car, and the energy type is gasoline.
8
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.