What is the fuel consumption of the Tang DM?

1 Answers
DeEmilia
07/30/25 1:03am
The fuel consumption of the Tang DM-i is 5.5L/100km. Below are its related introductions: Engine Introduction: The Tang DM-i adopts the same Xiaoyun-PHEV dedicated turbocharged 1.5Ti high-efficiency engine as the other two DM-i models, with a maximum power of 102kW (139 horsepower)/5200rpm and a maximum torque of 231Nm/1350rpm-4000rpm. Reasons for Energy Efficiency: The compression ratio reaches 12.5 in terms of craftsmanship, and the peak thermal efficiency is pushed to 40%. The motor as a whole has the advantages of small size and high efficiency: The presence of EHS allows the vehicle to achieve series, parallel, and engine direct drive modes, indirectly replacing the transmission. The addition of technologies such as a 16000rpm high-speed motor, flat wire winding, and oil-cooled heat dissipation gives the motor the advantages of small size and high efficiency.
Was this review help?
15
5
Share
More Forum Discussions

What does the ECON mode mean in Hyundai Verna?

ECON is the switch for the car's fuel-saving mode, which can be turned on or off with this button. Modern cars generally offer three driving modes to choose from: Eco mode, Comfort mode, and Sport mode. Below is information about these three modes: Eco mode: When the car is in this mode, fuel consumption is relatively low. The throttle pedal sensitivity decreases, and the transmission shifts up more aggressively. Comfort mode: This mode is considered a normal operating mode for the car. In this mode, the throttle pedal response is more sensitive than in Eco mode. Sport mode: This mode can be used during aggressive driving. When Sport mode is activated, the throttle pedal response becomes highly sensitive, and the transmission delays shifting. The transmission only upshifts when the engine speed reaches the redline. After switching to Sport mode, the engine speed is maintained at around 3,000 RPM, ensuring better power response during acceleration. When the car enters ECON mode, it achieves reduced fuel consumption and energy savings, but the car's power output weakens. ECON can be understood as an abbreviation for "economy." In most cases, it is recommended to keep ECON mode enabled. However, it must be turned off when high torque output is needed (e.g., when climbing a slope) or when driving at very high speeds. After pressing the ECON button, the car enters a low-carbon, eco-friendly driving mode. The ECU, engine, and transmission then operate intelligently in the most fuel-efficient manner to execute the driver's intentions, achieving optimal fuel economy through quick upshifts and smooth acceleration. When the driver presses the throttle pedal deeply, the ECON system effectively controls the opening and closing of the intake valves to ensure stable engine operation and energy savings. Although the ECON mode is simple and effective, it cannot operate under certain conditions: When the vehicle speed exceeds 120 km/h, priority is given to speed, and the fuel-saving mode automatically deactivates. This means that if the car exceeds the economical speed range (typically between 60-90 km/h), the ECON mode will not save fuel. The key to the ECON mode is its reliance on computer-controlled operation while the car is moving. Therefore, it does not function when the car is idling, parked, or in N, P, or manual mode. When the car needs to overcome significant resistance or output high torque—such as when climbing a slope—the ECU prioritizes ensuring sufficient power to drive the car, and the ECON mode will not work in such cases.
17
3
Share

Does the Arrizo 5 have navigation?

The Arrizo 5 comes with navigation. The Arrizo 5 is a compact sedan with body dimensions of 4572mm in length, 1825mm in width, and 1482mm in height. In terms of power, the Arrizo 5 is equipped with a 1.5L naturally aspirated engine, delivering a maximum power of 116 horsepower and a maximum torque of 141 Nm, paired with either a 5-speed manual transmission or a CVT continuously variable transmission. For suspension, the Arrizo 5 features a MacPherson strut independent front suspension and a torsion beam non-independent rear suspension combination. This setup provides good durability on bumpy roads, ensuring a comfortable ride for passengers.
20
1
Share

What are the reasons for a vehicle not consuming urea?

Vehicle not consuming urea may be due to the SCR system not functioning properly. Below are the hazards of not using urea: 1. Environmental pollution: Diesel vehicles without urea can have an extremely negative impact on the ecological environment, and this is also prohibited by national laws and regulations. 2. Damage to the SCR injection system: If urea is not used for a long time, the nozzles, pipelines, and urea pump in the SCR system may crystallize and clog, or be damaged by high temperatures. 3. Reduced power: This is not a direct result of not using vehicle urea, but rather because when the engine's electronic control system detects no urea injection and excessive exhaust pollution, it will forcibly limit the engine's torque output.
18
5
Share

Why can't the BMW audio system be unmuted?

BMW audio system cannot be unmuted due to incorrect wiring. Here is the relevant introduction: Pursuit: Car audio modification, as the name suggests, is the upgrade of the car's audio system, aiming to meet the car owner's demand for car music; to express the 'audiophile' pursuit of music lovers in the best possible sound field expression within the car's audio space. Specialty: Due to the uniqueness of music, car audio manufacturers produce different types of speakers for different music styles. Therefore, only by clearly knowing the music style you prefer can you choose the most suitable car audio system.
16
0
Share

What is the principle of dynamic balancing?

The principle of dynamic balancing is: A car's wheel is an assembly consisting of a tire and a rim. However, due to manufacturing variations, the mass distribution of this assembly cannot be perfectly uniform. When the car wheel rotates at high speed, it creates a dynamically unbalanced state. To prevent or correct this condition, weights are added to the wheel under dynamic conditions to adjust the balance at various edge points. Tire balancing is divided into two types: dynamic and static balancing. Dynamic imbalance causes wheel wobble, leading to scalloped tire wear, while static imbalance results in bouncing and hopping, often causing flat spots on the tire. Therefore, regular balancing checks not only extend tire life but also improve driving stability by preventing accidents caused by loss of control due to tire wobble or hopping at high speeds.
3
3
Share

Do car tires need to be replaced after running 100,000 kilometers in one year?

If car tires have run 100,000 kilometers in one year and are worn below the warning line, they need to be replaced; if they haven't reached the warning line yet, replacement isn't necessary. Tires are rubber products, and prolonged use leads to wear and aging, so regular replacement is required. Tire usage precautions: 1. Normally, the shelf life of tires is three years; 2. After installing new tires, it's essential to perform a dynamic balance test on each wheel to prevent abnormal vibrations; 3. Regularly check tire pressure during daily use; 4. If tire pressure is found to be inappropriate during use, adjust it immediately, as it can affect the car's handling and safety.
12
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.