What is the fuel consumption of the BYD Qin gasoline version?

3 Answers
MacElla
07/24/25 11:54pm
The fuel consumption of the BYD Qin gasoline version is approximately 6.5 liters per 100 kilometers. Below is more information about the BYD Qin: 1. Body dimensions: The vehicle's length, width, and height are 4765 mm, 1837 mm, and 1495 mm respectively, with a wheelbase of 2718 mm. 2. Powertrain: The vehicle is equipped with a 1.5-liter naturally aspirated engine, which has a maximum power output of 81 kW at 6000 rpm and a maximum torque of 135 Nm at 4500 rpm. The engine utilizes multi-point fuel injection technology and features an aluminum alloy cylinder head and block.
Was this review help?
7
1
Share
CaydenLynn
08/10/25 10:44am
I've been driving the BYD Qin fuel version for almost two years. In the city, the fuel consumption is around 8 to 9 liters per 100 kilometers, mainly due to higher consumption during peak hours with traffic congestion. On the highway, it drops to about 7 liters, with the most fuel-efficient cruising speed controlled between 80 to 100 kilometers per hour. Driving habits have a significant impact; for example, smoother acceleration and fewer sudden brakes can reduce fuel consumption. Maintenance factors also play a role, such as changing the engine oil every six months and keeping tire pressure around 2.3 bar, which helps save fuel. Overall, this car is quite economical, with lower fuel consumption compared to some vehicles in the same class. However, I recommend test-driving more before purchasing to experience its performance under different road conditions, as actual fuel consumption varies from person to person. Daily fuel expenses are approximately 600 to 800 yuan per month, and planning routes wisely can save even more money.
Was this review help?
14
1
Share
Expand All
LondynFitz
09/26/25 7:29am
The official fuel consumption of the BYD Qin fuel version is rated at 7.5 liters per 100 kilometers, but actual experience often shows higher figures, typically exceeding 8 liters in urban conditions, while it can drop to around 7 liters on highways. Factors influencing this include transmission response, vehicle weight, and load—full load driving can increase consumption by approximately 0.5 liters. Personally, I pay attention to avoiding prolonged idling and use the eco mode to save some fuel; regular maintenance, such as cleaning the air filter, is crucial. Environmental factors like temperature changes also play a role, with slightly higher consumption in winter due to heating. Overall, the fuel consumption is reasonable for a compact car. It’s advisable to regularly record fuel consumption data and optimize driving habits with the help of apps. Don’t overlook the impact of air resistance—closing windows at high speeds can reduce additional fuel consumption.
Was this review help?
3
3
Share
Expand All
More Forum Discussions

Does the Ford Escort have only one brake light?

Ford Escort is equipped with two brake lights, plus an additional high-mounted brake light. There is only one reverse light, located on the left rear side of the vehicle, and one rear fog light, positioned on the right rear side. If only one brake light is illuminated, it indicates that the bulb has burned out and needs replacement. Below is more related information: 1. Brake light bulb model: The brake light bulb for Ford Escort is model P21W, a halogen bulb with a power of 21 watts. 2. Ford Escort: The Ford Escort was developed by Ford's British engineers in 1964. Mass production began at the end of 1967, and it made its debut at the Brussels Motor Show in early 1968. Not only did it exist as a successful compact family car, but it also pioneered Ford's participation in rally events with sport versions of economy sedans in Europe, establishing Ford's sporty and avant-garde image in this category of vehicles.
3
2
Share

Why is it difficult to pull the handbrake?

Reasons for difficulty in pulling the handbrake: The cable has been used for a long time and is rusted inside, making it hard to pull, which requires replacing the cable; the gap is too small, making it hard to pull, and a mechanic can adjust it. The handbrake does not need to be pulled too tight, generally 4~6 ratchet teeth are sufficient. Below is a detailed introduction about the handbrake: 1. Parking and turning off the engine with the handbrake on: The handbrake, also known as the parking brake, provides resistance to the car when parked to prevent it from rolling. Automatic transmissions do not require the driver to manually shift gears; the vehicle automatically selects the appropriate gear based on driving speed and traffic conditions. 2. Parking in neutral with the handbrake on: Generally, automatic transmission cars have six gear positions, from top to bottom: P, R, N, D, S, L.
3
5
Share

What Causes Neutral Gear Shaking?

The reasons for engine shaking in neutral gear are as follows: 1. Poor gasoline quality: This is usually caused by filling up with low-quality gasoline at non-standard gas stations, leading to incomplete combustion of the air-fuel mixture during engine operation and triggering the engine fault light. While this does not affect driving safety, it may cause some degree of harm to the engine. 2. Oxygen sensor failure: Modern cars are equipped with two oxygen sensors, one before and one after the three-way catalytic converter. The front oxygen sensor detects the air-fuel ratio under different engine conditions, and the ECU adjusts the fuel injection amount and calculates the ignition timing based on this signal. The rear sensor mainly monitors the performance of the three-way catalytic converter. Therefore, if the oxygen sensor is damaged or the sensor connector is faulty or loose, it can cause the air-fuel mixture to become too lean or too rich, leading to the illumination of the fault light.
19
2
Share

Is it normal to practice driving for only half an hour each time?

It is normal to practice driving for only half an hour each time, as the instructor will arrange for students to take turns. Here are some precautions to take when practicing driving: 1. Overtaking and lane changing: Be decisive and firm when overtaking or changing lanes, and try to stay close to the vehicle in front, especially on two-way roads, to save time. When changing lanes, carefully observe the traffic in the adjacent lane through the rearview mirror, not only judging the distance but also the speed of the following vehicle. 2. Listen to the engine sound: Unusual noises occur when the speed is high but the gear is low, or when the gear is dragging. Abnormal sounds also happen at low speed with high gear, accompanied by body shaking. 3. Avoid frequently shifting to neutral: Coasting in neutral is acceptable when the speed is low and safety is not compromised, but it consumes more fuel for fuel-injected vehicles. Never shift to neutral when going downhill, as it can easily lead to brake failure and loss of control if the engine stalls.
6
0
Share

What are the functions of the Volkswagen multifunction steering wheel buttons?

The functions of the Volkswagen multifunction steering wheel buttons are as follows: 1. Resume button: Press RES to restore the previously set speed after temporarily canceling cruise control; 2. Set button: Press SET to set the current speed as the cruise speed after temporarily canceling cruise control; 3. Deceleration button: If adaptive cruise control is activated, use it to reduce speed; 4. Acceleration button: If adaptive cruise control is activated, use it to increase speed; 5. Cruise control on/off button: Press to turn on cruise control; 6. Cancel button: Press to cancel cruise control; 7. Volume adjustment buttons: Press to increase or decrease volume, with the left button lowering volume and the right button raising it; 8. Bluetooth call button: Press to answer incoming calls; 9. Voice control button: Press to activate voice commands; 10. Option toggle button: Used to switch between options up and down on the multifunction display; 11. Menu toggle button: Used to switch between options left and right on the multifunction display, with OK indicating confirmation; 12. Track change buttons: Press to skip to the next or previous track.
17
2
Share

Where is the Start-Stop Switch for Cadillac XT5?

Cadillac XT5's auto start-stop switch is located on the left side of the central control screen. To turn it off, simply press the corresponding button. Notes on using auto start-stop and auto hold: 1. Auto start-stop will shut off the engine, and unless the vehicle is also equipped with auto hold, you must keep your foot on the brake during this process. Once you release the pedal, the engine will restart. 2. Auto hold locks the wheels, eliminating the need for the driver to keep their foot on the brake. Pressing the accelerator pedal is the signal to release, at which point the vehicle will start moving again. Tips for using Cadillac XT5's auto start-stop: 1. The auto start-stop function must be manually turned off each time you drive. To disable it permanently, you need to visit a 4S dealership for settings. 2. During holidays with frequent traffic jams, it is recommended to turn off the start-stop function. Frequent restarts significantly reduce ride comfort. 3. For vehicles without hill-start assist, it is advisable to turn off this function when starting on a slope to prevent the vehicle from rolling backward.
14
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.