What is the difference between 1.4t and 1.8l?

1 Answers
EmmettAnn
07/29/25 5:13pm
1.4t and 1.8l differ in the following aspects: 1. Different maximum torque of the engine: The 1.4t engine model has a maximum torque of 215nm and a maximum power of 98kw; the 1.8l engine model has a maximum torque of 170nm and a maximum power of 98kw. 2. Different engine systems: 1.4t refers to a 1.4-liter turbocharged engine; 1.8l refers to a 1.8-liter naturally aspirated engine. The turbocharging device can change the intake volume of the engine, allowing the fuel to burn more fully in the cylinder, thereby increasing the engine's output power. The advantage of a turbocharger is that it can significantly increase the engine's power and torque without increasing the engine displacement.
Was this review help?
3
1
Share
More Forum Discussions

What type of engine oil is used for the Honda Lingpai 1.0t?

Honda Lingpai 1.0t uses fully synthetic engine oil with specifications of 0W20 and 5W30. Relevant information about engine oil is as follows: Introduction: Engine oil, also known as engine lubricant (English name: Engine-oil), has a density of approximately 0.91×10³ (kg/m³). It serves multiple functions for the engine including lubrication and wear reduction, auxiliary cooling, sealing and leakage prevention, rust and corrosion protection, as well as shock absorption. It is often referred to as the 'blood' of automobiles. Composition: Engine oil consists of two main components - base oil and additives. The base oil is the primary constituent of lubricants, determining their fundamental properties, while additives compensate for and enhance the performance shortcomings of the base oil, imparting certain new characteristics. Additives are an essential part of lubricants.
5
1
Share

What are the P, R, N, D gears in a car?

In a car, P stands for Parking gear, R stands for Reverse gear, N stands for Neutral gear, and D is the most commonly used Drive gear for forward motion. Below is a partial introduction to car gears: 1. P gear: Parking gear, also used when starting the car. When the car is parked and not in use, it mechanically locks the wheels to prevent rolling. 2. N gear: Neutral gear. Used for temporary stops (such as at a red light). This gear indicates neutral, and to prevent the car from rolling on a slope, the brake must be engaged. 3. Operation steps: To shift gears in an automatic transmission car, simply push the lever to the corresponding gear. Some semi-automatic transmissions may not have as many gears; apart from P, R, and N (these three gears are essential in automatic cars), the forward gear is usually just D (as in the FAW Mazda 6), and the functions of other gears can be achieved through manual mode.
12
4
Share

What Operations Should Be Maintained After a Vehicle Wades Through Water?

After a vehicle wades through water, it should maintain low-speed driving and intermittently lightly press the brake pedal to restore braking effectiveness. Below are related introductions about vehicle wading: 1. Vehicle Wading Insurance: According to insurance terms, wading insurance mainly applies when a motor vehicle is submerged up to the exhaust pipe or intake pipe due to heavy rain or floods, and the driver continues to start the vehicle or uses inertia to start the vehicle; or starts the vehicle without necessary treatment after suffering from heavy rain or floods. In these two cases, wading insurance can compensate for the damage caused. 2. Precautions After Wading: Immediately remove explosive substances from the electrical parts, dry the wet parts, and reinstall the fan belt. Check whether each gearbox has been immersed in water, whether there are drifting objects blocking between the radiator fins of the water tank, whether the tires are damaged, whether there are aquatic plants entangled under the chassis, etc. Clean the vehicle in time to restore braking effectiveness.
17
1
Share

Where are the drainage holes of the Buick Regal located?

Buick Regal has a total of 4 drainage holes, located at the fuel tank cap, the four corners of the sunroof, the lower part of the front and rear doors, and both sides of the front windshield wipers. Among them, the most prone to clogging are the drainage holes in the engine compartment and the sunroof. Below is the relevant introduction: Function: The purpose of the vehicle's drainage holes is to drain accumulated water from the vehicle to the outside during rainy days. During normal driving, if not cleaned in time, it can eventually lead to water ingress inside the vehicle, and in severe cases, may cause irreversible damage to the vehicle's mechanical parts and electronic devices. Precautions: After purchasing a new car, it is essential to promptly check the drainage holes on the doors to ensure they are open. If the drainage hole plugs are not opened, water may accumulate in the trunk during rain or car washing, leading to rust over time and affecting the car's lifespan.
9
3
Share

Should I Replace the Fuel Pump in Honda's Recall?

Honda's fuel pump recall must be addressed by replacement, as failing to do so significantly increases the risk of vehicle accidents. Therefore, owners should follow the manufacturer's recommendation to replace the fuel pump. The Purpose of the Recall: The primary goal of the recall is to eliminate safety hazards, not to provide financial compensation. Thus, it is advised that owners prioritize cooperating with the recall to rectify the defect. For those facing substantial travel expenses due to the distance to the recall service location, communication with the manufacturer or the 4S dealership can help negotiate the coverage of related costs. How the Recall is Conducted: In general, when a vehicle recall is issued, the automaker will contact the owners via phone or community platforms regarding the recall arrangements. Additionally, owners can call GAC Toyota's customer service hotline to inquire and obtain more information about the recall.
16
0
Share

What are the reasons for the Buick LaCrosse not responding when trying to start with electricity?

Buick LaCrosse not responding when trying to start with electricity could be due to the following reasons: Spark plug failure: Check the circuit to see if the spark plug is igniting normally, whether there is any leakage, and whether the high-voltage wire has a high-voltage spark. If there is an ignition coil, check if the ignition coil is faulty. Fuel line blockage: Inspect the fuel line, open the engine's fuel inlet pipe, turn the key to start, and see if fuel comes out. If no fuel comes out, it may be due to a blocked fuel line or the electronic fuel pump not working. Another rare possibility is the ECU being locked due to anti-theft activation. Wiring fault: Issues with the starter or wiring connections can also prevent the car from starting. Additionally, if the battery's starting voltage is below 9.5V, it may also cause the car to fail to start.
18
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.