What is the fuel consumption of the FJ Cruiser?

1 Answers
LaJeffrey
07/30/25 2:47am
The FJ Cruiser has 3 models. Among them, the 2013 FJ Cruiser 4.0L and 2011 FJ Cruiser 4.0L, equipped with a 272 horsepower engine, have an NEDC fuel consumption of 11.9L per 100 km. The 2010 FJ Cruiser 4.0L, equipped with a 272 horsepower engine, has an NEDC fuel consumption of 11.6L per 100 km. The fuel tank capacity of all FJ Cruiser models is 72L. The distance that can be covered with a full tank of fuel is as follows: For models equipped with a 272 horsepower engine, the distance that can be covered with a full tank of fuel is 72/11.9*100=605 km. For models equipped with a 272 horsepower engine, the distance that can be covered with a full tank of fuel is 72/11.6*100=621 km. The fuel consumption of a car is directly related to five major factors: driving habits, the car itself, road conditions, natural wind, and environmental temperature. Specific factors that can increase a car's fuel consumption are as follows: Driving habits: Aggressive driving, such as sudden acceleration, frequent overtaking, and not easing off the throttle before a red light, can increase fuel consumption. The car itself: Cars with larger engine displacements generally consume more fuel than those with smaller displacements because larger displacements usually mean higher power, requiring more gasoline to burn and perform work. Heavier cars also have higher fuel consumption because greater weight requires more driving torque. Road conditions: Driving on dirt roads, muddy roads, soft surfaces, or mountainous roads increases resistance and fuel consumption. Natural wind: Driving against the wind or on windy days increases the car's resistance and fuel consumption. Low environmental temperatures: When the engine block temperature is low, the gasoline injected during a cold start does not atomize easily, requiring more gasoline to be injected for combustion, which increases fuel consumption. Additionally, at low temperatures, the engine's computer will control the engine to run at higher RPMs to warm up, which also increases fuel consumption.
Was this review help?
3
4
Share
More Forum Discussions

How fast can a 1500w motor with 72v run?

1500w motor with 72v can reach a maximum speed of 60km/h. Here is some introduction about automotive motors: 1. Function: An electrical component that converts between electrical energy and mechanical energy. When electrical energy is converted into mechanical energy, the motor exhibits the working characteristics of an electric motor; when mechanical energy is converted into electrical energy, the motor exhibits the working characteristics of a generator. Most electric vehicles convert mechanical energy into electrical energy during braking, using the generator to recharge the battery. 2. Development status and classification: The drive motors commonly used in electric vehicles include DC motors, asynchronous motors, permanent magnet synchronous motors, and switched reluctance motors. DC motors were the first to be applied in electric vehicles, known for their good control performance and low cost. With the development of electronic technology, mechanical manufacturing technology, and automatic control technology, asynchronous motors, permanent magnet synchronous motors, and switched reluctance motors have demonstrated superior performance compared to DC motors, and these types of motors are gradually replacing DC motors.
8
3
Share

Should the RAV4 use 92 or 95 octane gasoline?

Both 92 and 95 octane gasoline can be used for the RAV4. The selection method and basis are introduced as follows: Gasoline selection method: The difference between 92 and 95 octane gasoline is not significant, primarily in their octane ratings. This results in different anti-knock properties, and the choice should be based on the engine's compression ratio. You can refer to the compression ratio specified in the vehicle's manual, and manufacturers usually indicate the recommended gasoline grade in the manual. Gasoline selection basis: Compact cars generally do not have very high engine requirements, with compression ratios ranging between 8.6 and 9.9. Mid-size cars have compression ratios between 10 and 11.5. For engines with compression ratios exceeding 11.5, higher-octane gasoline may be considered—these engines are typically found in luxury-brand vehicles and deliver strong performance. Engines with compression ratios between 8.6 and 9.8 are suitable for 92 octane gasoline, while those between 10 and 11.5 are suitable for 95 octane gasoline.
1
2
Share

When to Use the S Gear in a Car?

S gear, known for its strong power, is generally used when overtaking or climbing hills. After completing these actions, it is recommended to switch back to the more economical D gear, as the S gear mode consumes significantly more fuel than the normal mode due to increased fuel injection at high RPMs. It also tends to wear out the transmission more quickly, making it unnecessary for daily driving. Here are some relevant details about the S gear: 1. Benefits of using the S gear: Although the S gear is not frequently used, it does have advantages. For cars that often drive in congested urban areas, the engine tends to accumulate more carbon deposits. Therefore, using the S gear periodically can help remove carbon deposits from the engine, improve fuel economy, and extend the engine's lifespan. 2. Avoid using the S gear for prolonged high-speed driving: Since the S gear only delays upshifting without altering other operational aspects, it inevitably increases the transmission's load in the short term, leading to higher temperatures and accelerated wear. Additionally, the vehicle's comfort level is slightly reduced in S gear mode, so it is advisable to avoid prolonged use of the S gear.
4
5
Share

How Long Does Driving Count as Fatigue Driving?

Continuous driving for 4 hours is considered fatigue driving. Below are specific precautions to take when driving long distances: Balance Work and Rest: For long-distance road trips, it is advisable to have two or more cars traveling together. This way, they can look out for each other on the road, and if a vehicle breaks down or an accident occurs, there will be assistance. Each car should ideally have two drivers. When one feels physically exhausted, the other can take over, ensuring the journey continues smoothly while avoiding fatigue driving. Pay Attention to Traffic Safety: Self-driving trips often take place during holidays when the number of vehicles and pedestrians on the road is significantly higher than usual. Therefore, drivers should pay extra attention to traffic safety, firmly uphold the principle of safety first, and consciously comply with traffic regulations. Monitor the Vehicle: While driving, always be attentive to the vehicle's operating conditions. Follow these three steps: 1) Listen—check for any abnormal sounds from the engine or chassis; 2) Observe—ensure all dashboard indicators display normal readings; 3) Smell—be alert for unusual odors such as burning wires, rubber, clutch, or brakes, as well as sudden gasoline smells.
17
4
Share

What are the consequences if I can't attend the scheduled Subject 4 test?

Absence from the test will be treated as a failure. Although Subject 4 can be scheduled an unlimited number of times, frequent absences may affect the success rate of future appointments. If you genuinely cannot attend the test due to personal reasons, it is recommended to cancel the appointment at the vehicle management office at least one day in advance to avoid being marked as absent. Below is the content of the Subject 4 test: 1. Type: Depending on the type of driver's license being pursued, 50 questions are randomly selected from the corresponding Subject 4 question bank in proportion. For car licenses, questions are drawn from 1235 items, and for large vehicle licenses, from 1235 items, with each question worth 2 points. 2. Time: The test duration is 45 minutes. Making mistakes totaling 12 points (6 questions) will terminate the test. 3. Question Types: The test includes true/false questions (1-22), single-choice questions (23-45), and multiple-choice questions (46-50). 4. Questions: The test questions consist of image-based questions, scenario recognition questions, and text-based questions.
15
2
Share

What are the causes of a car's radiator boiling over?

The causes of a radiator boiling over include insufficient water level; radiator blockage leading to poor circulation or backflow; water leakage from the radiator hindering water circulation; malfunctioning thermostat in switching between large and small circulation cycles; damaged cooling fan or short circuit causing fan failure, or very slow fan speed; and issues with the fan's water temperature sensor. Below are the handling methods for a car boiling over: When boiling over at low speed: Immediately pull the car over to the roadside, turn off the engine, and open the engine hood to allow faster heat dissipation. After the engine's water temperature drops, check if the coolant level is too low, inspect the radiator pipes for leaks, and verify if the cooling fan is operational. Generally, boiling over caused by low-speed driving is commonly due to radiator or pipe leaks, or the cooling fan not working. When boiling over at high speed: Pull over immediately, but do not turn off the engine. Similarly, open the engine hood and let the engine cool down naturally at idle speed for a while before shutting it off. If the engine is turned off immediately, the car's cooling system will stop working while the engine is still under high thermal load, which may lead to engine component deformation, cylinder scoring, and other phenomena.
16
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.