···
Log in / Register

What is the battery model of the Refine S3?

4 Answers
WyattRose
07/24/25 8:23am
The battery model of the Refine S3 is 55D23L 12V, with a battery capacity of 60Ah and a voltage of 12V. Below is more information about car batteries: 1. A car battery, also known as a storage battery, refers to a lead-acid battery. It is primarily made of lead and its oxides, with sulfuric acid solution as the electrolyte. It is a type of battery that works by converting chemical energy into electrical energy. 2. The normal service life ranges from 1 to 8 years, depending largely on the condition of the vehicle. Under normal circumstances where the vehicle's alternator charges properly and there are no electrical leaks or grounding issues, the battery can generally last for more than 3 years. If you notice that the battery is not charging properly, the starter is weak, or the headlights are significantly dimmer, the battery should be removed and charged with a charger for 12-24 hours.
Was this review help?
5
1
Share
LeGeorge
08/11/25 1:04am
I remember the battery model for JAC Refine S3 is usually 6-QW-45, which is a standard 12-volt 45Ah battery. I've been driving this car for three to four years, and last winter it suddenly wouldn't start. After checking, I found the battery was dead. I replaced it with a Varta brand battery, looked up the model online, and installed it myself, costing a little over 200 yuan. For regular maintenance, be careful not to leave the car parked for too long without driving it, as the battery can easily discharge. It's recommended to start the car once a week to recharge it. Also, in the summer, don't turn off the air conditioning immediately after parking in high temperatures to reduce the load. If you're unsure about your car's battery model, check the user manual or ask a mechanic to measure the voltage and terminal size. The battery lifespan is about two to three years. For peace of mind, choose original factory parts, and don't go for cheap, no-name brands to avoid getting stranded on the road.
Was this review help?
1
0
Share
Expand All
LaAyla
09/25/25 2:06am
I've been driving the JAC Refine S3 for five years, and the battery model is 6-QW-45, 12V 45Ah. This car is sturdy, but the battery is a frequent issue. The last time I replaced it was at a neighborhood repair shop, opting for a Sail brand battery—moderately priced with a two-year warranty. Maintenance is simple: don't let the car sit idle for too long; drive at least a few kilometers every week to avoid battery drain. Regularly check the electrodes for corrosion; a quick scrub with hot water will do. If you're unsure about the model, don't panic—just head to a 4S shop or a specialty store for professional testing. Safe driving is crucial; a weak battery can affect starting and lighting, especially in rainy or foggy conditions, which can be dangerous. I recommend a comprehensive check every two years—it doesn't cost much.
Was this review help?
5
0
Share
Expand All
Julia
11/08/25 4:13am
The JAC Refine S3 typically comes with a 6-QW-45 battery, which is a standard 12-volt 45Ah model. Having worked in auto repair for many years, I often get this question from car owners. The model number is quite consistent—just ensure the capacity and terminal positions match when replacing. Most battery issues stem from power depletion causing failure to start. I generally advise drivers to check the voltmeter reading weekly; a normal reading should be above 12.6 volts. If the battery lifespan is shorter, cold starts in winter become more challenging—avoid keeping headlights or music on when the engine is off. For a new battery, opt for reputable brands like Varta. After installation, expect smooth starts at a reasonable cost, around 200 yuan.
Was this review help?
13
5
Share
Expand All
More Forum Discussions

What does Maintenance A and Maintenance B mean?

A Maintenance and B Maintenance refer to the service codes for vehicle maintenance. A Maintenance is a minor service, while B Maintenance is a major service. Below are the detailed explanations: 1. A Maintenance: A Maintenance, also known as a minor service, typically refers to the basic maintenance tasks performed at the manufacturer's recommended time or mileage intervals to ensure vehicle performance. This mainly includes changing the engine oil and oil filter. During engine operation, metal friction generates debris, and impurities and moisture from the air mix into the oil. Continuous lubrication and high-temperature working conditions cause the oil itself to degrade and lose effectiveness. Similarly, the oil filter's efficiency diminishes over time, so timely replacement is necessary. 2. B Maintenance: B Maintenance is a major service for the vehicle, performed at the manufacturer's recommended time or mileage. In addition to changing the engine oil and oil filter, it includes replacing the air filter, cabin air filter, brake fluid, transmission fluid, and other items. Therefore, B Maintenance includes A Maintenance, and typically, A and B Maintenance are performed alternately. The selection of major maintenance items can be fully referenced according to the vehicle's maintenance manual.
19
2
Share

Is Anti-Skid the Same as ESP?

Anti-skid is part of the ESP system. Below is an introduction to the ESP system: 1. Definition: The ESP system is actually a type of traction control system. Compared to other traction control systems, ESP not only controls the drive wheels but also the non-drive wheels. For example, in rear-wheel-drive cars, oversteering often occurs, where the rear wheels lose control and the car fishtails. In such cases, ESP will brake the outer front wheel to stabilize the car. In cases of understeering, to correct the tracking direction, ESP will brake the inner rear wheel to adjust the driving direction. 2. Function: The ESP system is an important system in a car, typically supporting the functions of ABS and ASR. It analyzes vehicle driving state information from various sensors and then sends correction commands to ABS and ASR to help maintain the vehicle's dynamic balance. ESP can keep the vehicle stable under various conditions, with particularly noticeable effects in cases of oversteering or understeering. ESP generally requires the installation of steering sensors, wheel sensors, skid sensors, and lateral acceleration sensors.
3
5
Share

What Causes the Chassis Noise in Emgrand?

Automobile chassis noise can be attributed to the following reasons: 1. Suspension System: The noise heard when the vehicle starts is usually due to a fault in the suspension system, which may be caused by loose or damaged engine mounts. 2. Steering System and Suspension System: The noise heard when the vehicle is turning may be due to faults in the steering system and suspension system, as the vehicle tilts during the turning process, causing the suspension system to deform and participate in the movement. 3. Brake System Components: The noise heard when the vehicle is driving on good road conditions may be due to faults in the brake system components, or it may be caused by loose or worn brake system components, out-of-round brake drums, or uneven brake disc surfaces. 4. Bearings: It could also be an issue with the bearings that connect the moving and stationary parts of the vehicle. If it is a bearing problem, the driver can identify it by applying slight brakes. If the noise remains unchanged when the vehicle is moving at a constant speed with the brakes applied, then it is a bearing issue.
18
3
Share

What is the actual lifespan of a Hyundai CVT transmission?

There is a reference answer regarding the actual lifespan of a CVT transmission, which is 400,000 kilometers. However, this also depends on driving habits, so it can only serve as a reference. Below is some relevant information about CVT transmissions: 1. The principle of CVT transmissions: They mainly consist of two conical pulleys and a steel belt or chain. The two conical pulleys can be pressed together or released via electro-hydraulic control devices, changing the diameter of the steel belt wrapped around the pulleys to achieve variable transmission ratios. During startup, the driving pulley has the smallest diameter, while the driven pulley has the largest diameter. At high speeds, the driving pulley's diameter increases, and the driven pulley's diameter decreases. The entire diameter-changing process is controlled by a computer, enabling stepless adjustment and continuously variable transmission. 2. Advantages of CVT transmissions: Since CVT transmissions do not have mechanical gears, the driving process is very smooth with almost no noticeable jerking. CVTs have fewer components, only a few hundred, which contributes to their higher reliability.
11
1
Share

Does the dash cam only record when the car is started?

It depends on whether the installed dash cam has a parking monitoring mode. Without this mode, the dash cam naturally cannot record after the car is turned off. Even dash cams with parking monitoring mode will only start recording when necessary. Below is an introduction to parking monitoring dash cams: 1. Dash cams with parking monitoring function: Dash cams with parking monitoring function abandon traditional power sources like cigarette lighters or USB ports, instead using a step-down cable to directly draw power from the ACC fuse box. After the vehicle is parked and turned off, the dash cam will automatically shut down and enter a low-energy sleep mode. However, upon detecting a collision or movement in front, it will immediately wake up and record the surrounding scene. 2. Reducing battery drain: The parking monitoring mode of a dash cam is not always on. Typically, the dash cam uses a step-down cable with low-voltage protection to minimize battery drain as much as possible. After the vehicle is parked and turned off, the dash cam enters a low-energy state. If the car is hit or movement is detected, the system will immediately activate the parking monitoring function and record the monitoring footage.
9
4
Share

How many ring roads can Tianjin license plates enter in Beijing?

Tianjin license plates can enter any ring road in Beijing with a Beijing entry permit. Without the permit, they are only allowed to drive outside the Fifth Ring Road and must comply with Beijing's traffic restrictions. Below is an extended introduction: 1. Time restrictions: On weekdays during morning and evening peak hours (7:00-9:00 and 17:00-20:00), driving on the main roads, auxiliary roads, and roads within the Fifth Ring Road is prohibited. From 9:00 to 17:00 on weekdays, vehicles must adhere to the tail number restriction rules, which are the same as those for Beijing license plates, covering the main roads, auxiliary roads, and roads within the Fifth Ring Road. 2. Entry rules: Outside the Sixth Ring Road, non-local vehicles can enter any ring road in Beijing with a Beijing entry permit. Without the permit, non-local vehicles can only drive outside the Fifth Ring Road. According to Beijing's regulations, non-local vehicles have restricted entry times and are not allowed in designated areas during morning and evening peak hours. Violations will result in fines.
10
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.