What is the difference between Haval Red and Blue badges?

What does it mean when the BMW X6 displays 4x4 and DSC faults?

When the DSC fault light on the dashboard comes on, it indicates that the vehicle stability control system may have a malfunction, and the DSC is not functioning at this time. Here is an introduction about the fault light: Causes: During engine combustion, air intake is required, and in this process, the air filter plays a crucial role. If the car's air filter is not clean and not regularly cleaned, it can affect the car's air intake. Over time, this can lead to blockages, and in severe cases, it can cause the engine fault light to come on. Methods: Check each cylinder's fuel injector. Let the engine idle and disconnect each fuel injector plug one by one to check if there is any change in the idle speed. If disconnecting each cylinder's fuel injector results in roughly the same reduction in idle speed, it means all fuel injectors are working normally. If disconnecting a particular fuel injector does not cause any change in the engine's idle speed or stability, measure the resistance of the fuel injector plug to see if it is between 10~13. If it does not meet the standard, replace the fuel injector.

13

2

Share

How many airbags does the Geely Boyue have?

Geely Boyue has a maximum of 6 airbags. The number of airbags varies depending on the configuration: The main airbags in the Geely Boyue include: driver's front airbag located in the center of the steering wheel. The front passenger front airbag is located in the passenger side instrument panel. Front side airbags, the driver and front passenger seat side airbags are located on the side of the seat back closest to the door (not available in the lowest configuration). Higher-end models also include front and rear head airbags. Attention should be paid when adjusting the driver's seat or steering wheel: The distance between the steering wheel and the chest should not be less than 25 centimeters. If it is less than 25 centimeters, the airbag system cannot provide protection and may pose a life-threatening risk. The lever must be pressed firmly to prevent the steering column from changing position while the vehicle is in motion. If the steering wheel is aligned with the driver's face, the protective effect of the driver's airbag may be compromised in the event of an accident. Therefore, the steering wheel should be aligned with the chest.

6

3

Share

What Components Make Up an Electronically Controlled Fuel Injection System?

Electronically Controlled Fuel Injection System, commonly known as EFI (Electronic-Fuel-Injection), is colloquially referred to as gasoline injection. It primarily consists of three major components: the air supply system (air circuit), the fuel supply system (fuel circuit), and the control system (electrical circuit). Below is a detailed introduction to each component: 1. Main function of the air supply system: To provide the necessary air for the engine and control the air supply during normal operation. It generally includes components such as the air filter, throttle valve, air valve, intake manifold, and intake pipe. Additionally, to regulate the air intake as needed, the intake system is equipped with an air intake detection device. 2. Main function of the fuel supply system: The fuel injector supplies the required fuel for combustion to the cylinder, and the injector sprays fuel based on computer commands. It typically consists of the fuel tank, fuel pump, fuel filter, pressure regulator, and fuel injector. 3. Main function of the control system: Based on signals from various sensors, the computer performs comprehensive analysis and processing, controlling fuel injection volume and other parameters through actuators to ensure optimal engine performance. The control system mainly comprises sensors, input/output circuits, and a microcomputer, with the ECU (Engine Control Unit) serving as the core of the control system.

7

5

Share

How to Solve the Problem of BMW 3 Series Headlights Staying On After Locking the Car?

If the headlights remain on after the car is turned off, you can check whether the headlights inside the car are not turned off. If the vehicle is equipped with automatic headlights, the headlights will turn off after a delay. However, if they stay on continuously after locking the car, you should check whether there is an issue with the circuit. It is recommended to visit a repair shop or a 4S store for inspection. Headlights that stay on for too long may eventually drain the battery, making it impossible to start the car next time. Car headlights, also known as car front lights or car LED daytime running lights, serve as the eyes of the car. They not only affect the owner's external image but are also closely related to safe driving at night or in bad weather conditions. Functions of car headlights: High and low beams: These are important indicators for driving at night. Position lights: Used to display the width and length of the vehicle at night. Fog lights: There are two types, front fog lights and rear fog lights. Front fog lights are installed at the front of the car, slightly lower than the headlights. Turn signals: Activated when the vehicle is turning, they flash intermittently to alert surrounding vehicles and pedestrians.

18

5

Share

How to Set Up One-Touch Power Window Control?

Setting up one-touch power window control is as follows: 1. Turn the ignition switch to the "ON" position. 2. If the driver's side window is closed, use the driver's side window switch to open it more than halfway. 3. Pull up and hold the driver's side window switch to close the driver's side window. After the window is fully closed, continue holding the switch for about 3 seconds, then release. 4. Check if the power window function is working properly, and the one-touch control setup is complete. Additional Information: One-touch power window refers to a system where the car window glass can be fully opened or closed with a single press of a button. Cars equipped with one-touch power windows have a two-stage window control switch. The first stage works like a regular power window switch. The second stage allows the window to automatically open or close completely with just a single press and release of the button. In contrast, regular power windows require the user to hold the switch until the window reaches the desired position, and the movement stops when the button is released.

12

2

Share

Precautions for Engine Installation

Precautions for engine installation are as follows: 1. Maintain a clean environment, preferably with a separate overhaul room; assembly is best performed by 1 to 2 people, with one person taking the lead to avoid forgetting installations or torque tightening due to too many people. 2. Piston installation direction: Generally, pistons have markings, such as small arrows pointing forward or dots on B-series engines. Do not analyze the valve grooves on the piston; the larger groove does not necessarily align with the intake valve. 3. Do not install valve springs upside down: Wuling uses unequal-pitch coil springs, which have a specific installation direction. Generally, the side with yellow markings faces upward. If the markings are unclear over time, remember to place the denser part of the spring downward. 4. Camshaft bearing cap bolts are prone to stripping: The camshaft caps on Wuling B-series engines are made of aluminum alloy and secured with two bolts. Repeated disassembly or excessive force can cause thread stripping. Pay attention here; the standard torque is 12 Nm. 5. Do not mix up bolt types: Be careful not to confuse bolts during installation, as some bolts may have similar lengths and sizes but different thread pitches. Specifically, do not mix up the No. 14 bolts for the Wuling B-series engine manifold with those for the flywheel plate, as their thread pitches differ.

3

1

Share

What is the difference between Haval Red and Blue badges?

What does it mean when the BMW X6 displays 4x4 and DSC faults?

How many airbags does the Geely Boyue have?

What Components Make Up an Electronically Controlled Fuel Injection System?

How to Solve the Problem of BMW 3 Series Headlights Staying On After Locking the Car?

How to Set Up One-Touch Power Window Control?

Precautions for Engine Installation

What does JDM represent in terms of car models?

How Much Horsepower Does the BMW 530 Have?

What is the reason for the radiator overflowing when the cylinder gasket is not damaged?

What is the transmission model of the Tharu 330?