What is the curb weight of the Haval F7?

2 Answers
May
09/08/25 3:33am
The curb weight of the Haval F7 is approximately 1.6 tons. Below are the specific details of the Haval F7: Body: The Haval F7 is positioned as a compact SUV, with body dimensions of 4620mm in length, 1846mm in width, 1690mm in height, and a wheelbase of 2725mm. The side profile of the body gives a very solid impression, with multiple waistlines enhancing the sense of layering. The chrome-trimmed window lines rise towards the rear of the body and taper at the tail, adding visual tension. Exterior: The Haval F7 adopts Haval's new family design language, featuring a large hexagonal grille and eagle-eye-style LED headlights at the front, paired with an exaggerated and sporty front bumper, presenting a sharp and aggressive appearance.
Was this review help?
18
3
Share
ReidAnn
09/20/25 2:22am
I've tested the Haval F7, with a curb weight of approximately 1,650 kg, which is quite standard for an SUV. The advantage of a heavier body is greater stability at high speeds; it's less prone to swaying in wind and rain, especially maintaining excellent body control during cornering, giving the driver more confidence. However, a heavier vehicle also means slightly higher fuel consumption, potentially reaching 9L/100km in daily city driving, especially noticeable when frequently carrying heavy loads or luggage. Additionally, during maintenance, special attention should be paid to the suspension system and tire wear, as the weight can accelerate aging in these areas. In terms of safety, the 1,650 kg structure can absorb more impact in collision accidents, enhancing passenger protection. The general advice is to avoid overloading and control speed reasonably, allowing you to enjoy the safety benefits of the weight without wasting money on fuel.
Was this review help?
5
3
Share
Expand All
More Forum Discussions

What should I do if I run over a yellow line when turning left?

After running over a yellow line, first observe whether there are any vehicles in the lane to ensure driving safety. If it is safe, you can return to the correct lane and continue driving normally. Observe what kind of line the yellow line is for reflection and summary.
14
0
Share

How to Remove the Seats?

10mm socket wrench. Fold down the rear seats, first install the headrest and seat back covers, the installation method is the same as the front seats. There are two white clips at the bottom of the rear seats, reach in with your hand and try to pry them. If the seat is lifted but cannot be removed, tools will be needed. Remove the two backrests on the sides of the rear seat.
2
3
Share

How to Turn On and Off the Left Turn Signal?

When making a right turn at some intersections with heavy traffic, it is also necessary to master some techniques. Before turning right: Turn on the right turn signal. When spotting an available parking space, you can turn on the turn signal in advance, slow down, and if conditions permit, choose to drive directly into the parking space with the front facing inward. Before entering a roundabout, keep to the left and turn on the left turn signal. There is a turn signal switch below the steering wheel. Pushing it downward activates the left turn signal, and pushing it upward activates the right turn signal. Moving it to the middle position turns it off.
15
0
Share

How to Adjust Seat Height?

With sufficient visibility, the lower the seat height, the better. A lower seat height means a lower center of gravity, resulting in less body sway when driving on bumpy roads. For the adjustment of the seat backrest angle, it is advisable to set it to provide some support to the waist, and the backrest should be kept as upright as possible. While ensuring the accelerator can be fully depressed, try to adjust the seat as far back as possible. More space means less risk in the event of an accident.
15
1
Share

How to Remove the Rearview Mirror of Baojun 730?

Pinch the support rod of the front windshield rearview mirror and rotate it 45 degrees counterclockwise to remove it. After removal, you will see that only a base of the front windshield rearview mirror remains stuck to the glass. Rotate it clockwise to reinstall the front windshield rearview mirror. The structure of the front windshield rearview mirror in the Lavida is very simple, consisting of a base and a mirror.
15
2
Share

How to engage 4WD mode in the Land Cruiser Prado?

There is a 4WD mode button located on the vehicle's center console. Press it to switch to 4WD mode. When the vehicle encounters slipping conditions during driving, the onboard computer will automatically detect and can switch modes accordingly.
10
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.