What is the battery model for the BYD F3 remote key?

1 Answers
MacAlex
07/29/25 9:46pm
The battery model for the BYD F3 remote key is 1632. The method to replace the battery in the BYD F3 key is as follows: 1. Pull out the mechanical key, which is the L-shaped key; 2. Pry open the key shell directly. There is a deep groove and a shallow groove at the top of the key. Use a flat-head screwdriver to pry along the shallow groove to open it; 3. Remove the old battery and install the new one; 4. Reassemble the key. The BYD F3 is an A+ class passenger car produced by BYD Auto. It is equipped with a 1.5L inline 4-cylinder naturally aspirated engine, paired with either a 5-speed manual or 6-speed dual-clutch transmission. It has a maximum power output of 80 kW, a maximum horsepower of 109 PS, and a maximum torque of 145 Nm.
Was this review help?
1
2
Share
More Forum Discussions

What are the symptoms of a bad crankshaft pulley?

Crankshaft pulley damage has a significant impact on the vehicle. The car's power performance will be very poor, and the engine may produce unusual sounds when idling or accelerating. Below is a detailed introduction to the crankshaft pulley: 1. The car pulley is mainly installed on the car engine crankshaft to drive the camshaft, water pump, generator, air conditioning compressor, power steering pump, and other components. 2. The function of the pulley: It drives the water pump, generator, and air conditioning compressor to work. The water pump ensures the normal water circulation of the engine for cooling purposes. The generator charges the battery to ensure the normal operation of various electrical circuits in the car. The air conditioning pump, also known as the compressor, is used in the air conditioning system. 3. Advantages of pulley drive: The pulley drive can mitigate load impacts; it operates smoothly with low noise and vibration. The structure of the pulley drive is simple and easy to adjust. The manufacturing and installation precision of the pulley drive is not as strict as that of meshing drives. The pulley drive has an overload protection function. The center distance between the two shafts in the pulley drive can be adjusted over a wide range.
3
5
Share

Do You Use Turn Signals When Driving on Curves?

Turn signals are not used when driving on curves. When starting the vehicle, use the left turn signal. For hill start and stop, begin using the right turn signal when starting from a designated point. After stopping at a designated point and starting again, use the left turn signal. For parallel parking, use the turn signal: only the right turn signal when reversing, and the left turn signal along with the horn when exiting the parking space. Use the left turn signal for right-angle turns. Below are details about turn signals: Function of Turn Signals: Turn signals are controlled by electronic devices but still simulate the sound of a relay with audio cues. They are activated when a motor vehicle turns to alert the driver that the turn signal is flashing and to notify vehicles in front, behind, and to the sides, as well as pedestrians, serving as an important indicator. Types of Turn Signals: They can mainly be divided into three types: resistance wire type, capacitor type, and electronic type. The resistance wire type can be further divided into thermal wire type (electric heating type) and vane type (spring type), while the electronic type can be divided into hybrid type (with contact-type relays and electronic components) and fully electronic type (without relays).
20
3
Share

How Long Does It Take for a Beginner to Get on the Road?

It takes 1-3 months for beginners to get on the road. Generally, the sticker display period is one year, but in practice, basic skills are usually mastered within 1-3 months. For beginners driving on the road, it's advisable to invite friends to accompany them. Even if the friends cannot drive, they can at least help observe the surrounding conditions. The following are some precautions for beginners on the road: Pay attention to speed: As long as it's not on the highway, beginners should stabilize their speed at around 60 km/h, which is beneficial for control. Observe the rearview mirrors more: The rearview mirrors can help observe the road conditions on the left and right rear of the vehicle, especially when changing lanes, reversing, or overtaking, where the role of the rearview mirrors is crucial. Maintain a safe distance: Beginners tend to follow too closely. If the car in front brakes or cuts in, beginners usually react by immediately hitting the brakes. Sometimes, excessive nervousness can also cause the steering wheel to turn too sharply, leading to traffic accidents. Therefore, maintaining a safe distance from the car in front is key. When a car cuts in, it's appropriate to slow down and yield.
12
2
Share

What causes a car to start and then stall quickly without being able to accelerate?

Here are the reasons why a car starts and then stalls quickly: 1. Throttle issues. For example, a clogged throttle; carbon buildup in the throttle, etc. 2. Problems with the ignition coil or spark plugs. For example, spark plugs reaching the end of their lifespan; excessive spark plug gap, etc. 3. Issues with the fuel injector, such as a clogged injector; problems in any part of the fuel system, ignition system, or intake system can lead to this phenomenon. 4. Engine carbon buildup. Carbon deposits have a strong adsorption effect on gasoline. If there is significant carbon buildup on the intake valve, throttle, or pistons, it can absorb some fuel, causing the air-fuel mixture to become too lean and affecting startup. This situation can also occur during cold starts. 5. Fuel quality. After the engine stalls when hot and sits for a while, the engine compartment temperature remains high. If the fuel is highly volatile, it can form high vapor pressure in the fuel rail. When this pressure exceeds the fuel system's supply pressure, it creates vapor lock, causing the fuel injector to spray overly lean fuel vapor, making it difficult to start.
12
5
Share

Why Has the Estimated Driving Range Suddenly Decreased?

The driving range is calculated based on the fuel consumption during previous periods. During a cold start in the morning, fuel consumption is very high, and the computer estimates the driving range based on this, resulting in a reduced value. The following factors influence the driving range: Comprehensive Factors: To improve a car's driving range, the key lies in fuel technology, which involves continuously enhancing engine performance. However, factors such as vehicle size and price must also be considered. Other Factors: The overall driving range is still affected by multiple other factors, such as battery performance in high and low temperatures and optimization of battery BMS technology.
10
1
Share

Where Can I Find Low-Cost Disposal of Stock Vehicles?

Used car markets and secondary dealers offer low-cost disposal of stock vehicles. Below is an introduction to low-cost disposal of stock vehicles: 1. Secondary Dealers: Typically, if automakers face inventory overstock and determine that the situation cannot be reversed, many manufacturers choose to sell the stock vehicles to secondary dealers. However, one unavoidable issue with such vehicles is prolonged storage, leading to rusted components, which may cause problems later. 2. Used Car Markets: Most stock vehicles are dismantled and sold as parts, but if the market has low demand and surplus parts production, dismantling and retailing lose their value. In such cases, these stock vehicles end up in the used car market.
13
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.