What is the comparison between Porsche 718 and 911?

1 Answers
EvangelineLee
07/30/25 3:59am
Comparison between Porsche 718 and 911: In terms of body dimensions: The Porsche 718 measures 4379mm in length, 1801mm in width, and 1295mm in height; the 911 measures 4499mm in length, 1808mm in width, and 1294mm in height. 2. Transmission: The Porsche 718 is equipped with a 7-speed dual-clutch transmission across the range; the 911 offers a choice between 7-speed and 8-speed dual-clutch transmissions. In terms of power: The Porsche 718 is powered by a 2.0-liter turbocharged and a 2.5-liter turbocharged engine; the 911 is powered by a 3.0-liter twin-turbocharged, a 4.0-liter naturally aspirated, and a 3.8-liter twin-turbocharged engine. 4. Drivetrain: The Porsche 718 is rear-wheel drive across the range; the 911 offers both rear-wheel drive and all-wheel drive options.
Was this review help?
15
3
Share
More Forum Discussions

How to Deal with Buick GL8 Electronic Stability Control Failure?

Here are the solutions for the Malibu displaying 'Please Shift to P Gear': 1. If the sensor malfunctions, visit a 4S shop to replace the gear lever; 2. If there is damage or debris inside the gear shift lever, go to a repair shop for cleaning or repair; 3. The vehicle's transmission may have a fault, requiring the driver to shift the transmission to the P position to ensure vehicle safety, then re-shift following the correct steps. Below are precautions for car gear shifting: 1. Avoid looking down at the gear lever while shifting: Especially when driving on city streets or highways, looking down can cause the vehicle to veer off course, leading to accidents. 2. Use the double-clutch method: Most modern cars are equipped with synchronizers, making shifting easier, but improper operation can be hazardous. The double-clutch method helps extend the lifespan of components. 3. Avoid skipping the throttle blip when downshifting: On synchronized gears, downshifting can be done without blipping the throttle using a single clutch, but this can cause wear and premature damage. Therefore, whether the car has a synchronizer or not, always use the double-clutch method with a throttle blip for downshifting. 4. Fully depress the clutch when shifting: If the clutch is not fully depressed, the engine and the transmission's first shaft cannot completely disengage, leading to intermittent power transmission, noise during shifting, and potential gear damage. 5. Avoid skipping gears when upshifting: Upshifting should be done sequentially to prevent power interruption and stalling. Downshifting, however, can be done by skipping gears, and frequent skip-downshifting is recommended.
4
4
Share

What brand is the audio system in the Audi A6L?

Audi A6L is equipped with Bose audio system. The main components of a car audio system are the head unit, amplifier, and speakers. The car audio system is designed to alleviate the monotony of travel for drivers and passengers with its radio and playback functions. Bose is one of the largest speaker manufacturers in the United States, headquartered in Massachusetts, and is a wholly-owned independent company. Bose provides customized audio systems for many global luxury car models and is widely used in professional audio industries, such as in over ten exhibition halls and the opening and closing ceremonies of the 2004 Rome Olympics. Along with Harman Kardon and Burmester, Bose is considered a high-standard audio brand. Of course, the Bose audio system is only available in the two high-end versions of the Audi A6L, while other versions can opt for it as an upgrade. According to reports, the standard audio system in Audi vehicles is provided by Konka, featuring 10 speakers distributed throughout the car. However, compared to Bose, the difference is quite noticeable. Bose significantly increases the number of speakers and amplifies the power output several times over the standard system.
1
3
Share

How to Obtain the 6-Year Inspection Exemption Sticker?

There are two methods to obtain the 6-year inspection exemption sticker: 1. Bring the vehicle registration certificate, compulsory traffic insurance policy, and vehicle and vessel tax payment or tax exemption certificate directly to the nearest traffic police detachment's vehicle administration hall or the municipal vehicle management office and its branches to apply for the inspection exemption sticker. 2. For owners who don't have time to apply in person, they can apply for the inspection exemption sticker online through Alipay and choose EMS delivery to their home. Steps to obtain via Alipay: (1) Open Alipay and click on the 'More' icon on the homepage; (2) Find 'Car Owner Services' in the all applications interface; (3) Click on 'More' within the Car Owner Services; (4) Find 'Annual Inspection Appointment' in the more car owner services and click to enter; (5) In the vehicle inspection services, click on '6-Year Inspection Exemption'; (6) On the next interface, you can see the conditions for the vehicle inspection exemption service. Upload photos of the front and back of the vehicle registration certificate, a copy of the compulsory traffic insurance policy within the validity period, fill in the license plate number, registration date, delivery address, name, and mobile phone number, then pay the fee to complete the process. (Note: New vehicles within six years do not need to go to the inspection station for an on-site annual inspection; they only need to obtain the 6-year inspection exemption sticker.)
10
2
Share

Which is the fast lane and which is the slow lane on the highway?

On highways, when there are two lanes in the same direction, the left lane is the fast lane and the right lane is the slow lane; when there are three or more lanes in the same direction, the leftmost lane is the fast lane, the middle lane is the travel lane, and the rightmost lane is the slow lane. Additional information: 1. Highway: Highways are high-grade roads, abbreviated as expressways. According to the "Technical Standards for Highway Engineering" by China's Ministry of Transport, highways refer to "roads that can accommodate an average annual daily traffic volume of more than 25,000 passenger cars, are exclusively for high-speed divided-lane driving, and have fully controlled access." Although different countries have different names for highways, they all specifically refer to roads with more than four lanes, two-way separated traffic, fully controlled access, and all-grade interchanges. 2. Traffic restrictions, exclusive to motor vehicles: Highways prohibit pedestrians, non-motorized vehicles, tractors, electric vehicles, agricultural transport vehicles, wheeled special machinery, full-trailer tractors, and motor vehicles with a designed maximum speed of less than 70 km/h from entering, being exclusively for motor vehicles; China also stipulates that the design speed of highways is generally 120 km/h. 3. Controlled access, "closed" to non-access points: Non-motorized vehicles, pedestrians, and livestock are isolated from highways using barriers, high embankments, guardrails, and other measures to "close" the highway; for intersections where vehicles are not allowed to enter or exit, separated interchanges are set up for isolation; for intersections where vehicles are allowed to enter or exit, designated interchange ramps are used for connection. 4. Divided traffic, safe and high-speed: Highways adopt a dual-carriageway form, with a central median separating opposing traffic flows to prevent head-on collisions; for traffic in the same direction, lane markings are used throughout to divide lanes, reducing interference caused by overtaking and different speeds in the same direction, which is conducive to safe and high-speed driving.
12
5
Share

What does tc mean in a car?

tc stands for Traction Control System, which is a very important system in a car. Here is the relevant introduction: 1. Traction Control System, abbreviated as TCS, is also known as ASR or TRC. 2. It can control the car's traction by reducing the throttle opening to decrease engine power or by using the brake to control wheel slip. In cars equipped with tc, the mechanical connection between the accelerator pedal and the throttle of the gasoline engine is replaced by an electronic throttle device. When the sensor sends the position of the accelerator pedal and the wheel speed signal to the control unit, the control unit generates a control voltage signal. The servo motor adjusts the throttle position accordingly, and then feeds back the position signal to the control unit for timely adjustment of the brake. 3. The computer uses the steering wheel angle sensor to understand the driver's steering intention, and then uses the left and right wheel speed sensors to detect the speed difference between the left and right wheels; thus, it determines whether the car's steering degree matches the driver's steering intention. If understeer is detected, the computer immediately determines that the driving wheel's driving force is too high and issues a command to reduce the driving force to achieve the driver's steering intention.
18
4
Share

What is the fuel consumption per 100 km for the Grand Cherokee?

The Grand Cherokee currently has 7 models available for sale. Among them, the 2021 3.0L 80th Anniversary Edition, 2020 3.0L Elite Navigation Edition, and Professional Navigation Edition are equipped with a 234 horsepower engine, with an NEDC fuel consumption of 9.8L per 100 km. The 2020 3.6L High-Performance 4WD Edition, Elite Navigation Edition, Flagship Honor Edition, and Luxury Navigation Edition are equipped with a 286 horsepower engine, with an NEDC fuel consumption of 10L per 100 km. The fuel tank capacity of the Grand Cherokee is 93.5L. The distance each model can travel on a full tank is as follows: Models with the 234 horsepower engine can travel 93.5/9.8*100=954km on a full tank. Models with the 286 horsepower engine can travel 93.5/10*100=935km on a full tank. Vehicle fuel consumption is directly influenced by five major factors: driving habits, the vehicle itself, road conditions, natural wind, and environmental temperature. Specific factors that can increase fuel consumption include: Driving habits: Aggressive driving behaviors such as rapid acceleration, frequent overtaking, and not easing off the throttle before reaching a red light can increase fuel consumption. The vehicle itself: Vehicles with larger engine displacements generally consume more fuel than those with smaller displacements because larger displacements typically produce more power, requiring more gasoline for combustion. Heavier vehicles also consume more fuel due to the greater driving torque needed. Road conditions: Driving on dirt roads, muddy roads, soft surfaces, or mountainous roads increases resistance and fuel consumption. Natural wind: Driving against the wind or on windy days increases vehicle resistance and fuel consumption. Low environmental temperatures: When the engine block is cold, gasoline injected during a cold start does not atomize easily, requiring more gasoline for combustion, thus increasing fuel consumption. Additionally, at low temperatures, the engine's computer may control the engine to run at higher RPMs to warm up, which also increases fuel consumption.
13
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.