···
Log in / Register

What is the battery model of the Refine S3?

4 Answers
GarrettDella
07/28/25 10:16pm
The battery model for the Refine S3 is 55d231. This vehicle requires a 12V 55Ah battery, and it is essential to select the correct model when replacing the battery. The battery is a crucial component in a car, used for storing electrical energy. Without this component, the vehicle cannot operate normally. Below is some related information about the battery: 1. Avoid using in-car electrical appliances when the engine is not started: Do not use in-car electrical appliances for an extended period when the vehicle is not started, as this may cause severe battery drain, leading to the vehicle's inability to start. 2. When the vehicle is parked for a long time: It is recommended to disconnect the negative terminal clamp of the battery. Before connecting or disconnecting the negative terminal of the vehicle's battery, ensure that the ignition switch is turned off. 3. For vehicles equipped with an intelligent start-stop fuel-saving system: After reconnecting the battery's negative terminal, the vehicle needs to remain stationary for at least 4 hours. Before this period, the engine will lose its automatic start-stop function.
Was this review help?
4
2
Share
McGideon
08/12/25 1:44am
The original battery in my previous JAC Refine S3 was a 12V 60Ah model, labeled as 6-QW-60. This type of maintenance-free battery is quite common, and older models mostly used this configuration. However, newer models after 2017 might use a 55Ah version instead. When replacing the battery, pay attention to the size issue. A friend of mine once bought a cheap off-brand battery, only to find it didn't fit into the battery tray and had to buy another one. It's best to check the original battery label for the most accurate information, as the model number and CCA parameters are usually printed on the side. Additionally, a JAC 4S店 technician mentioned that for cold starts in winter, you should choose a battery with a CCA value of at least 500A; otherwise, starting the engine in sub-zero temperatures can be difficult. Generally, a car battery lasts about 2-3 years, and if it's been deeply discharged twice, it's usually time for a replacement.
Was this review help?
7
1
Share
Expand All
SanNadia
10/01/25 3:42am
The original battery model for the JAC Refine S3 is mostly 6-QW-60, corresponding to the 12V 60Ah standard. However, the specific model depends on the year. Early models generally used this specification uniformly, while some post-2018 models switched to a reduced 55Ah version. When replacing the battery, I paid special attention to the dimensions: the length, width, and height must be within 242*175*190mm to fit into the battery compartment. Brands like Varta or Fengfan are recommended as their OEM products are stable and meet the CCA (Cold Cranking Amps) requirements. When helping my cousin replace his battery, I noticed that after installing the new battery, the window anti-pinch function needed to be reset by holding the switch for 5 seconds after fully raising the window. Regular maintenance should include cleaning corrosion from the battery terminals, as severe oxidation can cause voltage instability.
Was this review help?
13
5
Share
Expand All
BraxtonLee
11/14/25 5:29am
The commonly used battery model for the JAC Refine S3 is 6-QW-60, representing 12V voltage and 60Ah capacity. However, there are actually two scenarios: the base manual transmission models may use the Q-55 with 55Ah, while the higher-end automatic transmission models are equipped with 60Ah. When replacing the battery, focus on the installation position—the battery compartment in this car is designed to be compact, so you must choose the L2-400 specification to match the mounting bracket. The Camel brand's T6 series is recommended, as it comes with a built-in charge indicator window for easy status monitoring. In daily use, avoid idling with the air conditioning on for extended periods, especially in summer—running the AC at maximum fan speed for half an hour can drain 30% of the battery. Checking battery life is simple: if the headlights noticeably dim when starting the car, it's time for a replacement.
Was this review help?
6
1
Share
Expand All
More Forum Discussions

What is the process of Subject 2 and the time limit for each item?

There are time limits for Subject 2, which generally consists of five major test items, each with its own time limit. Here are the details: 1. Reverse parking into a garage: The completion time for this item must not exceed 3.5 minutes. 2. Pole test (A1, A3, B1, B2): The completion time must not exceed 8 minutes. 3. Parking and starting on a slope: The starting time must not exceed 30 seconds. 4. Parallel parking: The completion time must not exceed 1.5 minutes. 5. Narrow road U-turn (A1, A2, A3, B1, B2): The operation time must not exceed 5 minutes.
7
2
Share

How to Turn Off the Auto Start-Stop Function in Volkswagen Cars?

Taking the Lamando as an example, the auto start-stop function uses a mechanical button. To turn it on or off, simply press the button. Below is some relevant information about the auto start-stop function: 1. Usage Notes for Auto Start-Stop: The auto start-stop function will shut off the engine. Unless the vehicle is also equipped with an auto-hold function, you must keep your foot on the brake during this process. 2. Tips for Using Auto Start-Stop in the Volkswagen Lamando: (1) The auto start-stop function can only be permanently disabled by modifying the vehicle's code. For normal use, the driver must manually turn it off each time. (2) During heavy traffic on holidays, turning off this function can make driving more comfortable. Otherwise, frequent restarts may occur, and you might be more susceptible to being cut off by other drivers. (3) When starting on a slope, turn off the auto start-stop function. A slow response during startup could lead to the vehicle rolling backward, creating a dangerous situation. 3. Possible Reasons Why the Auto Start-Stop Function in the Volkswagen Lamando May Not Work: (1) The function does not operate when the battery charge is below 60%. (2) The interior temperature is below 20°C, or the outside temperature is below 4°C. (3) The engine has not reached the standard operating temperature. (4) The steering wheel is turned too far, exceeding 30 degrees.
13
2
Share

What Causes the Peeling of Car Wrapping Film?

Reasons for the peeling of car wrapping film: Presence of Moisture: If bubbles appear shortly after applying the film to the rear windshield, typically appearing as white spots, it is due to improper handling of moisture between the film and the glass during application. Use of Low-Quality Film: If bubbles appear several years after application and gradually increase in number and size, this is caused by the use of low-quality film. Over time, exposure to UV rays can cause low-quality films to release toxic gases such as formaldehyde, leading to bubble formation. Poor-quality films, with issues like aging adhesive layers, rough film structure, and easy detachment, are prone to bubbles and ripples when exposed to UV light.
14
0
Share

How to Conduct Annual Inspection for Vehicles with 8-Year Exemption?

Vehicles are exempt from inspection for the first six years, after which they must undergo on-site testing to obtain the annual inspection sticker. Vehicles in their eighth year are no longer exempt and cannot apply for the exemption sticker online. Instead, they must be taken to the vehicle management office for on-site inspection to receive the annual inspection sticker. Therefore, for the eighth year, you should schedule an appointment with the vehicle management office for the annual inspection within three months before the inspection deadline. Alternatively, you can follow the dates suggested by the Traffic Management 12123 app to legally arrange your inspection. Annual Inspection Procedure: First, after submitting the inspection application, the vehicle must undergo on-site testing. Drive the vehicle into the automatic inspection area to sequentially check the exhaust emissions, speed, lights, side slip, and chassis for compliance with standards. Only if all items pass can the inspection be completed. Next is the visual inspection, which verifies the accuracy of the vehicle's license plate, type, body color, engine number, VIN code, and frame number. Then, inspect the vehicle's exterior, including details such as the bumper, engine compartment, rearview mirrors, under-mirrors, window glass, paint, engine operation condition, and the interior and wheels of passenger vehicles. Finally, the owner can obtain the inspection report and application form from the inspector. If all inspection items pass, the owner can proceed to pay the inspection fee and collect the vehicle registration certificate and compliance label. If any items fail, the owner must repair the vehicle and participate in a re-inspection until all items pass before proceeding with the visa procedures.
10
1
Share

What are the three principles of driving?

Driving principles are: Stay focused, drive cautiously, and prevent in advance. Here are the details: 1. Stay focused: You must concentrate fully while driving. Avoid chatting and laughing with passengers or any actions unrelated to driving. 2. Drive cautiously: Always remember to be careful, careful, and more careful when driving. Do not drive recklessly, show off, or out of anger. It's better to stop for an hour than to rush for a second. Never cut in or force overtaking. 3. Prevent in advance: When passing through intersections, be aware of potential vehicles suddenly appearing from the side. When changing lanes, watch for vehicles behind accelerating to overtake. On highways, avoid driving behind large trucks for extended periods as they block your view, making it hard to predict road and traffic conditions ahead. If the truck brakes suddenly, following vehicles may not react in time.
7
0
Share

Is There a Fee for Replacing a Driver's License?

Replacing a driver's license requires a fee. There is a processing fee. Documents required for replacing a driver's license: The original driver's license of the driver; the driver's ID card and a copy; a physical examination certificate issued by a county-level or higher medical institution or a military medical institution; 3 personal one-inch photos of the driver. Go to the vehicle management office to fill out the "Motor Vehicle Driver's License Application Form" and submit it along with the above documents to the relevant window of the vehicle management office for processing. Related services of the vehicle management office: The vehicle management office is mainly responsible for handling motor vehicle registration, modification, transfer, mortgage, and cancellation, as well as applications for driver's licenses, replacements, renewals, inspections, and other related services concerning motor vehicles and drivers.
6
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.