What is the definition of a multi-purpose truck?

1 Answers
SanKarter
07/24/25 6:27pm
Multi-purpose trucks generally refer to high-performance, lightweight cargo vehicles with four-wheel drive. Below is relevant information: 1. Truck: A truck (Wagon) is a commercial vehicle primarily designed and equipped for transporting goods, whether or not it can tow a trailer. Cargo vehicles are commonly referred to as trucks, also known as lorries, mainly used for transporting goods. Sometimes they may also refer to vehicles capable of towing other vehicles, falling under the category of commercial vehicles. Generally, they can be classified into heavy-duty and light-duty based on vehicle weight. 2. Classification: In fact, China's society has a rather chaotic classification system for trucks. Some classify by total mass, others by engine displacement. The new national standard "Terms and Definitions of Motor Vehicles and Trailers" categorizes trucks under commercial vehicles and further subdivides them into: ordinary trucks, multi-purpose trucks, full-trailer tractors, off-road trucks, special operation vehicles, and specialized trucks.
Was this review help?
19
2
Share
More Forum Discussions

What is the general tire pressure for car tires?

Typically, the inflation pressure for household car tires is between 0.2~0.25MPa. The hazards of either too high or too low tire pressure are as follows: Hazards of too low tire pressure: The friction coefficient with the road surface increases, leading to higher fuel consumption. The friction between the tire and the ground multiplies, causing the tire temperature to rise sharply, the tire to soften, and its strength to drop drastically. When driving at high speeds, this may result in a tire blowout. Hazards of too high tire pressure: The friction and adhesion of the tire decrease, affecting braking performance. It may cause the steering wheel to shake or veer, reducing driving comfort. It accelerates the wear of the tread pattern in the center of the tire, making it prone to bulging or trapping stones. Additionally, it causes excessive stretching and deformation of the tire cords, reducing the elasticity of the tire body. This increases the impact experienced while driving and raises the noise level during travel.
9
3
Share

How Long Can a New Car Sit During the Break-in Period?

New car break-in period generally requires 1 year. Relevant introduction about the new car break-in period is as follows: Fuel-saving tips during the new car break-in period: The car body should not be driven with too much load. The lighter the car body during the break-in period, the better, because excessive load can also damage the car. When in use, do not let the engine speed too high, generally do not exceed 3000 rpm, and if it is an automatic transmission, do not exceed 3500 rpm. Do not maintain one gear for a long time or drive in low gear for a long time. The speed must be gradually increased. Factors affecting car fuel consumption: Potholes on the road will consume more fuel. Driving in low gear for a long time will inevitably increase fuel consumption. Placing too heavy items in the luggage compartment will increase fuel consumption. Incorrect driving can consume 2 to 3 times more fuel. Low gear and high speed will consume more fuel.
9
3
Share

How to adjust the ambient lighting in BMW X1?

Method to adjust the ambient lighting in BMW X1: 1. Press the unlock button on the remote control and open the car door; 2. Press the one-touch start switch to put the vehicle in the ignition-on state; 3. Rotate the iDrive knob to "My Vehicle" and press the knob; 4. Rotate the iDrive knob to "Lighting" and press the knob; 5. Rotate the iDrive knob to "Ambient Lighting" and press the knob; 6. Rotate the iDrive knob to select "Off," "Classic," or "Sport," then press the knob to set the ambient lighting. The BMW X1 is a compact SUV with the following dimensions: length 4454mm, width 1798mm, height 1545mm, wheelbase 2760mm, front track 1500mm, rear track 1529mm, and minimum ground clearance 194mm.
10
2
Share

What should I do if my tire loses pressure?

If the tire pressure warning light comes on, first pull over to a safe location. At this time, prepare a tire pressure gauge to check the tire pressure. Identify the wheel with inconsistent pressure compared to the other three wheels and record the pressure reading. The standard tire pressure is usually 2.2-2.5 bar. If the tire pressure drops below 1.8 bar, you should not continue driving. A tire pressure loss means one or more of the vehicle's four tires is underinflated. Therefore, use a tire pressure gauge to measure the pressure of all four tires and check if they are within the specified range. If not, inflate them to the required level. If the tire pressure warning appears, you can still drive the vehicle, but proceed to a repair shop as soon as possible. If the vehicle is equipped with liquid tire sealant, you can add it before driving, but keep the speed below 50 km/h. If the tire pressure is too low to drive, set up a warning sign behind the vehicle, turn on the hazard lights, and either change to the spare tire or call for roadside assistance. Continuing to drive with low tire pressure can cause the tire sidewall to be crushed by the rim, leading to damage.
6
3
Share

How about steering gear repair?

Steering gear repair won't have much impact. Here are some learning techniques for proper steering wheel operation: 1. Technique one: Imagine the steering wheel as a clock, with your left hand at the 9 o'clock position and your right hand at the 3 o'clock position. Your four fingers should curl from the outside inward, with your thumbs naturally extended. 2. Technique two: Avoid crossing your hands when turning the steering wheel; instead, alternate them. When your right hand is about to meet your left hand, quickly adjust the position of your left hand, and vice versa. 3. Technique three: If you forget how many turns you've made on the steering wheel, lightly press the accelerator to observe the steering direction and make adjustments accordingly.
20
1
Share

How Many Years Can a Turbocharged Engine Last?

Turbocharged engines can generally last for more than 20 years. A turbocharged engine refers to an engine equipped with a turbocharger, which is essentially an air compressor that increases intake air volume by compressing air. It utilizes the inertial impulse of exhaust gases from the engine to drive the turbine in the turbine chamber, which in turn drives the coaxial impeller. The impeller then pressurizes the air delivered through the air filter pipe, forcing it into the cylinders. When the engine malfunction indicator light comes on, it can be divided into three scenarios: 1. The car cannot start, which may be caused by a faulty fuel pump or ignition components. It is recommended to call for assistance immediately and have it inspected at an auto repair shop. 2. The malfunction light is on, but there are no noticeable abnormalities while driving. This might just be due to a faulty sensor. In this case, you can continue driving temporarily, but it's best to drive at low to medium speeds and head to the nearest auto repair shop to resolve the issue. 3. The engine malfunction light is on, and the vehicle can still be driven, but there are symptoms such as severe shaking or lack of acceleration. In such cases, it is advisable to have it inspected promptly.
7
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.