What is the fuel consumption of the Changan Uni-K?

1 Answers
DiAlana
07/29/25 8:27pm
The official fuel consumption of the Changan Uni-K is 6.3L/100km. Below is an introduction on how to check fuel consumption and factors that affect it. Method to check fuel consumption: The fuel gauge on the engine displays the fuel level, used to monitor the reserve and consumption of fuel in the tank. 'F' indicates full, and 'E' indicates empty. When the fuel warning light comes on, record the mileage, then refuel. When the fuel runs out again, record the mileage once more. Subtract the initial mileage from the final mileage to get the actual distance traveled, then divide by the fuel consumed to calculate the fuel consumption. Factors affecting fuel consumption: Incorrect driving habits can increase fuel consumption by 2 to 3 times. Aggressive driving behaviors, such as rapid acceleration and hard braking, especially in traffic jams, at red lights, or during lane changes, are the most common contributors. Rough or uneven roads force the vehicle to operate in lower gears for extended periods, inevitably increasing fuel consumption. Neglecting maintenance also leads to higher fuel consumption. Proper and scientific maintenance can help save fuel.
Was this review help?
17
3
Share
More Forum Discussions

What are the differences between the Arrizo 5 Plus and the Arrizo 5?

The differences between the Arrizo 5 Plus and the Arrizo 5 are that the Arrizo 5 PLUS has a more sporty appearance. The following is a specific introduction to the Arrizo 5: 1. In terms of appearance: The Arrizo 5 PLUS looks more sporty, which better suits the aesthetics of young people. The Arrizo 5 PLUS is 108mm longer and 8mm taller than the Arrizo 5, making it larger in size, so the headroom and legroom of the Arrizo 5 PLUS have been improved to some extent. 2. In terms of configuration: The Arrizo 5 PLUS adds front side airbags, fatigue driving reminder, rearview camera, and engine electronic anti-theft system.
4
2
Share

What do the approach angle and departure angle of a car mean?

Approach angle refers to the angle between the ground and the tangent line drawn from the foremost protruding point of the car to the front wheel when the car is fully loaded and stationary. Departure angle refers to the angle between the road surface and the tangent line drawn from the rearmost protruding point of the car to the rear wheel when the car is fully loaded and stationary. Here are the relevant introductions: 1. Approach angle: The approach angle is the maximum angle between the horizontal plane and the plane tangent to the outer edge of the front wheel tire (under static load). Any rigid component fixed to the vehicle in front of the front axle must not be below this plane. The larger the approach angle, the less likely the car is to have a contact accident when boarding or disembarking a ferry or during off-road driving, and the better the car's passing performance. 2. Departure angle: The departure angle refers to the angle between the road surface and the tangent line drawn from the rearmost protruding point of the car to the rear wheel when the car is fully loaded and stationary, that is, the maximum angle between the horizontal plane and the plane tangent to the outer edge of the rearmost wheel tire (under static load). Any rigid component fixed to the vehicle behind the rearmost wheel must not be below this plane. It characterizes the car's ability to avoid collision when leaving obstacles (such as hills, ditches, etc.). The larger the departure angle, the better the car's passing performance.
17
1
Share

What problems may occur after a vehicle wades through water?

Problems that may occur after a vehicle wades through water include: 1. Residual water can prevent the brake discs and brake pads from fully contacting, causing loss of braking power; 2. Rainwater on roads tends to be dirty with debris like fallen leaves, which can easily adhere to chassis gaps and cause rust; 3. If headlight covers aren't well sealed, water can enter during wading, creating condensation inside that affects light projection; 4. The engine compartment contains numerous wiring harnesses and circuits that may get wet during wading. If interfaces are found wet, immediate drying is necessary to prevent short circuits.
12
5
Share

At how many kilometers does a vehicle require a major maintenance service?

Vehicles require a major maintenance service every 40,000 kilometers. Routine maintenance items include: replacement of engine oil and oil filter. The primary function of the lubrication system is to effectively lubricate various components of the car engine to prevent excessive wear; the oil filter's role is to remove various impurities from the oil, ensuring the normal operation of the lubrication system. The oil filter should be replaced along with the oil during an oil change. The air filter's function is to filter the air before it enters the cylinders, removing impurities, dust, sand, and other foreign particles. The cleaning and maintenance of the air filter depend on the operating environment. The gasoline filter is typically replaced after driving 20,000 to 25,000 kilometers. Spark plugs are consumable parts and should be replaced every 20,000 kilometers.
10
4
Share

What are the differences between the Mercedes-Benz C-Class and CLA?

The differences between the Mercedes-Benz C-Class and CLA are: 1. Different vehicle types: The Mercedes-Benz C-Class is a mid-size car; the CLA is a compact car. 2. Different engine displacements: The Mercedes-Benz C-Class has 1.5T and 2.0T options; the CLA has 1.3T and 2.0T. 3. Different transmissions: The Mercedes-Benz C-Class uses an automatic transmission; the CLA uses a dual-clutch transmission. 4. Different drive systems: The Mercedes-Benz C-Class is rear-wheel drive; the CLA is front-wheel drive. The front design of the Mercedes-Benz C200 is identical to the imported version, with sharp lines for the split high and low beams, giving it a youthful and dynamic overall look. In terms of dimensions, the Mercedes-Benz C200 measures 4526mm in length, 1728mm in width, and 1427mm in height, with a wheelbase of 2715mm, making it a four-door, five-seat sedan.
4
3
Share

How to Deal with Coolant Leakage from the Radiator?

Methods for handling coolant leakage from the radiator: It is recommended to use a specialized radiator pressure tester for inspection. Pressure must be applied to the engine cooling system to detect leaks. If significant leakage is found, the damaged components need to be replaced. After replacement, use the radiator pressure tester again to pressurize the radiator and check for any additional leaks. Coolant is a liquid with antifreeze properties, serving the functions of antifreeze and cooling—preventing freezing in winter, overheating in summer, and protecting against scale, rust, and corrosion year-round. Ordinary coolant can have a freezing point as low as -40°C or even -60°C, safeguarding the engine's cooling system under extremely cold conditions.
2
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.