What is the fuel consumption of the RAV4?

Can Transmission Noises Be Repaired?

Transmission noises can be repaired. Once an automatic transmission malfunctions, the vehicle owner should promptly send it for repair. If abnormal noises are ignored and the vehicle continues to be used, it may eventually lead to the vehicle not moving or even complete transmission failure. Therefore, once a transmission issue arises, it must be taken to a professional transmission repair facility immediately to avoid greater losses. The main causes of abnormal noises in an automatic transmission include: excessive wear of the oil pump or improper transmission fluid level (too low or too high), noise from the torque converter due to damaged lock-up clutch or one-way overrunning clutch in the guide wheel, noise from the planetary gear set, or noise from shift actuators. Solutions for transmission noises: Check the automatic transmission fluid level; if it is too high or too low, adjust it to the correct level. Use a lift to raise the vehicle, start the engine, and check the source of the noise in neutral, drive, reverse, and other gears. If there is continuous noise at the front of the transmission in all gears, it is usually due to the oil pump or torque converter. In such cases, the transmission should be disassembled for inspection. Check the oil pump for wear and the torque converter for excessive friction debris. Replace the oil pump or torque converter if abnormalities are found.

14

4

Share

What is the difference between SN and SP engine oil?

Differences in viscosity (phosphorus content); Different advantages. Below is the relevant introduction: Viscosity (phosphorus content): SN engine oil has relatively lower phosphorus content; and the viscosity of SP oil is slightly higher compared to SN. Different advantages: SP oil film is stronger than SN, providing better protective performance. Additionally, SP shows stable improvements over SN in terms of noise reduction, fuel consumption, and acceleration performance. Synthetic oil: Synthetic oil is manufactured by humans using chemical methods. Depending on the intended use, the composition of synthetic oil can be adjusted. The development of synthetic oil began in the 1930s. At that time, due to the demanding conditions of aircraft engine oil, which required higher performance, some chemical plants began to develop and produce synthetic oil.

12

3

Share

What Causes Loud Engine Noise During Acceleration?

Reasons for loud engine noise during acceleration: 1. Dirty air filter, old spark plugs, damaged ignition wires, or contaminated gasoline; 2. Issues with the fuel filter, carburetor, or fuel pump components; 3. Engine overheating, clogged exhaust system, or vacuum tube leakage; 4. Lack of power steering fluid, damaged generator bearings, or problems with the power steering pump and water pump. The engine is the device that provides power to the car, determining its power performance, fuel economy, stability, and environmental friendliness. Engines are categorized into diesel engines, gasoline engines, electric vehicle motors, and hybrid systems. The working principle of a gasoline engine is based on the four-stroke cycle.

14

1

Share

Should Fuel Additive Be Added Before or After Refueling?

It is more effective to add the fuel additive to the fuel tank before refueling. When the fuel level in the tank is low, adding the fuel additive and then refueling allows for better mixing of gasoline and the additive. Fuel additives, also known as gasoline additives, are primarily used to remove carbon deposits from the engine. However, some low-quality additives may not only fail to clean carbon deposits but could also damage the engine. The main function of fuel additives is to clean carbon deposits, which has always been their key product feature, along with additional benefits such as maintaining the engine and fuel system. Some specialized fuel additives can also improve the anti-knock properties (octane rating) of the fuel.

16

5

Share

What is the appropriate level to fill the coolant to?

Coolant should be filled to the midpoint between the upper mark (MAX) and the lower mark (MIN). Relevant information about coolant is as follows: Replacement cycle: The shelf life of automotive antifreeze is generally 2 years. Typically, ordinary household vehicles require antifreeze replacement every 2 years or after driving 40,000 kilometers. Introduction: Antifreeze, fully known as antifreeze coolant, refers to a coolant with antifreeze properties. It is a type of coolant containing special additives, primarily used in liquid-cooled engine cooling systems. Currently, over 95% of antifreeze used domestically and internationally is ethylene glycol-based aqueous antifreeze, characterized by a high boiling point, low volatility, moderate viscosity, minimal changes with temperature variations, and excellent thermal stability, making it an ideal coolant. The primary function of antifreeze is to remove excess heat from the engine cooling system while preventing the cooling water in the pipes from freezing and expanding in winter, which could lead to radiator damage.

14

3

Share

What is the 0-100 km/h acceleration time of the CFMoto 800MT?

The 0-100 km/h acceleration time of the CFMoto 800MT is 7 seconds. Here are some details about the CFMoto 800MT: Fuel consumption: Approximately 5 liters per 100 kilometers. For comparison, a typical 125cc household motorcycle consumes about 2.5 liters per 100 kilometers, while a 500cc motorcycle consumes around 4 liters. The CFMoto 800MT is a twin-cylinder, 800cc motorcycle with a fuel consumption of about 5 liters per 100 kilometers. In congested urban traffic conditions, this can increase to 6-7 liters, while on long-distance trips at a steady speed of 80-90 km/h, it can drop to around 4 liters. Power configuration: The CFMoto 800MT is equipped with a 799cc inline twin-cylinder liquid-cooled engine, delivering a maximum power of 70 kW (95 hp) at 9000 rpm and a maximum torque of 77 Nm at 6500 rpm.

6

3

Share

What is the fuel consumption of the RAV4?

Can Transmission Noises Be Repaired?

What is the difference between SN and SP engine oil?

What Causes Loud Engine Noise During Acceleration?

Should Fuel Additive Be Added Before or After Refueling?

What is the appropriate level to fill the coolant to?

What is the 0-100 km/h acceleration time of the CFMoto 800MT?

What is the difference between semi-synthetic and fully synthetic engine oil?

Are Methanol Vehicles Considered New Energy Vehicles?

What Causes the Engine Warning Light to Illuminate After Accelerating?

Will the vehicle be fined if it exceeds the inspection date?