What is the difference between China 6 and China 5 vehicle emission standards?

1 Answers
DeAmara
07/25/25 6:27am
Here are the differences between China 5 and China 6 vehicle emission standards: 1. Price difference: China 6 vehicles are more expensive than China 5 vehicles, mainly because China 6 vehicles need to comply with the new policy requirements by adding more configurations. Automakers also need to submit applications to relevant departments and conduct various pollution tests, which increases costs and leads to higher vehicle prices. 2. Access restrictions: With the implementation of China 6 standards, vehicles that do not meet the emission standards will face certain driving restrictions. China 5 and below vehicles will be directly banned from road use due to non-compliance with emission requirements.
Was this review help?
15
1
Share
More Forum Discussions

How to Set One-Touch Power Windows?

Lift the window button directly to raise the window to the top, hold for 3-5 seconds, then release. Next, press the window button to lower the window completely, hold for 3-5 seconds, then release. Below is an introduction to the related content: How one-touch power windows work: The key emits a weak radio wave, which is received by the car's antenna. The electronic control unit identifies the signal code, and then the system's actuator (motor or electromagnetic coil) executes the open/close action. Press and hold the unlock button on the remote, and all four windows will automatically lower; press and hold the lock button, and all four windows will automatically rise.
7
4
Share

Should the Positive or Negative Terminal Be Removed First When Disconnecting a Car Battery?

Remove the negative terminal first. Below are the relevant steps for battery removal: 1. Before replacing the battery, check if it is completely depleted. If the battery is cracked, replace it immediately. If not, inspect both terminals first. Sulfate buildup can corrode the battery terminals. Use a brush dipped in a mixture of baking soda and water to clean them. 2. Turn off the engine before replacement. Carefully loosen the battery screw connected to the negative terminal with a wrench and remove the cable clamp from the terminal. Repeat the same process for the positive terminal. Firmly grasp the battery and remove it from the vehicle. After removal, clean the clamps and battery tray with soda water. 3. During installation, carefully place the new battery in the battery tray. Ensure the positive and negative terminals are correctly positioned, then secure the battery by tightening the bracket. Attach the cable clamps to the positive and negative terminals. Finally, close the hood.
20
4
Share

What is the bulb model for Wuling Hongguang S headlights?

Wuling Hongguang S headlight bulb models: low beam uses H1, high beam uses H7. When replacing bulbs, please note the following two points: 1. The engine must be turned off for 5 minutes before replacing bulbs. 2. Gloves and protective goggles are required. Use alcohol to wipe fingerprints or grease from the outer surface of the lamp housing. Never touch the glass surface of the bulb with bare hands to prevent shortening the bulb's lifespan due to fingerprints contaminating the glass housing. Below are some routine checks for vehicle lights: 1. Check if the front position lights, low beams, high beams, turn signals, hazard lights, and front fog lights are functioning properly. 2. Check if the rear position lights, license plate lights, rear fog lights, brake lights (including the high-mounted brake light, totaling 3), reverse lights, rear turn signals, rear hazard lights, and trunk light are functioning properly. 3. Check if the dashboard indicator lights, interior lights, air conditioning, radio, cigarette lighter, and door window lift indicator lights are functioning properly. 4. Check if the headlight beam is aligned correctly and adjust if necessary.
17
1
Share

What are the causes of idle vibration in new cars?

New car idle vibration can be caused by poor fuel combustion, insufficient ignition energy due to spark plug failure, air leakage in the intake system or low fuel pressure, poor fuel injector atomization, improper idle adjustment, malfunctioning idle control valve or bypass air valve, carbon buildup on valves and intake ports, etc. Here is the relevant content introduction: Intake manifold or various valve leaks. When unwanted air, gasoline vapor, or combustion exhaust enters the intake manifold, it can cause the air-fuel mixture to become too rich or too lean, leading to abnormal engine combustion. When the leakage affects only individual cylinders, the engine will experience more severe vibration, which has a greater impact on new car idle conditions.
6
2
Share

Is Engine Oil the Same as Transmission Fluid?

Engine oil and transmission fluid are not the same. Here are the relevant details: 1. Engine oil is the lubricant for the engine system, possessing properties such as oxidation resistance, wear resistance, and corrosion prevention. Transmission fluid, on the other hand, is primarily used to keep the gear system clean, ensuring the transmission operates normally and extending the lifespan of the transmission components. 2. Transmission fluid is an oil-based product designed to maintain the cleanliness of the gear system, ensuring proper transmission function and prolonging the service life of the transmission components. Most transmission fluids are compatible with automatic transmissions on the market. However, each automatic transmission design has unique technical requirements. Even the same model of transmission configured in different vehicle models may differ in torque, weight, speed, and structure. Therefore, manufacturers specify their own dedicated transmission fluid. Different transmission fluids can significantly impact shift quality.
11
2
Share

Where is the sunroof button on the Mercedes-Benz E300L?

The sunroof button of the Mercedes-Benz E300L is located at the position of the front reading light, which is directly above the center console. The button is of a push-pull type. To open the sunroof, pull the button backward once. To close the sunroof, push the button forward once. The following is an introduction to the Mercedes-Benz E300L model: 1. All functions of the Mercedes-Benz E300L are controlled via buttons on the steering wheel. 2. The Mercedes-Benz E300L is a specially extended version designed for the Chinese automotive consumer market. It is a domestically produced Mercedes-Benz, with the extended wheelbase entirely aimed at meeting the needs of Chinese consumers. 3. The 2019 Mercedes-Benz E300L was launched in two models: a Sport Fashion version and a Sport Luxury version.
18
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.