What is the emission standard for a 2009 car?

1 Answers
StTeagan
07/25/25 4:57pm
2009 cars are either China III or China IV emission standard. Cars produced between July 2007 and September 2009 are generally China III standard, while those after September 2009 are mostly China IV standard. Here are methods to check your vehicle's emission standard: 1. Check the back of the vehicle's environmental protection compliance label - the emission standard is clearly marked there. 2. Look at the first page of the vehicle qualification certificate. While it doesn't directly state "China III/IV", the emission standard is indicated through a series of characters. 3. You can roughly estimate the emission standard based on the vehicle's production year. 4. Take the vehicle registration certificate to your local vehicle management office for verification. Both the original and photocopy are acceptable for this query.
Was this review help?
1
5
Share
More Forum Discussions

Why is the MG5's fuel consumption so high?

MG5 average fuel consumption: 5.6~9.8L/100km, MIIT comprehensive fuel consumption: 5.6~7.8L/100km. The reasons for high fuel consumption are as follows: Abnormal tire pressure: Incorrect tire pressure can also affect the car's fuel consumption. When the tire pressure is too low or the tread is severely worn, the contact area between the tire and the road surface increases, friction increases, rolling resistance increases, and fuel consumption naturally rises. Excessive load: Long-term transportation of heavy loads increases the vehicle's weight, leading to greater driving pressure and higher fuel consumption. Car sensor failure: This is also a major cause of increased fuel consumption. When the water temperature sensor fails, it makes the engine mistakenly think the car is in a cold state, continuously sending signals to inject fuel, resulting in higher fuel consumption.
4
4
Share

When Did Henan Province Implement the China VI Emission Standard?

The Department of Ecology and Environment of Henan Province issued the "Announcement No. 5 [2019] of the Department of Ecology and Environment of Henan Province on the Implementation of the National Phase VI Vehicle Emission Standards," declaring that the "China VI Emission Standard for Motor Vehicles" would be officially implemented in Henan Province starting from July 1, 2019. According to the announcement, the "China VI Standard" in Henan Province is implemented in phases: 1. Phase One: Starting from July 1, 2019, light-duty vehicles sold and registered within the administrative region of Henan Province must comply with the "Limits and Measurement Methods for Emissions from Light-Duty Vehicles (China VI)" (GB18352.6-2016) Phase 6a or 6b standards. Gas-powered vehicles produced, imported, sold, and registered in Henan Province must meet the "Limits and Measurement Methods for Emissions from Heavy-Duty Diesel Vehicles (China VI)" (GB17691-2018) Phase 6a or 6b standards. Urban-use diesel vehicles sold and registered in Henan Province must comply with the "Limits and Measurement Methods for Emissions from Heavy-Duty Diesel Vehicles (China VI)" (GB17691-2018) Phase 6a standards. 2. Phase Two: Starting from July 1, 2020, all urban-use heavy-duty diesel vehicles produced or imported within the administrative region of Henan Province must comply with the "Limits and Measurement Methods for Emissions from Heavy-Duty Diesel Vehicles (China VI)" (GB17691-2018) Phase 6a standards. 3. Phase Three: Starting from July 1, 2021, all heavy-duty diesel vehicles produced, imported, sold, and registered within the administrative region of Henan Province must comply with the "Limits and Measurement Methods for Emissions from Heavy-Duty Diesel Vehicles (China VI)" (GB17691-2018) Phase 6a standards.
11
3
Share

Can a motorcycle battery be charged directly on the vehicle?

1. Yes, it can be charged on the vehicle, but ensure the vent holes are unobstructed. Most importantly, avoid overcharging. The charging duration should be determined based on your charger's power and the battery's discharge level. 2. Pay special attention to connecting the positive and negative terminals correctly and ensuring the vent tube near the battery is not blocked. Motorcycle batteries typically have a small capacity, around 5AH-9AH, and are 12V batteries. Therefore, set the charger to around 12V1A. For a 7AH battery, it takes approximately 7 hours to fully charge. 3. Do not start the motorcycle or turn on high beams during charging, as this can damage the charger. Before charging, clear the vent holes on the battery's filler caps to ensure they are not blocked. This allows proper ventilation even when the battery generates a lot of bubbles during charging. Additionally, ensure the live wire (the red one) connected from the battery does not come into contact with the vehicle to prevent short circuits.
14
3
Share

What is the 0-100km/h acceleration time for the CHR Hybrid?

First, set the Toyota CHR to sport mode. With a full-throttle start, there will be slight wheel spin on the front wheels, but this does not affect the car's response. The body reacts promptly, and the initial acceleration feels strong. The final 0-100km/h test result is 9.32 seconds. As a compact SUV, the Toyota CHR's fuel consumption should not be very high. According to the combined fuel consumption data released by the Ministry of Industry and Information Technology, the CHR's fuel consumption is 5.7L/100km. Of course, this figure is not the actual fuel consumption. Based on independent tests by owners, the actual fuel consumption of the Toyota CHR is around 6.8L/100km. This model performs well in terms of power. First, the fuel consumption is relatively low, and the 0-100km/h performance is quite good.
16
2
Share

How to Distinguish Between a 6-Volt and 12-Volt Motorcycle Battery?

Motorcycle batteries come in two types: 6-volt and 12-volt. However, 6-volt batteries were used in older models without electric starters and are now obsolete. So, how can you tell if a motorcycle battery is 6-volt or 12-volt? Here are some methods: 1. Use a multimeter to directly measure the voltage. 2. Each battery cell is 2 volts. If the battery has a transparent casing, you can count the number of cells: 3 cells indicate 6 volts. For opaque casings, remove the top cover and count the number of holes. For example, a battery with 6 holes is 12 volts. 3. If you can find the model or specifications on the casing, you can look up the voltage value online. Some batteries even have the voltage value printed directly on them.
3
2
Share

Is the rear seat space of the Toyota C-HR very small?

The rear seat space of the Toyota C-HR is not very small. Here is more information about the Toyota C-HR: 1. Exterior: The new car features boomerang-shaped taillights similar to the Civic Coupe, with black mirror housings, body panels, spoilers, and a floating C-pillar adding a touch of crossover sportiness. 2. Interior: The overseas version is equipped with an 8-inch multimedia touchscreen, and the extremely minimalist center console button layout ensures a clean visual effect. Additionally, the new car comes with an upgraded Toyota HMI human-machine interface system as the vehicle's multimedia information system. 3. Powertrain: The overseas 1.2T model has a maximum output of 85kW (116PS) and a peak torque of 200N·m, paired with a simulated 7-speed CVT automatic transmission. The hybrid model is equipped with a 1.8L Atkinson-cycle four-cylinder engine + two electric motors, delivering a combined output of up to 90kW (122PS) with a thermal efficiency exceeding 40%.
19
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.