What is the appropriate tire pressure for Chery eq1?

1 Answers
Eva
07/29/25 10:12pm
The appropriate tire pressure for Chery eq1 is 2.4-2.5bar. When driving with insufficient tire pressure, the most noticeable effect is increased fuel consumption. Low tire pressure increases the contact area between the tire and the ground, resulting in greater friction and added driving resistance, which in turn leads to higher fuel consumption. Additionally, insufficient tire pressure accelerates tire wear and reduces the tire's service life. The relationship between tire pressure and vehicle handling stability: Cornering stiffness is an important parameter that determines a vehicle's handling stability. Tires should have high cornering stiffness to ensure good handling stability. Tire pressure is a significant factor affecting cornering stiffness—the higher the tire pressure, the greater the cornering stiffness. However, once the pressure exceeds a certain level, the stiffness no longer changes. Introduction to standard tire pressure: According to the international GBT2978-2008 standard, the recommended tire pressures are as follows: standard tires 2.4-2.5bar; reinforced tires 2.8-2.9bar; the maximum pressure should not exceed 3.5bar.
Was this review help?
1
4
Share
More Forum Discussions

What are the causes of spark plug damage?

The causes of spark plug damage are: 1. Long-term failure to clean carbon deposits; 2. Neglecting the cleanliness of the spark plug's exterior; 3. Over-tightening during spark plug installation; 4. Exceeding the recommended service life of the spark plug. Methods for spark plug maintenance include: 1. Using compressed air or a fine soft tube to blow away dust and impurities around the spark plug; 2. Ensuring the engine is cold before removing the spark plug, and never performing installation or removal while the engine is running; 3. Protecting the spark plug hole after removal to prevent debris or dust from entering the cylinder; 4. Using the correct tools for removal, ensuring the wrench fits properly and is operated straight and true to avoid damaging the insulating ceramic body.
4
1
Share

What are the consequences of using the wrong engine oil in a car?

The consequences of using the wrong engine oil in a car are: 1. It can cause chemical reactions, reducing lubrication effectiveness; 2. It can produce acid-base compounds that accelerate corrosion of engine components; 3. It can degrade the sealing performance of piston rods or piston rings, leading to discoloration or damage; 4. The engine is more prone to malfunctions, accelerating sludge buildup in the oil; 5. Abnormal smoke from the exhaust pipe and severe wear of pistons and cylinder liners. Engine oil, also known as motor lubricant, consists of base oil and additives. It serves to lubricate and reduce friction, assist in cooling, seal against leaks, prevent rust and corrosion, and provide cushioning and shock absorption for the engine.
8
1
Share

What causes unstable idle speed in the BMW X6?

The reasons for unstable idle speed in the BMW X6 are: 1. Improper air-fuel mixture ratio in the engine compartment; 2. Extended use of spark plugs leads to aging of the ignition coil, high-voltage wire aging, and leakage issues, which reduce ignition capability; 3. Carbon deposits on the engine's valves and intake passages, resulting in decreased vehicle power; 4. Malfunctioning coolant temperature sensor. The BMW X6 is a coupe-style SUV produced by German automaker BMW, with body dimensions of 4880mm in length, 1983mm in width, 1709mm in height, a wheelbase of 2933mm, a luggage compartment volume of 470 liters, and equipped with a V8 twin-scroll twin-turbocharged engine.
9
4
Share

Why Do Cars Need Oil Changes?

Cars need oil changes for the following reasons: 1. To improve and enhance lubrication for the friction components in the engine; 2. To extend the engine's service life; 3. To improve the engine's lubrication conditions and reduce friction in moving parts. Precautions for oil changes include: 1. Perform the change when the engine is warm to ensure thorough drainage of old oil; 2. Add oil and ensure the correct amount is used; 3. After adding oil, start the engine and check for any leaks. The steps for an oil change are: 1. Lift the car, remove the underbody cover, and place a container of about 10 liters under the drain plug; 2. Unscrew the drain plug, use an air gun to blow into the oil filler for two minutes, then tighten the drain plug and wipe it with a tissue to check for leaks; 3. Reinstall the underbody cover, lower the car, and use a funnel to add oil through the filler port.
19
1
Share

What is the fuel consumption of the Haval Big Dog 2.0t?

Haval Big Dog 2.0t fuel consumption is 9.7 to 10L/100km. The following factors affect the fuel consumption of Haval Big Dog 2.0: Driving habits: Sudden braking, low gear high speed, frequent braking, and aggressive acceleration at start-up will all increase the vehicle's fuel consumption. Different tire types: Different types of tires have different performance characteristics. Semi-slick or full-slick racing tires focus more on the tire's grip performance. The size of the tire will also affect the actual fuel consumption. In the selection of tire types, it should be based on daily usage conditions. Using only economy-type tires may actually consume more fuel.
12
0
Share

How often should the transmission fluid be changed in the Envision?

Envision requires transmission fluid changes approximately every 80,000 kilometers. Transmission fluid plays a crucial role in cooling, lubrication, and power transmission within the transmission system. The Envision is a midsize SUV under SAIC-GM Buick. Taking the 2021 Envision 532T Front-Wheel Drive Leading model as an example, its body dimensions are: length 4,694 mm, width 1,839 mm, height 1,686 mm, with a wheelbase of 2,750 mm and a fuel tank capacity of 66 liters. The 2021 Envision 532T Front-Wheel Drive Leading model is equipped with a 1.5T turbocharged engine, delivering a maximum horsepower of 169 hp, a maximum power output of 124 kW, and a maximum power speed of 5,600 rpm.
7
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.