What is the driving method for an S-shaped curve?

1 Answers
MacNolan
07/30/25 8:55am
Driving method for an S-shaped curve: 1. When initially entering the S-curve, position the car as close to the middle of the curve as possible; 2. Inside the curve, if the left side of the car is far from the curve line, turn the steering wheel to the left; if the right side is far, turn the steering wheel to the right; 3. When encountering a narrower section in the middle, stay calm and avoid excessive steering wheel movements—make slight adjustments. The steering wheel should follow the direction of the curve naturally, with your hands moving as your eyes guide them. Focusing too much on the steering wheel can easily lead to crossing the line. Throughout the process, keep the speed as slow as possible and maintain good control. Driving too fast may result in delayed reactions and crossing the line, while driving too slowly may cause the vehicle to stall.
Was this review help?
15
0
Share
More Forum Discussions

What is the fuel consumption per 100 kilometers for the Audi Q2L?

Audi Q2L's fuel consumption per 100 kilometers is 6.1 liters. Taking the 2021 Audi Q2L as an example, its body dimensions are: length 4236mm, width 1785mm, height 1548mm, wheelbase 2628mm, minimum ground clearance 142mm, fuel tank capacity 50 liters, and the body structure is a 5-door, 5-seat SUV. The 2021 Audi Q2L is equipped with a 1.4T turbocharged engine, with a maximum power of 110kW and a maximum torque of 250Nm, paired with a 7-speed dual-clutch transmission. It adopts a front suspension type of MacPherson independent suspension and a rear suspension type of multi-link independent suspension.
4
4
Share

How to adjust the audio system in Changan CS75?

To adjust the audio system in Changan CS75, follow these steps: Open the settings on the central control screen, locate the sound effects settings, and adjust the equalizer. The Changan CS75 is a compact 5-door, 5-seat SUV with body dimensions of 4650mm in length, 1850mm in width, and 1715mm in height, with a wheelbase of 2700mm. It is equipped with a 1.5T turbocharged engine and a 6-speed manual transmission, delivering a maximum power of 131 kW and a maximum torque of 265 Nm. The drivetrain is front-wheel drive, with a MacPherson independent suspension at the front and a multi-link independent suspension at the rear.
7
5
Share

Do turbocharged cars need to warm up?

Turbocharged cars do need to warm up. Turbocharging is a technology that uses the exhaust gas produced by internal combustion engine operation to drive an air compressor, with the purpose of increasing engine air intake and thereby enhancing engine power and torque. Turbocharging systems are divided into constant-pressure turbocharging systems and pulse turbocharging systems. The functions of turbocharging are: 1. Significantly increase engine power and torque without increasing engine displacement; 2. Turbocharged engines are more fuel-efficient, reducing emissions of CO (carbon monoxide), CH (hydrocarbons), and PM (particulate matter); 3. Turbocharged engines have a simple structure, are easy to install, and have broad technical adaptability.
19
4
Share

How to Bleed the Air from the Chevrolet Cruze Clutch Slave Cylinder?

The method to bleed the air from the Chevrolet Cruze clutch slave cylinder is as follows: 1. Use a plastic hose with one end attached to the bleed screw of the slave cylinder and the other end connected to a transparent container, then slowly pump the clutch pedal repeatedly; 2. If the clutch pedal is pumped too quickly, the air in the cylinder may not be fully expelled, and the pedal must be returned to the highest position each time it is released; 3. One person should hold down the clutch pedal while another loosens the bleed screw to allow hydraulic fluid to flow into the transparent container, then tighten the bleed screw and repeat the process; 4. The expelled hydraulic fluid will contain dissolved air and must sit for at least 30 minutes before reuse. Finally, refill the reservoir to the normal oil level.
2
3
Share

What are the differences between Toyota Corolla and Levin?

Toyota Corolla and Levin differ in the following aspects: 1. Exterior design: Corolla adopts a horizontal-span design; Levin features a hexagonal lower air intake design. 2. Powertrain: Corolla is equipped with a 1.2L turbocharged engine and CVT transmission; Levin also comes with a 1.2L turbocharged engine and CVT transmission. 3. Interior style: Corolla follows American styling; Levin embodies European aesthetics. 4. Dimensions: Toyota Corolla measures 4635mm in length, 1780mm in width, and 1455mm in height; Levin's dimensions are 4640mm long, 1780mm wide, and 1455mm tall.
2
5
Share

Where is the air filter of BYD S7 located?

The air filter of BYD S7 is located behind the glove box. After unscrewing the plastic screws and opening the cover plate, it can be seen. The steps for replacing the cabin air filter are as follows: 1. Unscrew the two plastic screws on both sides of the glove box; 2. Remove the damping buckle on the right side of the glove box and take off the plastic panel; 3. After removing the plastic panel, there are blue and white wires. Unplug the connectors of the two wires to remove them; 4. After replacing the new cabin air filter, install the plastic panel in the reverse order of disassembly. The functions of the cabin air filter: 1. Filter the air entering the cabin; 2. Absorb moisture in the air; 3. Keep the air clean and prevent bacterial growth.
14
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.