···
Log in / Register

What is the best engine oil for the 1.5L Earth Dreams engine?

5 Answers
SanGabriella
07/29/25 4:44pm

For Honda's 1.5L Earth Dreams engine, it is recommended to use 0W20 or 5W20 engine oil. Expanded relevant information is as follows: 1. Mechanism of action: Engine oil is known as the blood of the engine and is extremely important for the engine. Without engine oil, the engine cannot operate normally. Inside the engine, oil not only lubricates but also cleans, seals, cushions, prevents rust, and dissipates heat. When the engine is running, the oil forms a film on the surfaces of various components inside the engine, preventing direct contact and friction between them. 2. Regular replacement: Over time, the performance of engine oil degrades, so it needs to be replaced regularly. Failure to change the oil for an extended period can accelerate engine wear. 3. Replace the oil filter with each oil change: The oil filter is used to filter the oil. Without an oil filter, the oil would become very dirty after some use.

Was this review help?
9
4
Share
DeJameson
08/14/25 6:19am

I've driven a Honda 1.5L Earth Dreams engine for several years and believe oil selection depends on daily usage. That engine is quite precise, and Honda's official manual recommends 0W-20 full synthetic oil, which I've tried with good results - smooth starts and fuel efficiency. For regular city driving, this viscosity helps prevent engine carbon buildup. I've used Mobil 1, which offers good value, with quick power response during highway driving. Remember to change it every 5,000 to 7,500 km, as poor oil quality affects engine lifespan. Buy from authorized shops and avoid cheap off-brands. Also, lower viscosity during cold starts helps the engine warm up faster, reducing wear. Don't mistake the oil grade - 0W is specifically designed for low temperatures.

Was this review help?
19
0
Share
Expand All
McAdam
10/13/25 2:50am

As a seasoned driver who has maintained the 1.5L Earth Dreams engine multiple times, my top priority for engine oil is balancing protection and fuel efficiency. Honda recommends 0W-20 or 5W-20 full synthetic oils, and I personally prefer Shell's Helix Ultra series (gray bottle). After switching to it, I noticed reduced noise levels and a quieter engine. Choosing the right viscosity ensures effortless cold starts in winter and prevents rapid degradation under summer heat. Regularly check oil levels during daily driving, as aged oil can compromise performance. For long-distance trips, high/low-temperature stability becomes crucial. In terms of fuel savings, synthetic oils outperform mineral oils, offering annual cost benefits. Always look for API or ILSAC certifications when purchasing to ensure compatibility. Never exceed the manufacturer-recommended oil change intervals to prevent engine issues.

Was this review help?
10
0
Share
Expand All
VonJackson
10/13/25 2:52am

After driving more, I found that the 1.5L Earth Dreams engine works best with low-viscosity full synthetic oil, like 0W-20. Honda designed it with efficiency in mind. I've tried different brands, and both Mobil and Castrol perform well. Oil that's too viscous increases friction and fuel consumption, while oil that's too thin may not seal properly. When changing oil, don't wait too long—replace it once it turns black, or it could affect combustion. I prefer checking reviews when buying oil, prioritizing affordable yet decent quality. The Earth Dreams engine is quite reliable; paired with good oil, it can easily run over 100,000 kilometers. Also, keep maintenance frequency in mind—for city driving, it's recommended to check the oil every 5,000 kilometers.

Was this review help?
16
1
Share
Expand All
Furtado
11/26/25 3:49am

As a DIY car enthusiast, I often change the oil for my 1.5L Earth Dreams engine. Honda recommends 0W-20 full synthetic, and I choose Castrol Edge for its online shopping convenience and affordability. Oil that's too thin isn't suitable for cold regions, while thicker oil becomes sticky in summer. Each oil change is done with my own tools - simple steps: first check oil level when cold, drain old oil completely before refilling to dipstick mark. Oil quality determines engine wear resistance, with synthetic oils offering better durability and lower maintenance costs. When selecting oil, check packaging labels for 0W certification. By the way, regular oil changes prevent minor issues and extend vehicle life. Always prioritize safety when DIY-ing - wear gloves.

Was this review help?
19
2
Share
Expand All
More Forum Discussions

Is the Lexus UX compliant with China 6 emission standards?

Lexus UX complies with China 6 emission standards. The objectives of China 6 standards are: 1. To prevent environmental pollution caused by exhaust emissions from compression-ignition and gas-fueled spark-ignition engine vehicles; 2. To protect the ecological environment and safeguard human health. Taking the 2020 Lexus UX as an example, its body dimensions are: length 4495mm, width 1840mm, height 1540mm, wheelbase 2640mm, and fuel tank capacity 47L. The 2020 Lexus UX is equipped with a 2.0L naturally aspirated engine, with a maximum power of 127kW and a maximum torque of 207Nm, paired with a CVT continuously variable transmission.
6
0
Share

How Much Difference is There Between Cold and Hot Engine Oil Dipsticks?

There is a quarter difference between cold and hot engine oil dipsticks. The oil dipstick is located on the top or side of the engine and has an orange or red pull ring. The oil dipstick is a simple-structured liquid level gauge that directly displays the oil level in the oil pan, with clear upper and lower limits. The detected oil level should be between these limits. The correct way to use the oil dipstick is: 1. Check the oil dipstick after the car has been parked overnight or for half an hour; 2. Ensure the correct oil level position is observed, checking both sides and using the lower reading as the accurate one; 3. Frequently inspect the oil dipstick to ensure timely oil replenishment; 4. Pay attention to changes in oil quality; 5. Be alert to any malfunctions of the oil dipstick.
11
4
Share

What does 245/45r20 mean?

245/45r20 refers to the tire specification, where 245 indicates that the tire section width is 245 millimeters; 45 is the aspect ratio, meaning the tire sidewall height is 45% of the tire section width; R indicates that the tire has a radial construction, meaning it is a radial tire; 20 refers to the rim diameter of 20 inches. The combination of numbers and letters in 245/45r20 represents the key parameter information of the tire, followed by the load index and speed rating. When selecting tires, it is essential to fully consider all parameters based on specific conditions. Tires are the only components of a car that come into contact with the ground, affecting the vehicle's driving stability and safety. Tires are rubber products, and prolonged use can lead to aging, so they need to be replaced regularly. Generally, tires installed on a car can be used for four years. When purchasing new tires, always check the production date, as unused tires typically have a shelf life of three years. In addition to the model, tires also display the following common data: The tire sidewall may have an arrow or the word OUTERSIDE, indicating the tire's rotation direction; a small umbrella symbol on the sidewall indicates that the tire is suitable for driving in rainy or slippery conditions. Some tires may have other letters or symbols with special meanings, such as "X" for high-pressure tires, "C" for reinforced tires, "B" for bias-ply tires, and "-" for low-pressure tires. Tire cord materials: Represented by Chinese pinyin, such as M for cotton cord, R for rayon cord, N for nylon cord, G for steel cord, and ZG for steel radial cord tires. Speed rating: Indicates the maximum speed at which the tire can carry a specified load under defined conditions. Letters A to Z represent certified speed ratings from 4.8 km/h to 300 km/h. Common speed ratings include: Q: 160 km/h; H: 210 km/h; V: 240 km/h; W: 270 km/h; Y: 300 km/h. Rim specification: Indicates the rim size compatible with the tire for practical use, such as standard rim 5.00F. In daily use, pay attention to the following points regarding tires: Regularly inspect the tire surface for cracks, deformations, or other defects. Due to wear from driving, the tread grooves gradually become shallower. If the tread is worn flat, it loses its drainage and anti-slip functions, significantly reducing the car's performance. Small cracks can also pose a risk of tire blowouts at high speeds. Additionally, promptly remove small stones from the grooves. Park on level ground whenever possible. Avoid parking on roads with thick, sharp, or pointed stones. Do not park near or in contact with petroleum products, acids, or other materials that can deteriorate rubber. After parking, avoid turning the steering wheel, as this can accelerate tire wear. Do not splash water to cool tires. In hot weather or during high-speed driving, tires can overheat, and the pressure may increase. In such cases, stop to let the tires cool naturally. Never release air to reduce pressure or splash water to cool the tires, as this can cause abnormal aging of the tread rubber. Avoid sudden braking. Try to minimize frequent or hard braking to prevent accelerated tread wear from dragging against the ground.
2
3
Share

What is the function of a car reversing radar?

The function of a car reversing radar is: 1. Accurately measure the distance between the rear of the car and obstacles; 2. When reversing to a dangerous distance, it can emit rapid warning sounds to remind the driver to pay attention to braking; 3. Repeatedly emit voice warnings to alert pedestrians. The method of using the reversing radar is: 1. Open the car door on the driver's side; 2. Step on the car's brake pedal to prepare to start the engine; 3. Turn the car's key to start the engine and let it idle; 4. The car's dashboard lights up, and the entire vehicle is powered on; 5. Press the reversing radar start button located on the left side of the central control panel's combination switch.
4
1
Share

What are the symptoms of a faulty wastegate valve in the Magotan?

The symptoms of a faulty wastegate valve in the Magotan are: 1. Severe suction when opening the oil filler cap; 2. Sudden emission of large amounts of exhaust smoke, white at idle and blue during rapid acceleration or heavy throttle; 3. Accompanied by a strong burning rubber smell; 4. Causes engine idle vibration. The Magotan is a mid-sized 4-door 5-seater sedan with body dimensions of 4865mm in length, 1832mm in width, 1471mm in height, and a wheelbase of 2871mm. It is equipped with a 1.4T turbocharged engine and a 7-speed dual-clutch transmission, delivering a maximum power of 110 kW and a maximum torque of 250 Nm.
14
0
Share

How to reset the maintenance light on Borgward BX5?

The method to reset the maintenance light on Borgward BX5 is: Press and hold the scroll wheel on the right side of the steering wheel while the engine is off. The Borgward BX5 is a compact SUV with body dimensions of 4490mm in length, 1877mm in width, 1675mm in height, a wheelbase of 2685mm, and a fuel tank capacity of 60 liters. It is equipped with a 1.4T turbocharged engine, delivering a maximum power of 110kW at 5500rpm and a maximum torque of 250Nm between 1750 to 4000rpm.
16
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.