What is the emission standard for 2009 cars?

2 Answers
VonAaron
07/25/25 8:17am
2009 cars comply with the China IV emission standard. Below is relevant information about China IV: 1. Introduction: The China IV emission standard is the fourth-phase national standard for motor vehicle pollutant emissions. Automobile emissions mainly include HC (hydrocarbons), NOx (nitrogen oxides), CO (carbon monoxide), PM (particulate matter), etc. Through technologies such as improved catalytic converter active layers, secondary air injection, and exhaust gas recirculation systems with cooling devices, it controls and reduces vehicle emissions below specified limits. 2. Issues: From a management perspective, local governments clearly dominate in negotiations with automakers - non-compliant vehicles cannot be sold, which has caused significant anxiety among manufacturers with "China III" models. However, local governments may be at a disadvantage when negotiating with giants like Sinopec and PetroChina.
Was this review help?
18
3
Share
OChloe
08/10/25 6:53pm
As someone familiar with automotive details, I understand that most cars produced in China in 2009 complied with the China III emission standards. China's emission standards were gradually upgraded in the 2000s: China I was implemented around 2000, China II was promoted in 2004, and China III became the primary standard in 2007 until it was replaced by China IV in 2010. The year 2009 was right in the transition period, so newly manufactured vehicles were predominantly China III. In some major cities like Beijing and Shanghai, due to early policy adoption, certain models might have met China IV, but overall, China III was the mainstream. To confirm this, you can check the explicit labeling on the vehicle registration certificate or the environmental protection label on the front windshield. Many car owners at that time overlooked the standards, but today, traffic restriction policies, such as bans in urban core areas, have made this information crucial. Understanding it helps ensure smooth vehicle inspections and avoids unnecessary trouble, as differences in emission standards impact air quality and daily use.
Was this review help?
9
3
Share
Expand All
More Forum Discussions

Should the motorcycle fuel switch be turned up or down?

Motorcycle fuel switch should be turned up. The switch labeled 'fuel' is the fuel tank valve. On most models, turning the lever upward (with the arrow pointing downward) accesses the reserve tank, while turning it downward (with the arrow pointing upward) accesses the main tank. A horizontal position indicates the off state. Additional information about motorcycles is as follows: Definition: A motorcycle is a two- or three-wheeled vehicle powered by a gasoline engine, steered by handlebars for front-wheel direction. It is lightweight, agile, and fast, widely used for patrols, passenger and cargo transport, and also serves as sports equipment. Motorcycles are categorized into street bikes, road racing motorcycles, off-road motorcycles, cruisers, and tourers. Basic components: A motorcycle consists of five main parts - the engine, transmission system, running gear, steering and braking systems, and electrical instrumentation equipment. This includes the overall structure and names of various components.
5
4
Share

Why is there no music when my Buick is connected to Bluetooth?

The reasons for no sound when playing music via Bluetooth connection are: the volume on the car navigation system or phone is not turned on; the music playback program has a different pairing code with certain car models; the multimedia music function of the car Bluetooth is not enabled; the media audio on the phone is not turned off, causing signal interference with the Bluetooth function. Below are specific methods to play music from your phone in the car: 1. USB drive: Download music from the internet and copy it to a USB drive, then connect it to the car's USB port to play music. 2. AUX audio cable connection to the phone: Use an AUX car audio cable to connect one end to the phone and the other end to the car's player to play music. 3. Car Bluetooth connection to the phone: Open the car's multimedia settings and select the [Bluetooth] function. Enable the car's Bluetooth connection function, connect to the phone, and then you can play music from the phone.
7
3
Share

What is the distance between 5 stakes for motorcycles?

In the two-wheeled motorcycle subject two slalom test, there are 5 stakes with a spacing of 2.3 meters and a stake length of 1.1 meters. 2.3 multiplied by 5 equals 11.5 meters. Therefore, the distance for five stakes is 11.5 meters. Passing score: For motorcycles, subject two and subject three are usually taken together at the test site, with a passing score of 80 points for both. Subject two is the slalom test (touching one stake deducts 10 points, hitting one stake deducts 20 points, and if any wheel runs over the edge line of the stake path, it results in failure). Motorcycle test requirements: Navigate through 5 stakes in an S-shape with a spacing of 2.5m. There is a little over 1m of white line on both sides. Crossing the line, hitting a stake, or stalling results in failure. After completing the slalom, circle around and navigate back through the stakes.
3
2
Share

Why can't the motorcycle exceed 60 km/h?

The reasons why a motorcycle cannot exceed 60 km/h are as follows: Low fuel: A lean air-fuel mixture causes insufficient piston thrust after ignition combustion, prolongs combustion time, and leads to engine overheating. The symptoms of a lean mixture include poor acceleration during operation, temporary improvement when manually adjusting the choke or pumping fuel, and recurring weak acceleration without enriching the mixture - indicating a fuel-deficient state. Rich fuel: An overly rich air-fuel mixture causes weak acceleration at low speeds. The lack of sufficient oxygen during combustion of a rich mixture results in incomplete combustion, reduced power output, decreased fuel efficiency, and excessive carbon buildup that clogs exhaust components, worsening the weak acceleration. Clogged air filter or high carburetor float level: This can cause carburetor float chamber overflow; loose carburetor main jet; poor enrichment system reset; or blocked carburetor main air jet. Poor fuel quality or incorrect gasoline octane rating: May cause engine knocking; expired gasoline decomposes and loses calorific value; water in fuel causes intermittent engine operation and backfiring; presence of other contaminants in gasoline.
7
0
Share

What is the equivalent car engine displacement for a 300cc motorcycle?

A 300cc motorcycle is equivalent to a 0.3-liter car engine displacement. The 300cc in motorcycles refers to the engine's combustion chamber displacement of 300 milliliters. Definition of Displacement: A specialized term in hydraulic transmission, it refers to the volume of fluid inhaled or expelled per stroke or cycle. Motorcycle Displacement Categories: Motorcycles are primarily categorized by displacement into small, medium-small, medium-large, and large displacement. Small Displacement: Less than 50-90cc, including 50, 70, 80, 90, etc. Large Displacement: Ranging from 500-900cc, including 500, 600, 750, 900, etc. Optimal Displacement for 1.5 km: 50cc; for 15 km: 250cc; for 150 km: over 400cc. 150cc and Below: These belong to small-displacement motorcycles, typically used for scooters and certain models, often referred to as 'grocery-getters' and are the best choice for urban commuting motorcycles.
4
2
Share

Will Leaving the Car Unlocked Drain the Battery?

Leaving the car unlocked while parked will consume some battery power, although the amount is minimal. Even when the vehicle is locked, it still consumes power to maintain the anti-theft function and for daily battery usage. However, when the car is left unlocked, the door lights remain on continuously. Although the power consumption is low when leaving the car unlocked, it is a very bad habit. More relevant information is as follows: Note 1: Leaving the car unlocked while parked can cause some damage to certain components of the vehicle. For example, the BCM (Body Control Module) will remain in an active state, which also consumes power. Moreover, even without the key, when the doors are opened, both the front and rear hazard lights will illuminate because the door sensors and the control circuits remain active when the car is unlocked. Note 2: Modern cars, with more configurations than older models, maintain a minimum current of about 80mA. Features such as power windows, power seats, and audio systems all require battery power to function properly. Therefore, when the car is left unlocked, it will consume a small amount of power. Additionally, the battery itself discharges over time. So, whenever the battery gauge indicates that the charge is too low, it is important to recharge it promptly. This ensures sufficient power and can also help extend the battery's lifespan.
4
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.