What is the fuel consumption of the 2012 LaCrosse 2.4?

1 Answers
DiHeidi
07/25/25 8:17am
The LaCrosse is a new mid-to-high-end sedan positioned between the Regal and Royaum. The fuel consumption of the 2012 LaCrosse 2.4 is as follows: 1. Combined fuel consumption: Approximately 10.4 liters. 2. City fuel consumption: Around 11 liters. 3. Highway fuel consumption: Approximately 9.6 to 10 liters. Information about fuel consumption is as follows: 1. Constant-speed fuel consumption: This refers to the fuel economy indicator when the car is driving at a constant speed on a good road surface. Since constant-speed driving is a basic operating condition for cars on highways and this type of fuel consumption is easy to measure, it is widely used. 2. Road cycle fuel consumption: This is the fuel economy indicator measured when the car drives in repeated cycles according to specified speed and time norms on the road, also known as multi-condition road cycle fuel consumption. The speed and time norms specify various driving conditions for each cycle, including gear shift timings, braking and stopping times, as well as driving speed, acceleration, and braking deceleration values.
Was this review help?
18
2
Share
More Forum Discussions

Will Removing the Rear Window Film Damage the Heating Wires?

Generally, it will not damage the heating wires. 1. Location of heating wires: The heating wires are on the surface of the glass, and you can feel the raised lines by touching them. If the quality of the film is poor, removing it may pull off parts of the heating wires. However, if the film is properly applied and lasts for a long time, there will be no need to remove it. 2. Removing the film: Generally, removing the film will not damage the heating wires. During the operation, avoid rough handling and simply spray water beforehand to moisten it. 3. Disadvantages of inferior films: Inferior sun films usually contain benzene, formaldehyde, or other chemical substances that may melt and corrode the heating wires under high-temperature sunlight exposure.
7
2
Share

What Causes Low Pressure in the Transmission Driven Gear?

Low pressure in the transmission driven gear can lead to the vehicle being unable to accelerate, unresponsiveness when pressing the accelerator, and possible abnormal noises. This issue is related to the transmission, caused by internal oil pressure cylinder leakage and wear on the driven gear. Introduction to Automotive Transmission: Automotive transmission primarily refers to the vehicle's gearbox, which is divided into manual and automatic types. Manual transmissions mainly consist of gears and shafts, achieving speed and torque changes through different gear combinations. Automatic transmissions (AT), on the other hand, are composed of a torque converter, planetary gears, a hydraulic torque variation system, and a hydraulic control system, achieving speed and torque changes through hydraulic transmission and gear combinations. Function of Automotive Transmission: The engine's output speed is very high, with maximum power and torque occurring within a certain speed range. To optimize engine performance, the transmission was developed to coordinate the engine's speed with the actual driving speed of the wheels.
6
4
Share

What Causes Unstable Idle and Shaking After Starting the Car?

After starting the car, the reasons for unstable idle include engine control logic errors and air conditioning control circuit faults. Details are as follows: Engine Control Logic Error: Unable to receive the signal indicating the air conditioning is turned on. When it cannot determine whether the air conditioning is on, the engine control unit (ECU) mistakenly interprets this as a temporary high load and attempts to compensate by increasing the engine speed to offset the idle resistance. When the engine speed drops, it cannot handle the load from the air conditioning compressor, leading to another increase in speed. This back-and-forth adjustment results in unstable idle. Air Conditioning Control Circuit Error: Unable to send the air conditioning activation signal. Similar to the first scenario, because the ECU cannot determine the air conditioning status, it continuously adjusts the idle speed, leading to unstable idle performance.
12
2
Share

What is the size of a 14*2.125 tire in inches?

14*2.125 tire is 14 inches. Below are the specific details about car tire specifications: 1. Specification model representation: Tires are important components of a car, and there are many specification models of tires, with different models suitable for different types of vehicles. The specification model identification is usually on the sidewall of the tire, represented by a series of alphanumeric characters, corresponding to the tire's tread width, aspect ratio, type, rim size, load index, and speed rating. 2. Speed rating: Based on the maximum speed they can withstand, tires can be divided into different speed ratings from A to Z, with the A rating further divided into eight different levels from A1 to A8. Generally, the further back the letter representing the tire's speed rating is in the alphabet, the better the tire's performance.
1
4
Share

How Many Days Does It Take to Check Traffic Violations?

It usually takes 3 to 7 days to check vehicle violations after they occur. Here are the relevant details: 1. Reason: The traffic police team needs time to input and verify the information, with the latest update taking no more than 13 working days. There is a process from the occurrence of the violation to its entry into the online system, involving data collection, organization, review, entry, and transmission. The exact time frame is not yet standardized nationwide. 2. Non-on-site violations: For non-on-site violations, it may take more than 15 days to check. To confirm whether a violation has occurred, you can check online for relevant information one week after the violation.
10
4
Share

Is it still necessary to affix the annual inspection sticker for vehicle inspection now?

No, it is not required. 1. Inspection reform: Vehicle inspection information is now interconnected online. When traffic police conduct roadside checks, they can use PDAs to access the vehicle inspection monitoring system. If an approaching vehicle has not undergone the annual inspection, the system will issue an early warning, eliminating the need for police to visually verify inspection information. 2. Changes in annual inspection: There is no longer a need to obtain a paper annual inspection sticker, meaning it does not need to be affixed to the vehicle's front windshield. However, it is important to note that vehicle owners must apply for an electronic inspection certificate every two years. Since paper annual inspection stickers have been replaced by electronic inspection certificates, inspection centers may still issue paper stickers after a vehicle passes the inspection. Vehicle owners can choose whether to affix the paper sticker and can also view the electronic certificate on their mobile phones.
17
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.