What is the fuel consumption of the Changan Oushang X5 1.5t?

2 Answers
SimonAnn
08/28/25 2:24am
Changan Oushang X5 1.5t has a comprehensive fuel consumption of 6.0-6.3L/100km. Currently, there are 7 models of Changan Oushang X5 1.5t on sale: DCT Whirlwind Charge, DCT Flagship, DCT Hurricane Sonic, DCT Elite, DCT Premium, DCT Luxury, and DCT Tiger Roar Limited Edition, with a comprehensive fuel consumption of 6.2L/100km. The above figures are NEDC comprehensive fuel consumption, which is the fuel consumption data measured under the NEDC test procedure. The actual fuel consumption is higher than this value, ranging from 6.3-8.6L/100km. When driving, the following 5 tips can help reduce fuel consumption: When starting the vehicle, use a low gear, gently press the accelerator, and gradually increase speed. Avoid suddenly pressing the accelerator hard, as this will multiply fuel consumption. Light acceleration, light braking, and early braking: When driving, gently press the accelerator to avoid sudden increases in engine speed and prevent the car from shaking during driving, making the car more fuel-efficient. By estimating road conditions and adopting slow and uniform acceleration or braking, fuel economy can be increased by up to 20%. Maintain proper tire pressure: Keep tire pressure at the level recommended by the manufacturer. For every 2 PSI below the recommended value (equivalent to about 0.2 in metric units relative to the standard pressure of 2.4), fuel consumption increases by 1%. Regular maintenance or inspection of the vehicle: Regular oil changes can reduce carbon deposits (carbon deposits can cause poor ignition, sluggish acceleration, increased fuel consumption, and even cylinder misfires in severe cases); regularly check and replace the air filter when dirty, and clean or replace the fuel injectors, spark plugs, and throttle body at the recommended mileage. Close the windows while driving. Driving with windows open increases wind resistance. The greater the wind resistance, the greater the resistance the car faces, requiring more power and thus increasing fuel consumption.
Was this review help?
8
2
Share
DiHeidi
09/09/25 7:48am
I've been driving the Changan Oushang X5 1.5T for half a year, mainly commuting in the city, with fuel consumption around 8.5 to 9L per 100 km. It occasionally goes above 10L in heavy traffic, but drops below 7L on highways, which is quite satisfying. Turning on the AC increases fuel consumption slightly by about 0.5L, especially noticeable in summer. Timely maintenance is key—after replacing the air filter and engine oil once, my fuel consumption dropped from 9.2L to 8.3L. Driving habits also matter; avoiding sudden braking or hard acceleration saves fuel. Keeping the car light helps too—don’t overload the trunk. Overall, this car is great for daily family use with reasonable fuel consumption, and I’ve never exceeded my budget when calculating fuel costs.
Was this review help?
20
1
Share
Expand All
More Forum Discussions

Is the Audi Q3 compliant with China's National VI emission standards?

The new Audi Q3 is a model that meets the National VI emission standards. National VI emission standards: The National VI emission standards refer to the sixth stage of China's national standards for controlling pollutant emissions from motor vehicles. These standards are established to prevent environmental pollution caused by exhaust emissions from compression-ignition and gas-fueled spark-ignition engine vehicles, protect the ecological environment, and safeguard human health. The National VI emission standards specify the following limits: carbon monoxide (CO) emissions at 700mg, non-methane hydrocarbon (NMHC) emissions at 68mg, nitrogen oxide (NOx) emissions at 60mg, and particulate matter (PM) emissions at 4.5mg. Methods to check a car's emission standards: Check the vehicle's environmental protection compliance label or the page in the vehicle certificate where the label starts; estimate the vehicle's emission standard based on its manufacturing year; or use the original or a copy of the motor vehicle registration certificate to inquire at the local vehicle management office. The Audi Q3 is equipped with a 1.4T L4 turbocharged engine and a 2.0T L4 turbocharged engine, delivering a maximum horsepower of 150PS and a maximum torque of 250Nm, paired with a 7-speed dual-clutch transmission.
6
5
Share

When should car spark plugs generally be replaced?

Under normal maintenance conditions, car spark plugs should be replaced after driving 40,000 to 60,000 kilometers. However, this may vary depending on the brand and engine type, so it's recommended to follow the owner's manual. The following standards can be referenced for maintenance replacement: Platinum spark plugs should be replaced at 40,000 kilometers, ordinary nickel alloy spark plugs at 20,000 kilometers, and iridium spark plugs at 60,000 to 80,000 kilometers. Methods to determine if spark plugs are damaged: Remove the spark plug and observe its appearance color to assess its condition. A normal spark plug's insulator skirt and electrodes should appear gray-white, gray-yellow, or light brown. A properly functioning spark plug's insulator skirt should be reddish-brown, with an electrode gap between 0.8-0.9mm and no signs of electrode burning. If the spark plug has oil stains or deposits but isn't damaged, it can continue to be used after cleaning off the oil and deposits. If the spark plug is severely damaged with signs like blistering at the top, black streaks, cracks, or melted electrodes, the cause of damage should be identified. After troubleshooting, replace with a new spark plug. Additionally, if the spark plug appears smoke-blackened, it indicates incorrect heat range selection, rich fuel mixture, or oil leakage.
14
3
Share

Where is the cabin air filter located in the Audi A3?

The cabin air filter of the Audi A3 is located behind the glove compartment on the passenger side. Here is more information about the Audi A3: 1. The Audi A3 is equipped with two types of engines: a 1.4-liter turbocharged engine and a 2.0-liter turbocharged engine. 2. The 1.4-liter turbocharged engine delivers 150 horsepower and a maximum torque of 250 Nm. This engine reaches its maximum power output at 5000 to 6000 rpm and its peak torque at 1750 to 3000 rpm. It features direct fuel injection technology and uses an aluminum alloy cylinder head and block. This engine is paired with a 7-speed dual-clutch transmission. 3. The 2.0-liter turbocharged engine produces 190 horsepower and a maximum torque of 320 Nm. It achieves its maximum power at 5000 rpm and peak torque between 1600 and 4000 rpm. This engine employs a hybrid injection system and combines an aluminum alloy cylinder head with a cast iron block. It is also matched with a 7-speed dual-clutch transmission, which offers fast gear shifts and high transmission efficiency, making it particularly suitable for pairing with small-displacement turbocharged engines. 4. The Audi A3 uses a MacPherson strut front suspension and a multi-link independent rear suspension.
10
5
Share

What is the fuel tank capacity of the 2015 Tucson?

The fuel tank capacity of the 2015 Tucson is 62L. The Tucson's powertrain features a Gamma series 1.6T turbocharged engine across all models, paired with a Dymos 7-speed dry dual-clutch transmission. The 2.0L naturally aspirated engine and Powertrain 6AT are only continued in the ix35. For comparison, the fuel tank capacity of the Volkswagen Tharu in the same segment is 56.5L, the Nissan Qashqai has a 65L tank, and the T-Roc's fuel tank capacity is 51L. During actual refueling, the amount of fuel may exceed the marked capacity. This is because the fuel tank capacity specified by automakers is measured from the bottom of the tank to the safe fill level, with additional space remaining from the safe fill level to the tank opening. This space ensures that the fuel can expand when temperatures rise without overflowing. If fuel is filled up to the tank opening during refueling, the actual amount of fuel added may exceed the marked capacity. To check the remaining fuel level, owners can observe the fuel gauge on the right side of the instrument panel, marked with E (Empty) and F (Full). When the needle is close to E, it indicates low fuel, while nearing F means the tank is sufficiently full.
18
3
Share

What is the fuel tank capacity of the new Santana?

The fuel tank capacity of the Santana-2021 1.5L Manual Fashion Edition is 52.8L. It is equipped with a 1.5L naturally aspirated engine and a 5-speed manual transmission (MT). The drivetrain is front-engine, front-wheel drive. The front suspension is a MacPherson independent suspension, and the rear suspension is a compound torsion beam non-independent suspension. Among vehicles in the same class, the Buick Excelle-2021 Modified Classic 1.5L Automatic Entry Edition has a fuel tank capacity of 44L, while the Volkswagen Bora-2021 1.5L Manual Fashion Smart Connection Edition has a fuel tank capacity of 50L. During actual refueling, the amount of fuel may exceed the marked capacity. This is because the fuel tank capacity marked by the manufacturer is measured from the bottom of the tank to the safety limit. There is additional space from the safety limit to the tank opening, which is reserved to allow for fuel expansion when temperatures rise, preventing overflow. If fuel is filled up to the tank opening during refueling, the actual amount of fuel added may exceed the marked capacity. To check the remaining fuel level, drivers can observe the fuel gauge on the right side of the instrument panel, which is marked with E (Empty) and F (Full). When the needle is close to E, it indicates low fuel, while nearing F means the tank is nearly full.
15
4
Share

How to resolve the yellow warning light?

Ensure the gear lever of a manual transmission vehicle is in the neutral position. It is strictly prohibited to engage in parking behavior when the vehicle's transmission is in a forward gear (D, S, L, or with Arabic numerals, etc.) or reverse gear (R) position.
6
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.