What is the fuel consumption of the Honda XRV?

What is the difference between SN and SL engine oil?

Engine oil SL and SN refer to the quality grades of engine oil. The most obvious difference between SN and SL oil is the grade difference, which also corresponds to variations in various performance aspects of the oil. Below are the differences between SN and SL engine oil: 1. Differences in oxidation resistance and anti-wear performance under high-temperature and high-speed operating conditions: For example, in the same TEOST MHT high-temperature deposit test: The SN standard requires no more than 35 milligrams; SN oil has higher high-temperature cleanliness than SL, making it particularly suitable for turbocharged engines. SN-grade oil offers better oxidation stability and anti-wear performance. Since SN oil contains lower levels of phosphorus and zinc compared to SL oil, it reduces wear on the three-way catalyst. 2. Different environmental protection levels of the oil: In the quality grades, the further the letter is in the alphabet, the higher the environmental protection level. Therefore, SL oil has a lower environmental protection level than SN, and the highest environmental protection level is SP-grade oil. 3. Classification by quality level: SG, SH, SJ, SL, SM, SN, so SN has a higher quality than SL. 4. Difference in availability: The number of SL-grade oils available for sale is fewer than SN.

6

4

Share

Is the passing score for C1 Subject 2 80 or 90?

The passing score for the C1 driver's license Subject 2 test is 80 points, with a full score of 100, so 80 points or above is considered passing. The C1 Subject 2 test consists of five main sections: reverse parking, parallel parking, curve driving, right-angle turns, and hill start and stop. For automatic transmission (C2) Subject 2, the hill start and stop section is not tested, and in some regions, there is an additional high-speed card retrieval task. A C1 driver's license permits driving small and micro passenger vehicles, among others. Subject 2 Test Introduction and Tips: During the Subject 2 test, before driving, always adjust the seat height and rearview mirrors to ensure a clear field of vision, and fasten your seatbelt. As long as the system does not announce a failure, do not stop during the test. Parallel Parking: Park the car into the designated space without crossing or touching the lines. Tips: Remember to find the correct angle, turn the steering wheel quickly, react promptly, and coordinate with the car's speed. Hill Start: Slowly drive up the hill and stop within the designated area. Tips: Remember to engage the handbrake, turn on the left turn signal when starting, release the handbrake, stabilize the clutch, and gently press the accelerator while releasing the clutch to avoid stalling or rolling back. Right-Angle Turn: Prepare to turn 90 degrees while driving straight, without crossing or touching the lines. Tips: Identify the reference point before turning and coordinate with the car's speed. Curve Driving (S-Turn): Slowly navigate the S-curve without crossing or touching the lines. Tips: Control your speed, drive slowly, and time the turns of the car's front end correctly. Reverse Parking: Reverse the car into the parking space without stalling or crossing/touching the lines. Tips: Control your speed, find the correct reference point, and make minor adjustments if the rearview mirror shows any deviation. C1 License Test Passing Standards: Traffic Laws and Related Knowledge—90 points to pass. Field Driving—80 points to pass. Road Driving—80 points to pass. Subject 2 Deduction Items: Reverse Parking: Vehicle body crosses the line—100-point deduction, failing the test; fails to enter the parking space—100-point deduction, failing the test; stops midway—5-point deduction per occurrence; fails to complete the test within the allotted time—100-point deduction, failing the test. Parallel Parking: After parking, vehicle body crosses the line—100-point deduction, failing the test; stops midway—5-point deduction per occurrence; tires or body touches the curb—10-point deduction; fails to complete the test within the allotted time—100-point deduction, failing the test. Curve Driving: Wheels cross the road edge line—failing the test; stops midway—failing the test; fails to use second gear or higher—5-point deduction. Right-Angle Turn: Wheels cross the road edge line—failing the test; stops midway—5-point deduction per occurrence. Hill Start and Stop: After stopping, the front bumper or motorcycle front axle is not aligned with the pole line, exceeding 50 cm—failing the test. Exceeds the allotted time for starting—failing the test. After stopping, the front bumper or motorcycle front axle is not aligned with the pole line but does not exceed 50 cm—10-point deduction. After stopping, the vehicle body is more than 30 cm but less than 50 cm from the road edge line—10-point deduction. Fails to engage the parking brake after stopping—10-point deduction.

18

4

Share

What Should You Do When a Car Radiator Boils Over?

When encountering a high-temperature warning, you should first slow down. Then pull over to the side of the road, but do not rush to turn off the engine. After discovering the boiling over, do not shut off the engine immediately. Instead, maintain idle speed temporarily and try to cool it down.

6

5

Share

What are the reasons for the engine malfunction light in the Volkswagen Tharu?

The engine malfunction light in the Tharu may illuminate due to the following 7 main reasons: Sensor malfunction: This includes sensors such as coolant temperature, crankshaft position, air flow, intake temperature, and oxygen sensors. When these sensors are damaged, have poor contact, or experience signal interruption, the vehicle's ECU cannot accurately obtain engine data, triggering the malfunction light. Fuel quality issues: Failure to use the fuel and engine oil as specified by the manufacturer may cause engine wear, leading to the malfunction light. Poor combustion of the air-fuel mixture: This can result in engine carbon buildup or knocking. When detected by the oxygen sensor and reported to the ECU, the malfunction light will illuminate as a warning. Issues such as faulty spark plugs, ignition coils, fuel pump, or clogged fuel lines can cause poor combustion. Turbocharger problems: The intake boost pipe or turbocharger can also trigger the engine malfunction light. The most common issue is turbocharger damage, accompanied by symptoms like oil leaks, excessive oil consumption, reduced power, metallic noises, or blue/black smoke from the exhaust. Intake problems: If the vehicle's intake system is compromised, it may cause engine pipe blockages, and in severe cases, trigger the malfunction light. A dirty or uncleaned air filter can lead to intake issues. Exhaust problems: Exhaust system faults can also cause the engine malfunction light to illuminate. Common causes include faulty rear oxygen sensors, catalytic converters, exhaust camshafts, or bearings. The catalytic converter is the most frequent culprit, often damaged by leaded gasoline, lead/silicon-based lubricant additives, physical impacts, or fuel system issues. Anti-theft system malfunction: If the vehicle's electronic anti-theft system fails or the anti-theft controller does not match the engine ECU, the system may prevent the engine from operating normally, accompanied by the malfunction light. If the engine malfunction light illuminates, follow these steps: First, check if the engine is running normally. If there is shaking, black smoke, or other abnormalities, avoid restarting the engine. Note: Never restart if the red warning light is on. If the engine can start, turn it off and wait 5-10 minutes. Without pressing the brake, press the start button once or turn the key halfway to the "ON" position (without depressing the clutch). The vehicle will perform a self-check upon powering up. Observe if the malfunction light turns off after 5-10 seconds. If the light remains on, visit a service center as soon as possible. Technicians can use a portable diagnostic tool to read fault codes, identify the issue, and perform targeted repairs.

20

1

Share

How to Completely Eliminate Odors After a Car is Flooded?

When the car interior gets flooded, it's not just about cleaning but also disinfecting. This step is often easily overlooked. It's best to wash seats and seat covers with bleach, and the absorbent cotton must be replaced to prevent bacterial growth. It is recommended that car owners drive the flooded car under the sun on a clear day, setting the air conditioning system to warm air mode. Leave it to dry for more than ten minutes with all doors and windows fully open.

18

4

Share

What is the fuel consumption of the Changan CS35 Plus manual transmission?

The official combined fuel consumption of the Changan CS35 Plus manual transmission is 6.3L/100KM. More details about the Changan CS35 Plus manual version are as follows: 1. Body dimensions: The Changan CS35 Plus measures 4335mm in length, 1825mm in width, and 1660mm in height, with a wheelbase of 2600mm. 2. Powertrain: The Changan CS35 Plus manual version is equipped with a BLUE CORE 1.6L direct-injection naturally aspirated engine, delivering a maximum output of 128 horsepower (94kW) and a peak torque of 161 N·m, paired with a 5-speed manual transmission.

15

5

Share

What is the fuel consumption of the Honda XRV?

What is the difference between SN and SL engine oil?

Is the passing score for C1 Subject 2 80 or 90?

What Should You Do When a Car Radiator Boils Over?

What are the reasons for the engine malfunction light in the Volkswagen Tharu?

How to Completely Eliminate Odors After a Car is Flooded?

What is the fuel consumption of the Changan CS35 Plus manual transmission?

Can Car Keys and House Keys Be Stored Together?

How Should Beginners Drive in the City?

Where Can China 5 Vehicles Still Be Registered Now?

Can You Listen to Music When the Car Is Off?