What is the difference between Dongfeng Fengxing and Dongfeng Fengshen?

How to reset the maintenance reminder for a 2015 Focus?

The method to reset the maintenance reminder for a 2015 Focus is as follows: First, turn off the ignition. Press the button at the bottom right of the instrument panel, then turn on the ignition. At this point, you will notice that the maintenance indicator (a small wrench symbol) on the instrument panel stops flashing. Release the button and press the button at the bottom left. You will see that the small wrench symbol on the instrument panel has disappeared, indicating that the maintenance light has been successfully reset. The advantages of the maintenance reminder light include the following three points: 1. Improves vehicle performance: Regular maintenance can enhance the car's performance and extend its lifespan. 2. Saves fuel: Proper vehicle maintenance can help save fuel during driving. 3. Reduces emissions: After a full maintenance service, the car's carbon monoxide emissions during idle driving will be reduced.

7

5

Share

Does running a yellow light count as running a red light?

Running a yellow light and running a red light are both considered the same traffic violation—driving a motor vehicle in violation of traffic signal regulations. According to Article 2 of the "Scoring Standards for Road Traffic Violations," if a motor vehicle driver commits any of the following violations, they will be penalized with 6 points: driving a motor vehicle in violation of traffic signal regulations. The "Road Traffic Safety Law of the People's Republic of China" Article 26 stipulates: Traffic signals consist of red, green, and yellow lights. A red light indicates prohibition of passage, a green light indicates permission to proceed, and a yellow light serves as a warning. Article 38 of the "Road Traffic Safety Law" states: A yellow light serves as a warning, and motor vehicles should slow down when passing through an intersection. If a vehicle has already crossed the stop line when the yellow light is on, it may continue to pass; otherwise, it should stop. Article 38 of the "Implementation Regulations of the Road Traffic Safety Law of the People's Republic of China" specifies the following for motor vehicle and non-motor vehicle signals: When the green light is on, vehicles are permitted to proceed, but turning vehicles must not obstruct the passage of straight-moving vehicles or pedestrians. When the yellow light is on, vehicles that have already crossed the stop line may continue to proceed. When the red light is on, vehicles are prohibited from proceeding. At intersections without non-motor vehicle or pedestrian crossing signals, non-motor vehicles and pedestrians should follow the motor vehicle signal indications. When the red light is on, right-turning vehicles may proceed if they do not obstruct the passage of other vehicles or pedestrians. Electronic police capture red-light running violations based on the following three photos, which are reviewed by traffic police to determine whether a red light was run: An image of the vehicle not having passed the stop line when the red light is on. An image of the vehicle's front wheels pressing against the stop line. An image of the vehicle's entire body having crossed the stop line. If these three photos show that the vehicle moved beyond the stop line while the red light was on, the traffic police can confirm it as a red-light running violation during review. To avoid running a yellow light: Slow down when approaching an intersection, maintain a speed of 20–30 km/h, keep a safe distance from the vehicle ahead, and avoid tailgating or rushing through a yellow light. Alternatively, pay attention to the traffic signal in advance; observe the duration of the green light—if traffic is light and the green light lasts longer, prepare to slow down.

18

3

Share

What is the difference between Toyota C-HR Kuraku and Kuyue?

C-HR Kuraku and Kuyue have the same guide price and configurations, with only slight differences in appearance. Here is the relevant information: 1. The Kuraku has a body size of 4405*1795*1565mm, equipped with a 2.0-liter four-cylinder naturally aspirated engine. The entire series comes with a CVT continuously variable transmission (simulating 10 gears), delivering a maximum horsepower of 171 hp, a maximum power of 126 kW, a maximum torque of 203 N·m, and a top speed of 187 km/h. The combined fuel consumption by the Ministry of Industry and Information Technology is 5.7L/100km. 2. Both the C-HR Kuraku and Kuyue versions feature high safety configurations, including front and rear head airbags, ISOFIX child seat interface, ABS anti-lock braking system, brake force distribution system, brake assist system, traction control system, vehicle stability system, lane departure warning system, and active braking system.

8

2

Share

How Many Kilometers to Replace the Rear Wheel Bearing of the Spirior

The replacement of the rear wheel bearing of the Spirior does not have a fixed mileage requirement. It needs to be replaced only when abnormal noise is confirmed during high-speed driving on smooth roads. Below is an introduction to the bearing: 1. The main function of the bearing is to bear the load and provide precise guidance for the rotation of the hub. It bears both axial and radial loads and is a very important component. 2. When hearing noise from the hub bearing area, first locate the source of the noise. There are many moving parts that may produce noise, possibly due to contact between rotating and non-rotating parts. If the noise is confirmed to be from the bearing, the bearing may be damaged and need replacement. 3. Bearings should be installed in a clean and tidy environment. Small particles entering the bearing can shorten its service life. Maintaining a clean environment during bearing replacement is very important. Do not use a hammer to strike the bearing, and ensure the bearing does not fall to the ground. Before installation, inspect the condition of the bearing and the bearing seat. Even minor wear can lead to poor fit, causing early bearing failure. 4. The seal ring of a bearing equipped with an ABS device contains a magnetic thrust ring. This thrust ring must not be subjected to collisions, impacts, or contact with other magnetic fields. Remove it from the packaging before installation and keep it away from magnetic fields, such as those from motors or electric tools. When installing these bearings, observe the ABS warning needle on the dashboard during road condition tests to adjust the bearing's operation.

15

2

Share

What does 'beggar version' car mean?

Beggar version refers to the lowest configuration version in a car series, generally also called the entry-level model. The definition of 'beggar version' varies for different vehicle classes, but in simple terms, it is the cheapest model in the same series. Features such as sunroofs, seat heating, rearview cameras, power seats, automatic air conditioning, and power rearview mirrors are usually not included. Below is some relevant information: 1. Generally, mainstream brands often use their lowest starting price, i.e., the price of the 'beggar version,' as a selling point in their promotions. Often, when a new car is launched, the first thing people look at is the lowest price, especially for new models from major brands. People are highly interested in these seemingly 'within reach' prices until they see the actual car and sigh in disappointment. 2. The various features advertised at the car's launch do exist, but they are undoubtedly only available in higher-end configurations. However, the automakers' goal of lowering the price point has already been achieved.

11

0

Share

Does the Civic have a tire pressure monitoring system?

The tenth-generation Civic is equipped with a tire pressure monitoring system. The functions of the tire pressure monitoring system include the following 4 points: 1. Proactive safety protection to prevent accidents: Existing safety measures in cars, such as ABS, EDS, EPS, and airbags, are all reactive protections that only come into play after an accident to protect personal safety. 2. Extends tire lifespan: The system ensures that tires operate within a safe pressure and temperature range, thereby reducing tire damage and extending their lifespan. 3. Reduces fuel consumption, benefits the environment, and makes driving more economical. 4. Prevents abnormal wear of vehicle components: Driving with excessively high tire pressure can cause significant damage to the engine chassis and suspension system. Uneven tire pressure can lead to braking deviation, increasing wear on the suspension system.

3

1

Share

What is the difference between Dongfeng Fengxing and Dongfeng Fengshen?

How to reset the maintenance reminder for a 2015 Focus?

Does running a yellow light count as running a red light?

What is the difference between Toyota C-HR Kuraku and Kuyue?

How Many Kilometers to Replace the Rear Wheel Bearing of the Spirior

What does 'beggar version' car mean?

Does the Civic have a tire pressure monitoring system?

Which country is Porsche from?

What are the models of manual transmission fluid?

What to Do When the Charcoal Canister is Clogged?

Does the BYD Qin automatically close windows when locked?