What is the fuel consumption of the BYD Surui?

What Causes a Gasoline Car to Emit Black Smoke?

When a car emits black smoke, it is often due to uneven or excessive fuel supply from the high-pressure fuel pump across the cylinders. This can cause unstable engine speed and intermittent black smoke emissions. The issue should be addressed by adjusting the fuel supply to achieve balance or keep it within the specified range. Additionally, malfunctioning or damaged fuel injectors can lead to insufficient fuel atomization, resulting in black smoke. In such cases, the injectors need to be inspected and replaced. Below are the reasons and solutions for a car emitting black smoke: 1. Check if the air filter is clogged, if there is any leakage in the intake pipe (which may cause the engine to produce a sharp whistling sound under increased load), or if the turbocharger is damaged. 2. The solution involves inspecting whether the turbine wheel and compressor wheel blades are damaged and ensuring they rotate smoothly and flexibly.

1

4

Share

What is the ground clearance of the Zotye Z500?

The minimum ground clearance of the Zotye Z500 is 15cm. The Zotye Z500 is a mid-size car featuring a popular integrated lower grille design. The entire lineup is equipped with a 1.5-liter turbocharged engine, paired with either a 5-speed manual transmission or a CVT transmission. The front suspension of the Zotye Z500 utilizes a MacPherson independent suspension, while the rear suspension employs a torsion beam non-independent suspension. The torsion beam suspension has a simple structure and occupies minimal space, allowing for expanded rear passenger space and trunk capacity.

12

3

Share

What brand of tires does the Boyue use?

The Boyue uses two types of tires. The mid-to-low trim models are equipped with Giti Comfort-SUV520 tires, while another option is the Cooper Discoverer-HTS tires. Both tires share the same size: 225/65-R18. Here are the details: 1. The Giti Comfort SUV520 is a high-performance SUV tire that balances handling, comfort, and safety. It features 3B stiffness balancing technology, combined with an optimized shoulder tread block and transverse groove configuration, ensuring even tread contact pressure distribution for improved handling stability and grip performance. The use of high-grip synthetic rubber with nano-reinforced carbon black and high-performance silica materials, along with four wide longitudinal grooves on the tread, effectively enhances wet braking performance, reduces braking distance, enables rapid water drainage at high speeds, and improves tire grip. 2. The Cooper Discoverer-HTS is a tire developed for mid-to-high-end urban SUV models and is the most affordable option in Cooper's urban SUV tire lineup. This tire emphasizes handling comfort and quiet performance, excelling in both handling and comfort/noise reduction, making it a well-balanced SUV tire.

13

1

Share

Why Does the Car Clutch Become Lower?

Reasons why a car clutch becomes lower: 1. There is air inside the clutch system, or leakage in the clutch master or slave cylinder; 2. The clutch cable is low, and there is an adjusting screw at the front end of the clutch cable—sometimes if it loosens, the clutch becomes lower; 3. The impact of a low car clutch: if adjusted too low, it can affect the separation gap, causing the car to start in a semi-clutch state, leading to clutch wear, and making gear shifting difficult. The clutch functions like a switch, engaging or disengaging power transmission. The clutch mechanism allows the driving and driven parts to temporarily separate and gradually engage, with the possibility of relative rotation during transmission. A rigid connection cannot be used between the driving and driven parts of the clutch.

8

1

Share

Reasons for Detected Misfire in Cylinder 4 (P0304)

p0304 detected misfire in cylinder 4 can be caused by the following reasons: 1. Spark Plug: Poor spark plug firing. 2. Piston Ring: Damaged piston rings leading to low cylinder pressure. 3. Ignition Coil: Internal damage to the ignition coil. 4. Timing Mechanism: Incorrect timing or skipped teeth in the timing mechanism. 5. Engine: Engine computer damage or fault code issues. The troubleshooting methods are: Check the cylinder pressure of each cylinder to ensure it is normal; most vehicles have a cylinder pressure of around 1300 kPa. Address any cylinders with abnormal pressure. Inspect the spark plug firing condition, the size of the free gap, whether the ceramic area has cracks, and if it has been punctured. Replace any damaged spark plugs. Check if the timing marks on the timing belt or timing chain align correctly. If misaligned, disassemble the timing mechanism and realign the timing marks. Try replacing the ignition coil to see if the issue is resolved.

18

4

Share

What to Do When the Braking System Malfunctions?

Solutions for braking system malfunctions: 1. If you notice that the brake pedal does not rise when pressed and there is no resistance, check if the brake fluid is low and top it up promptly. It could also be due to a malfunction in the brake wheel cylinder, pipelines, or connectors, which requires repair. 2. If the braking effect is poor when the brake pedal is pressed all the way down or during continuous braking, it indicates the presence of air in the braking system, necessitating bleeding. 3. If the pedal position is very low and does not rise after being pressed, and it feels stiff, this is caused by a blockage in the master cylinder, which needs to be cleared.

18

3

Share

What is the fuel consumption of the BYD Surui?

What Causes a Gasoline Car to Emit Black Smoke?

What is the ground clearance of the Zotye Z500?

What brand of tires does the Boyue use?

Why Does the Car Clutch Become Lower?

Reasons for Detected Misfire in Cylinder 4 (P0304)

What to Do When the Braking System Malfunctions?

What Happens If the Owner Doesn't Move the Car with One-Tap Move Car Service?

How to Open the Trunk of a Mercedes-Benz E300?

What License Plate Does a Hybrid Car Use?

What is the probability of being caught for an illegal U-turn?