What is the engine model of the Great Wall Haval H6?

1 Answers
SanSienna
07/30/25 2:35am
The engine models of the Great Wall Haval H6 are GW4B15A and GW4C20. The Haval H6 is equipped with two engines: a 1.5-liter turbocharged engine and a 2.0-liter turbocharged engine, both paired with a 7-speed dual-clutch transmission. The 1.5-liter turbocharged engine has a maximum power of 110 kW, a maximum torque of 210 Nm, a maximum power speed of 5,600 rpm, and a maximum torque speed ranging from 1,800 to 4,400 rpm. The 2.0-liter turbocharged engine delivers a maximum power of 145 kW, a maximum torque of 345 Nm, a maximum power speed of 5,500 rpm, and a maximum torque speed ranging from 2,000 to 3,200 rpm.
Was this review help?
17
4
Share
More Forum Discussions

What Causes Trembling While Driving?

Introduction to the causes of trembling while driving: The main fault reason is the increase of carbon deposits in the throttle, intake tract, valves and other parts. When the car is cold, some gasoline is adsorbed, and when the car is hot, this gasoline evaporates, causing the mixture to be too rich when the engine is idling, leading to unstable hot idling. The following are specific reasons: 1. Severe engine carbon deposits: The most common cause of car trembling is a dirty throttle or excessive carbon deposits in the fuel injector. When there is too much carbon deposit inside the engine, the gasoline sprayed by the cold start injector will be largely absorbed by the carbon deposits, resulting in a too lean mixture during cold start, making it difficult to start. 2. Ignition system problems: Check the working condition of the spark plugs, high-voltage wires, and ignition coils. Poor performance of the ignition system or bad spark plug firing can also lead to such faults. 3. Unstable oil pressure: If you have already cleaned the engine carbon deposits, washed the throttle, replaced the oil pads and spark plugs, etc., and still find the car body trembling when idling, it is recommended to go to a 4S shop to check whether the fuel supply pressure and the intake pressure sensor are normal. If the fuel pump supply pressure is abnormal or the intake pressure sensor value is wrong and working poorly, it will cause the car body to tremble. 4. Aging engine components: Car trembling is also related to the aging of engine mounts. Engine mounts are actually the shock absorption system of the engine, responsible for absorbing the slight tremors when the engine is running. If there is a problem with the engine mounts, these vibrations will be transmitted to the steering wheel and the interior of the car, causing trembling when idling.
1
3
Share

Can ETC be installed on the black dots?

ETC devices can be installed on the black dots of the windshield, as long as they do not obstruct the driver's view and can sense the detection equipment of the toll station. However, installing them on the black dots of the windshield also has drawbacks, namely that the solar charging capability of the ETC device may weaken, and over time, it might run out of power. For small cars, the general installation position for ETC is in the upper middle part of the front windshield, while for large vehicles like trucks and buses, the installation position is in the lower middle part. The suitable installation position should be no lower than 1.2 meters and no higher than 2.5 meters, with an installation angle between 30 to 90 degrees. For vehicles with factory-installed or aftermarket explosion-proof film, which may affect the signal transmission of the microwave communication link, the ETC should be installed in the microwave window area. Here are some precautions for installing ETC: Do not obstruct the view; it's best to install it behind the rearview mirror: Many car models have windshields with a large rearward tilt angle, which reduces the driver's field of vision. If this is not considered during ETC installation, it can increase the driver's blind spots. Installing it on the right side behind the rearview mirror can help avoid obstructing the view. Do not affect charging: The ETC electronic tag consumes power but generally does not require charging or battery replacement, as it has a built-in solar panel for self-charging. Therefore, during installation, avoid the black areas on the windshield and positions that might block the solar panel. Once installed, do not remove it arbitrarily: The button in the middle of the adhesive is an anti-removal lever connected to a switch. After the electronic tag is installed, the windshield will press the anti-removal lever in. If the tag is removed arbitrarily, the lever will pop out and trigger the switch, locking the electronic tag and rendering it unusable. You will then need to visit an ETC service point to unlock it. This mechanism is designed to prevent multiple vehicles from sharing one device. When using ETC, note that: the ETC transaction sensing range is 8 meters. To prevent issues caused by the ETC device of the vehicle in front malfunctioning, maintain a distance of more than 10 meters from the vehicle ahead to avoid automatic sensing and paying for the wrong vehicle. The recognition speed for ETC lanes is 20 kilometers per hour; driving too fast may result in failure to read the vehicle's device information and cause payment failure. When using a debit card linked to ETC, insufficient balance can also lead to payment failure.
6
0
Share

What is the best installation location for ETC?

The ETC is generally installed in the upper middle part of the front windshield, while for large vehicles such as trucks and buses, the installation position is in the lower middle part. The appropriate installation position should be no less than 1.2 meters and no higher than 2.5 meters, with an installation angle between 30 and 90 degrees. For vehicles with anti-explosion film or those that have been retrofitted with anti-explosion film, it may affect the signal transmission of the microwave communication link, and it should be installed in the microwave sunroof strip. ETC stands for Electronic-Toll-Collection, which means electronic toll collection system. To apply for ETC, the vehicle owner needs to provide the original and photocopy of their valid ID card and vehicle license. If the application is not made by the owner, the agent's valid ID card is also required. The photocopy of the vehicle license should include the page with the most recent annual inspection stamp. A bank card for deducting highway tolls is also needed, and the vehicle must be registered under the name of an individual aged between 18 and 60. Documents required for company vehicles: Introduction letter from the vehicle owner (with official seal); Copy of the organization code certificate or business license (with official seal); Original ID card of the agent; Original vehicle license; Vehicle that needs to apply for ETC. Here are the precautions for installing ETC: Do not block the view, it is best to install it behind the rearview mirror: Many car models have a large inclination angle of the windshield, resulting in a smaller driver's field of vision. If this is not considered when installing ETC, it will increase the driver's blind spot. Install it behind the right side of the rearview mirror to avoid blocking the view. Do not affect charging: The ETC electronic tag consumes power, but generally does not need to be charged or have its battery replaced, as there is a solar panel on its back that can charge itself. Therefore, during installation, avoid the black areas on the windshield and do not install it in a position that easily blocks the solar panel. Once installed, do not remove it at will: The button in the middle of the adhesive is an anti-removal guide rod, connected to a switch below. After the electronic tag is installed, the windshield will press the anti-removal guide rod in. If it is removed at will, the anti-removal guide rod will pop out and trigger the switch, locking the electronic tag and making it unusable. You will need to go to the ETC service point to unlock it. This is designed to prevent multiple vehicles from sharing one device. Precautions for using ETC: The ETC transaction sensing area is 8 meters. To prevent the ETC device failure of the vehicle in front, keep a distance of more than 10 meters from the vehicle in front to avoid automatic sensing and paying for the vehicle in front; The recognition speed of the ETC lane is 20 kilometers per hour. If the speed is too fast, the vehicle device information cannot be read, resulting in a failed deduction; When using a debit card to bind ETC, insufficient balance will also lead to a failed deduction.
2
4
Share

How to Delete Videos from the Dash Cam?

Directly select and delete unwanted videos on the dash cam. Below is a detailed introduction about automotive dash cams: 1. Overview: A dash cam is a device that records images, sounds, and related information during vehicle travel. After installation, it can document the entire driving process through video and audio, providing evidence for traffic accidents. 2. Video Editing Prohibited: The recorded footage must not be edited. If altered, it cannot assist in determining liability after an accident. This measure helps prevent potential fraudulent claims.
4
5
Share

Does the Porsche 718 have a four-seater model?

Porsche 718 does not offer a four-seater model. Here are the relevant details about the Porsche 718: 1. Dimensions: The Porsche 718 measures 4379*1801*1295mm in length, width, and height, with a wheelbase of 2475mm. 2. Performance: The Porsche 718 2.0T model features an entry-level powertrain with 250 horsepower paired with a 7-speed wet dual-clutch transmission, known as the 'golden combination'. The high-power 2.0T model can deliver up to 300 horsepower, with 0-100 km/h acceleration times of 5.6 seconds and 4.9 seconds, offering very linear throttle response.
5
1
Share

How many years can a car battery generally last?

Automotive batteries typically last around 2 years. Functions of car batteries: Power the starting system, ignition system, and electronic fuel injection system during engine startup; supply power to vehicle electrical equipment when the engine is stopped or at low idle; act as a voltage stabilizer for the entire vehicle electrical system; store excess electrical energy generated by the alternator. Car battery maintenance methods: Clean the accumulated white acid corrosion powder on battery terminals to extend service life; add distilled water to the level between the upper and lower indicator lines; check whether the battery is charging normally.
4
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.