What is the correct way to use car anti-vibration pads?
2 Answers
First, peel off the adhesive backing on the anti-vibration pad to ensure it adheres tightly to the license plate. Install the anti-vibration pad in the corresponding position on the license plate, making sure to align the threaded holes for the license plate installation. It is recommended to use double-sided foam tape during the installation. Install the license plate and tighten the screws to prevent it from loosening. Place the license plate holder on the bracket first, then add a rubber pad behind the license plate.
Vibration dampening washers can effectively reduce engine vibration and noise in vehicles, and proper installation is crucial. When working on my own car, I prefer installing them at engine mounts or suspension points where vibration sources are most prominent. First, turn off the engine and thoroughly clean the contact surfaces with degreaser to remove any oil or rust. Then position the rubber washers, align them properly, and gently tighten the bolts using a standard wrench – avoid over-tightening to prevent crushing the washers. After installation, take a test drive; you'll notice significantly reduced vibrations and improved stability. This simple, low-cost solution also protects the engine and extends its lifespan. I inspect them every three months to prevent performance degradation due to aging. DIY maintenance like this saves both money and time.
