What is the average fuel consumption of the Mazda 6 Atenza 2.0?

1 Answers
DelPaislee
07/29/25 8:13pm
The average fuel consumption of the Mazda 6 Atenza 2.0 is 7.11L/100km. Here are specific methods to reduce fuel consumption: Plan your route in advance: Before driving, plan your route and check traffic conditions to avoid roads prone to congestion. Additionally, proper planning and familiarity with the route can prevent getting lost, as driving extra distance due to being lost will definitely increase fuel consumption. Maintain a steady speed: Try to drive at a constant speed. Unstable driving speeds can increase fuel consumption by 6% in suburban areas and 2% in urban areas. Reduce wind resistance: Keep the windows closed while driving to minimize wind resistance. The drag caused by open windows consumes more fuel than using the air conditioning.
Was this review help?
20
0
Share
More Forum Discussions

Do modern cars still need undercoating?

It depends on the specific situation. Here are the reasons: 1. Many new cars already come with factory-applied underbody protection, making additional undercoating unnecessary. However, if the purchased new vehicle lacks such protection, applying undercoating becomes highly advisable. 2. Undercoating doesn't involve installing a physical protective device on the car's chassis. Instead, it refers to spraying a 2-4mm thick layer of elastic sealing material underneath the vehicle. 3. The primary purposes of undercoating are to prevent rust formation on the chassis and reduce the impact of road debris during driving. Additionally, it provides thermal insulation and noise reduction benefits.
1
5
Share

Where is the button to open the fuel tank cap?

Opening the fuel tank switch is located on the left front door panel or the center console, usually marked with a fuel pump icon. Make sure to turn off the engine before refueling. Introduction to fuel tank opening methods: 1. Mechanical key opening: This method is relatively complex, so it is rarely used in household cars nowadays. It is mostly found in rugged SUVs. 2. In-car switch: This method is more convenient compared to using a mechanical key. It has been widely used in fuel vehicles for a long time. 3. Direct pressing: This is the most convenient among the three fuel tank cap opening methods, requiring no operation from the car owner, allowing the fuel attendant to refuel directly.
13
4
Share

How to Drive the X-Trail's Tiptronic Manual Mode?

Start the car. While driving, if the driver needs to switch to manual mode, simply push the gear lever to the left from the D position to enter manual mode. After switching to manual mode, if the owner needs to shift gears for speed changes, they can do so by moving the gear lever up or down, and can also push it to the right at any time. When climbing in manual mode, try to choose 1st or 2nd gear to maintain the engine speed above 3000 rpm in a climbing state, which can effectively prevent the automatic transmission from shifting frequently.
17
3
Share

What to Do When Changing License Plates with ETC?

Bring the vehicle registration certificate with the new license plate, driver's license, the bank card bound to the ETC, and the ETC pass card to the corresponding bank or ETC management department to apply for registration modification. Benefits of ETC: 1. Save time by eliminating the hassle of waiting in line. 2. Green and low-carbon, vehicles pass through toll stations without stopping, reducing noise and exhaust emissions, and minimizing pollution. 3. Cost savings, as vehicles reduce the frequency of starting and braking, lowering wear and fuel consumption. 4. More technological innovations. As the fastest and most convenient high-speed toll payment method currently available, ETC has never stopped exploring innovations.
4
4
Share

Can the electronic throttle be adjusted?

Screwdriver, 10mm short-handle socket, 12mm short-handle socket. Loosen the 4 white screws and remove 1 black fixing screw. With the sensor connector facing upwards, move it 1.5-2mm to the left. Ensure the sensor cover does not move excessively up and down, then tighten the 4 white screws. Then secure the black positioning screw. After installation, first connect the sensor connector. Start the engine and ensure the idle speed remains unchanged from before the adjustment. Then tighten the 2 throttle pedal screws and 1 nut.
17
2
Share

Can Mazda vehicles automatically lock after turning off the engine and leaving?

Some Mazda models can automatically lock after turning off the engine and leaving, while others do not support this feature. Owners must use the remote key to lock the doors after exiting the vehicle. Some cars are equipped with a keyless entry function, which is very convenient to use. When the owner approaches the car with the key, pressing the button on the door handle can unlock the door. Mazda Motor Corporation was founded in 1920 by Jujiro Matsuda, originally named Toyo Cork Kogyo Co., Ltd. In 1931, Mazda officially began producing small trucks in Hiroshima, and in the 1960s, the company started manufacturing passenger cars.
17
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.