What is the difference between 2.0L and 2.0T?

Can the vehicle annual inspection time be postponed?

Vehicle annual inspection time cannot be postponed. The following explains the reasons: 1. The vehicle owner can apply for inspection and obtain the inspection qualification mark at the vehicle registration office within three months before the expiration of the vehicle inspection validity period; 2. For example, if the vehicle's annual inspection validity period is December, the vehicle participating in the annual inspection can go to the vehicle inspection center for annual inspection from October to December; 3. If the annual inspection is not completed on time, the vehicle owner will be fined by the traffic police department, with 3 points deducted, and if the vehicle has not been inspected for 3 consecutive cycles, it will be forcibly scrapped.

5

2

Share

Does a Newly Replaced Clutch Need a Break-in Period?

A newly replaced clutch does require a break-in period. Here are some precautions to take during the clutch break-in period: 1. Regarding speed, there's no need to maintain a constant speed, but avoid exceeding two-thirds of the maximum speed. Keep the engine RPM below 3000-3500 (requirements may vary by manufacturer). Avoid sudden acceleration or hard braking. 2. Do not overload the vehicle. Regularly check tire pressure, coolant level, and brake fluid. 3. When driving downhill for extended periods, control your speed carefully. Avoid abrupt engine braking. For manual transmission vehicles, anticipate gear shifts in advance and avoid shifting at inappropriate speeds.

17

3

Share

What are the precautions for using waterless coolant?

Precautions for using waterless coolant are as follows: 1. After switching to engine waterless coolant, do not add water or other coolants to avoid affecting the optimal performance of the product. 2. If you find that the waterless coolant is insufficient during driving and the engine temperature is slightly high, and there is no waterless coolant in the car, you can add some purified water as an emergency solution. Then, when conditions permit, completely replace the coolant with high-quality waterless coolant to restore the original performance of the vehicle. The following are the usage restrictions for waterless coolant: 1. For vehicles with more than 30,000 kilometers, the cooling system must be thoroughly cleaned with a cooling system cleaner before application to prevent deposits in the water passages. 2. New vehicles or those with less than 30,000 kilometers do not require cleaning.

13

3

Share

Why is the car air conditioning compressor not starting?

There are several reasons why a car's air conditioning compressor may not start: 1. It is very likely due to compressor circuit issues. Disconnect the power supply to the compressor relay and bridge the compressor pins to make the compressor engage. 2. Another possibility is that the intake air temperature sensor or temperature control sensor in the air conditioning system is damaged, preventing temperature detection and the transmission of electrical signals, which stops the compressor from engaging. In this case, simply replacing the temperature control sensor will solve the problem. 3. Other factors such as insufficient refrigerant in the car air conditioning compressor or a faulty relay could also prevent the compressor from engaging.

14

0

Share

The Difference Between Direct Injection and Multi-Point Electronic Injection

The main differences between direct injection and multi-point electronic injection are as follows: 1. In multi-point electronic injection, the injectors are installed on the intake manifold, where fuel and air begin to mix before entering the cylinder; direct injection sprays fuel directly into the cylinder. 2. Compared to direct injection, multi-point electronic injection has lower requirements for fuel quality; direct injection has more complex components and is more expensive than multi-point electronic injection. 3. Multi-point electronic injection technology is mature and cheaper but consumes more fuel; direct injection has advantages in both performance and fuel consumption. 4. Multi-point electronic injection has higher combustion efficiency and can release more power compared to direct injection of the same displacement.

16

0

Share

How to Protect Your Car from Sun Damage in Summer?

Methods for protecting your car from sun damage in summer are as follows: 1. Leave appropriate window gaps when parking: The excessively high temperature inside the car is due to it being too sealed. Continuous exposure to sunlight will continuously accelerate the temperature inside the car, while the scorching air inside cannot dissipate, leading to an increasingly hotter interior that is much warmer than the outdoor temperature. Leaving a two to three-finger gap in the windows can prevent excessive temperature differences between the inside and outside. 2. Park in the shade: The most direct source of high temperature inside the car is sunlight. Parking in the shade effectively avoids direct sunlight, not only lowering the car's temperature but also reducing paint damage, thereby decreasing the frequency of car maintenance.

20

3

Share

What is the difference between 2.0L and 2.0T?

Can the vehicle annual inspection time be postponed?

Does a Newly Replaced Clutch Need a Break-in Period?

What are the precautions for using waterless coolant?

Why is the car air conditioning compressor not starting?

The Difference Between Direct Injection and Multi-Point Electronic Injection

How to Protect Your Car from Sun Damage in Summer?

How to Unlock a Car's Anti-Theft Lock?

How to Distinguish Run-Flat Tires?

What is a Run-Flat Tire?

Do Parallel Imported Vehicles Come with Warranty?