What is the battery model of the Baojun 630?
4 Answers
The battery model of the Baojun 630 is 6-QA-105D, 12V 55A. Methods to extend the battery life of the Baojun 630: Avoid frequent vehicle starts: Allow an interval of more than 5 seconds between each engine start. If the first start fails, do not rush to repeatedly start the engine. From the working principle of the car, continuous and uninterrupted starting of the motor can cause excessive discharge and damage to the battery. Turn off the air conditioning before shutting down the engine: Not turning off the air conditioning or allowing it to start with the Baojun 630 can cause the air conditioning system to automatically start and operate every time the ignition switch is turned on, leading to an instantaneous high power load on the vehicle and reducing the battery life. Always turn off the air conditioning before shutting down the engine. Avoid long-term vehicle parking: The battery is charged by the generator during normal vehicle operation. However, if the vehicle is parked for a long time, the battery can easily lose power because many vehicles come with an alarm system that slowly drains the battery over time, eventually making it impossible to start the vehicle. It is recommended to start the Baojun 630 at least once a week for more than 5 minutes to recharge the battery.
The battery model for the Baojun 630 is typically a 12V 60Ah, with brands like Camel L2-400 or Fengfan 6-QW-60 being common choices. I've helped a friend replace it before and found that the L2-400 is quite commonly used, but it still depends on the year of the car since there might be slight differences between batches. If you're replacing it yourself, remember to measure the battery compartment dimensions—length, width, and height—to avoid any fitting issues. A cold cranking amperage (CCA) of around 550A is sufficient, and this specification is widely available in the market, costing about 400-500 RMB. When replacing, remember to disconnect the negative terminal first, then the positive, and reverse the order when installing—it's quite simple.
For friends driving the Baojun 630 who need to replace the battery, the key parameter to look for is 12V 60Ah. Options like the Varta Blue Dynamic L2-400 or Fengfan 6-QW-60 are suitable, offering sufficient capacity at an affordable price. I once encountered an owner who installed a 70Ah battery, which caused the voltage controller to constantly report errors. Switching back to a 60Ah battery resolved the issue. When purchasing, remember to compare the label on the old battery, which indicates the CCA value—around 550A cold cranking amps is ideal for this car. If the car is over five years old, pay attention to any leakage or corrosion on the electrode terminals, as this can significantly impact battery lifespan.
The original battery for the Baojun 630 is usually 60Ah. My own older model uses a Camel brand battery. The key is to check the size of the battery compartment—as long as the dimensions match, it can be installed. Don't just focus on the brand; the production date is more important. It's best to choose a new battery manufactured within the last six months. When installing, tighten the screws securely but not too forcefully, as the plastic casing can crack easily. When I replaced mine, I specifically tested the cold cranking amps (CCA)—550A is sufficient for winter temperatures as low as minus ten degrees Celsius. If the battery has been in use for over three years and the car starts noticeably slower in the morning, it's time to check it.
