What is the difference between C1 and C2 driving license tests?

What are the usage rules for variable lanes?

Variable lanes are used according to their changing directions. Vehicles entering a variable lane must follow the direction indicated by the signage. The direction of a variable lane is determined by traffic flow—when left-turn traffic is heavy, the variable lane will switch to left-turn mode to alleviate pressure, and similarly, it will switch to right-turn mode when right-turn traffic is heavy. Once the lane changes to a turn-only direction, straight-through driving is no longer allowed, as the lane typically alternates between turning and straight-through directions. This type of lane is primarily designed for sections where traffic is concentrated during peak hours but lanes are insufficient, or where traffic flow differs significantly between morning and evening rush hours. Based on the characteristics of traffic flow during different periods, the direction is flexibly adjusted to alleviate congestion. Once a vehicle enters a variable lane, it must follow the direction indicated by the overhead signage. After entering a variable lane, drivers must not cross the line to change lanes, as this may result in a fine and a 3-point penalty if caught by electronic enforcement. Vehicles in a variable lane are also prohibited from making U-turns or speeding, which may likewise lead to fines and a 3-point penalty. The direction of the variable lane will not change if there are vehicles within 100 meters of the stop line. Violations occur only when drivers fail to follow the required direction—for example, driving straight when the lane is marked for left turns will definitely result in a penalty.

9

1

Share

What does the yellow exclamation mark light on the Roewe dashboard indicate?

When a yellow exclamation mark appears on the car dashboard, there are four possible scenarios: general malfunction, automatic transmission failure, abnormal tire pressure, or lighting system failure. Below is a detailed analysis of each situation: General Malfunction: A triangle with an exclamation mark inside indicates a fault in the vehicle's general performance, components, or functions. Common issues include parking sensor failure, fuel cutoff system intervention or malfunction, external light failure, or engine oil pressure sensor malfunction. It is recommended to visit a 4S shop for inspection to identify the source of the problem. Automatic Transmission Failure: A yellow gear with an exclamation mark inside is the automatic transmission warning light, signaling a transmission fault or insufficient transmission fluid. Immediate replacement of transmission fluid is necessary. Abnormal Tire Pressure: An exclamation mark inside a horizontal line under a parenthesis represents the tire pressure monitoring warning light. This light illuminates when the tire pressure is too low. Check the tire pressure and adjust it to the normal range. Lighting System Failure: A yellow bulb with an exclamation mark is the lighting fault indicator, indicating a malfunction in one of the vehicle's lights. Solution: Visit a 4S shop for inspection as soon as possible, or perform a self-check focusing on commonly used bulbs such as turn signals, fog lights, and interior lights to identify the issue. Additionally, a red exclamation mark inside a circle with parentheses indicates a brake system warning, typically signaling brake system failure or low brake fluid level. Immediate inspection and repair of the brake system are required to prevent accidents.

8

5

Share

What is the voltage of BMW's wake-up line?

BMW wake-up line voltage depends on the voltage of the power battery pack used in the electric vehicle. The charging voltage should be slightly higher than the battery pack voltage. Introduction to Wake-up Line: The wake-up line reactivates electrical appliances or modules that are in sleep mode before starting the car. The wake-up line is controlled by CAS. Simply put, the wake-up line activates the vehicle's circuit system. Introduction to Sleep Line: Opposite to the wake-up line is the sleep line, which gradually shuts down electrical appliances when the car is turned off. The wake-up line reactivates these sleeping electrical appliances before starting the car, and it is controlled by CAS.

11

0

Share

Where is the BMW 425 wheel lock key located?

BMW 425 wheel lock key is located in the trunk. Tire removal method: First, turn counterclockwise to loosen and clockwise to tighten. Loosen the tires counterclockwise. Since the wheel fixing bolts are very tight, you can use your full body strength. After loosening each bolt one by one, use a jack to partially lift the vehicle. Precautions when using a jack: There are many jack placement slots on both sides of the underbody. Be sure to place the jack in these slots to avoid accidents. After the jack is raised, remove the loosened bolts one by one, then the entire tire can be taken off, which means the tire removal is successfully completed.

12

2

Share

What Causes the Nissan X-Trail to Shake When Accelerating Uphill?

Nissan X-Trail shaking when accelerating uphill can be attributed to the following reasons: Carbon Buildup in the Engine: Carbon deposits can accumulate in various parts such as the cylinders, throttle body, spark plugs, and intake system. These components are crucial for the engine's power output. Excessive carbon buildup reduces ignition efficiency and intake airflow, ultimately diminishing engine power and causing shaking and sluggish acceleration. Fuel System Malfunction: Using an incompatible fuel grade can decrease the vehicle's power output and performance. Alternatively, a clogged fuel tank vent may restrict the necessary fuel supply, leading to a lean air-fuel mixture and weak engine acceleration.

4

3

Share

What is the engine number of the imported Corolla?

The engine number is the relevant information of the engine labeled by the manufacturer according to relevant regulations or industry practices, so the engine model is inconsistent, and the number is also inconsistent. Contents of the engine number: The order of the engine number and its contents vary by different manufacturers; it generally includes the engine model, production date, and the serial number randomly assigned when the engine comes off the production line. Some may also include the origin code. Uniqueness of the engine number: The uniqueness of the engine number is also to make it traceable, so that when problems are found with the engine or the manufacturer conducts an investigation, it is easy to track and obtain feedback.

13

0

Share

What is the difference between C1 and C2 driving license tests?

What are the usage rules for variable lanes?

What does the yellow exclamation mark light on the Roewe dashboard indicate?

What is the voltage of BMW's wake-up line?

Where is the BMW 425 wheel lock key located?

What Causes the Nissan X-Trail to Shake When Accelerating Uphill?

What is the engine number of the imported Corolla?

Does CVT Have Jerking Sensation?

Can a Car Remote Key Still Work After Being Washed? How to Fix Malfunctions?

What is the failure rate of the X-Trail transmission?

What is the difference between Toyota 1GR and 1GR-FE?