What is the channel number for Volkswagen tire pressure reset?

1 Answers
SamuelFitz
07/30/25 7:38am
Volkswagen tire pressure matching channel number is 5053—65—16—10896. Tire pressure monitoring is the real-time automatic monitoring of tire pressure during vehicle operation, with alerts for tire leaks and low pressure to ensure driving safety. There are three commonly used types of tire pressure monitoring: Direct tire pressure monitoring: Direct tire pressure monitoring devices use pressure sensors installed in each tire to directly measure tire pressure. The pressure information is transmitted wirelessly from inside the tire to a central receiver module, which then displays the tire pressure data. Indirect tire pressure monitoring: When the pressure in a tire decreases, the vehicle's weight causes the rolling radius of that tire to become smaller, resulting in faster rotation compared to other wheels. By comparing the rotational speed differences between tires, the system monitors tire pressure. Introduction to Tire Pressure Monitoring System (TPMS): It combines the advantages of both systems mentioned above, equipping direct sensors in two diagonally opposite tires and incorporating a 4-wheel indirect system.
Was this review help?
4
3
Share
More Forum Discussions

What are the causes of manual transmission oil leakage?

Manual transmission oil leakage can be caused by: 1. Improper selection of lubricating oil, resulting in excessive foam, or an excessive amount of lubricating oil. In this case, replace the lubricating oil or adjust the oil quantity; 2. Loose side cover, damaged sealing gasket, or damaged oil seal. Replace with new parts; 3. Loose drain plug and transmission housing or cover fixing bolts. Tighten them according to the specified torque; 4. Loose or damaged odometer gear limiter. Tighten or replace it. Transmission oil can clean the car's gear system and also plays a role in lubrication, heat dissipation, and sealing, reducing wear and extending the life of the transmission. Manual transmission oil is also called gear oil, classified into six grades from GL1 to GL6.
2
5
Share

Where is the fog light switch located on the Buick Excelle?

The fog light switch on the Buick Excelle is located at the lower left side of the instrument panel. To operate the fog light: Press button 6 to turn the rear fog light on or off. When the fog light is activated, the indicator on the combination meter will illuminate. Note that the fog light can only be activated when the headlights are turned on, which means the light switch must be rotated to position 3. The Buick Excelle is a compact 4-door, 5-seater sedan with dimensions of 4609mm in length, 1798mm in width, and 1486mm in height, and a wheelbase of 2640mm. It has a fuel tank capacity of 44 liters. This model is equipped with a 1.3T 163 horsepower inline 3-cylinder engine, delivering a maximum power of 120kW and a maximum torque of 230Nm, with a front-engine, front-wheel-drive configuration.
14
0
Share

Where to Check Fuel Consumption in Fista?

Fista's fuel consumption can be viewed on the trip computer display located on the vehicle's dashboard. Here is some relevant information about Fista: 1. Interior: Based on Hyundai's latest design style, with clear functional divisions. 2. Engine: Equipped with two types of engines: one is a 1.4-liter turbocharged engine, and the other is a 1.6-liter turbocharged engine. The 1.4-liter turbocharged engine has a maximum power of 103 kW, maximum torque of 242 Nm, maximum power speed at 6000 rpm, and maximum torque speed ranging from 1500 to 3200 rpm. The 1.6-liter turbocharged engine has a maximum power of 150 kW, maximum torque of 265 Nm, maximum power speed at 6000 rpm, and maximum torque speed ranging from 1500 to 4500 rpm.
4
1
Share

How many points will be deducted for making a U-turn over a crosswalk?

According to the Road Traffic Safety Law, three points will be deducted from the motor vehicle driver's license. During daily driving, it is essential to avoid making U-turns on crosswalks as it poses certain dangers to pedestrians and can cause traffic congestion. Below are the situations regarding U-turns: I. Situations where U-turns are allowed: 1. On yellow grid line sections of the road without central guardrails. 2. Where there is no 'No U-turn' sign in the middle of the road. 3. Where yellow solid and dashed lines are marked on the road. The solid line side prohibits overtaking and U-turns, while the dashed line side allows overtaking and U-turns. II. Situations where U-turns are prohibited: 1. Intersections marked with 'No U-turn' signs. 2. If the centerline of the road is solid, whether it is a single yellow line or double yellow lines, U-turns are 'prohibited'. 3. U-turns are prohibited at intersections where left turns are banned.
4
5
Share

How to Deal with Water in Engine Oil?

The method to deal with water in engine oil is: do not start the engine, then check the cause of water leakage. After solving the problem, completely drain the original oil and replace it with new oil. Most of the additives in engine oil are surfactants, which are emulsifiers in a sense. When mixed with water and circulated by the pump or stirred, it is easy to emulsify into a brownish-yellow emulsion. If there is a large amount of water, it may even emulsify into a milky-white emulsion. Therefore, if the used oil appears milky white, it may be due to radiator leakage or external water mixing into the lubrication system. In this case, the oil should be drained and the vehicle should be inspected. Continuing to use such oil will not only reduce the strength of the oil film but also cause foaming or emulsification and deterioration of the oil. In mild cases, it may cause rusting of mechanical parts, and in severe cases, it may lead to serious mechanical accidents such as cylinder scoring or bearing seizure.
16
2
Share

What is the appropriate amount to fill the fuel tank?

According to the relevant mandatory national standards, the rated capacity of a vehicle fuel tank should be controlled at 95% of the maximum safe capacity of the fuel tank. Taking a 60-liter fuel tank as an example, it can be filled up to a maximum of 75 liters, but the stored fuel should not exceed 60 liters. More relevant information is as follows: 1. The accuracy of the refueling amount cannot be judged based on the rated capacity of the fuel tank. The fuel tank of a fuel-powered vehicle is a container, not a measuring tool, so it cannot be used as a basis for judging measurement accuracy. Moreover, according to the relevant mandatory national requirements, the rated capacity of a vehicle fuel tank should be controlled at 95% of the maximum safe capacity of the fuel tank. 2. Many vehicle fuel gauges operate through the up and down movement of a float inside the tank, which drives an electronic sensor. The sensor then transmits the generated electronic signal to the fuel gauge pointer, displaying it on the fuel gauge, resulting in significant potential errors.
16
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.